Development of a 2D spatial displacement estimation method for turbulence velocimetry of the gas puff imaging system on EAST

A gas puff imaging(GPI)diagnostic has been developed and operated on EAST since 2012,and the time-delay estimation(TDE)method is used to derive the propagation velocity of fluctuations from the two-dimensional GPI data.However,with the TDE method it is difficult to analyze the data with fast transient events,such as edge-localized mode(ELM).Consequently,a method called the spatial displacement estimation(SDE)algorithm is developed to estimate the turbulence velocity with high temporal resolution.Based on the SDE algorithm,we make some improvements,including an adaptive median filter and super-resolution technology.After the development of the algorithm,a straight-line movement and a curved-line movement are used to test the accuracy of the algorithm,and the calculated speed agrees well with preset speed.This SDE algorithm is applied to the EAST GPI data analysis,and the derived propagation velocity of turbulence is consistent with that from the TDE method,but with much higher temporal resolution.

Improved interfacial adhesion for stable flexible inverted perovskite solar cells

Flexible perovskite solar cells have attracted widespread attention due to their unique advantages in lightweight,high flexibility,and easy deformation,which are suitable for portable electronics.However,the inverted(p-i-n)structured devices suffer from poor stability largely due to the low adhesion at the brittle interface(the hole transport layer/perovskite).Herein,zeolitic imidazolate framework-67(ZIF-67)is applied to inverted structured cells to optimize the interface and prolong the device lifetime.As a result,the flexible devices based on ZIF-67 obtain the champion power conversion efficiency of 20.16%.Over 1000 h under continuous light irradiation,the device retains 96%and 80%of its original efficiency without and with bias,respectively.Notably,devices show mechanical endurance with over 78%efficiency retention after 10,000 cycles of consecutive bending cycles(R=6 mm).The introduction of ZIF-67 suppresses the cracking in device bending,which results in improved environmental stability and bending durability.

A new electromagnetic probe array diagnostic for analyzing electrostatic and magnetic fluctuations in EAST plasmas

A novel electromagnetic probe array(EMPA) diagnostic, which consists of a magnetic probe array and an electrostatic probe array, has recently been developed on EAST. The EMPA is fixed near the first wall at horizontal port P. The magnetic probe array of the EMPA consists of 24 identical magnetic probes, each of them capable of measuring toroidal, poloidal and radial magnetic fluctuations simultaneously, providing additional toroidal magnetic fluctuation measurements compared with the regular magnetic probes on EAST. With a higher sampling rate and self-resonant frequency, the EMPA magnetic probes can provide higher frequency magnetic fluctuation measurements. The magnetic probe array of the EMPA is composed of two parallel layers of magnetic probes with a radial distance of 63 mm, and each layer of magnetic probes is arranged in four poloidal rows and three toroidal columns. The compact arrangement of the EMPA magnetic probe array largely improves the toroidal mode number measurement ability from-8≤ n≤ 8 to-112≤ n≤ 112, and also improves the high poloidal wave number measurement ability of magnetic fluctuations compared with the regular high frequency magnetic probes on EAST. The electrostatic probe array of the EMPA consists of two sets of four-tip probes and a single-tip probe array with three poloidal rows and four toroidal columns. It complements the electrostatic parameter measurements behind the main limiter and near the first wall in EAST. The engineering details of the EMPA diagnostic, including the mechanical system, the electrical system, the acquisition and control system, and the effective area calibration, are presented. The preliminary applications of the EMPA in L-mode and H-mode discharges on EAST have demonstrated that the EMPA works well for providing information on the magnetic and electrostatic fluctuations and can contribute to deeper physical analysis in future EAST experiments.

Experimental study of ELM-induced filament structures using the VUV imaging system on EAST

A high-speed vacuum ultraviolet(VUV) imaging system has been developed on the Experimental Advanced Superconducting Tokamak(EAST), which selectively measures line emission with a central wavelength of 13.5 nm(CVI, n=4–2). It has been employed to study edge/pedestal plasma behavior in EAST. Edge localized mode(ELM)-induced filament structures have been captured by the VUV imaging system during the ELMy high confinement mode discharge with both high temporal and spatial resolutions. The typical features(i.e.poloidal width and pitch angle) of the observed filaments are quantitatively characterized based on the VUV imaging data, and the dependence of these features on basic plasma parameters is analyzed. It is found that the poloidal width is proportional to the heating power, and the pitch angle is inversely proportional to the edge safety factor q.95 The scatterplot shows a positive trend between the poloidal width and the ELM amplitude defined by the relative change in stored energy. These results are based on the condition that the perturbation induced by ELMs is confined to a narrow layer in the plasma.

Observation of filament-like structures in ELMy H-mode plasma with a VUV imaging system developed on the EAST tokamak

On the EAST tokamak,filament-like structures have been observed in ELMy H-mode discharges with a high-speed vacuum ultraviolet (VUV) imaging system.The topos,chronos and their weight can be obtained simultaneously by performing the so-called singular value decomposition (SVD) analysis of raw VUV imaging data.The fluctuation amplitude is observed to be suppressed and enhanced gradually in the edge localized mode (ELM) crash and pedestal recovery phase in the chronos,respectively,while filament-like structures can only be found in the pedestal recovery phase on the topos.The mode structure,i.e.m/n =36/9 (m and n are the poloidal and toroidal mode number,respectively) with ρ0 =0.95,w0 =0.07 (ρ0 and w0 denote the mode location and mode width,respectively) is derived by a comparison of the synthetic images and the experimental imaging data.

Observation of coherent mode induced by a molybdenum dust on EAST

The influence of a molybdenum dust buildup on plasma edge turbulence has been studied in the EAST tokamak.The motion of the dust from the upper divertor region is detected by a fast visible CCD camera,the XUV spectrometer arrays,and the EUV spectrometer.The MoXV emission intensity sharply increases compared with the spectral lines of various ionization states of other elements,which implies that the dust particles are the molybdenum impurities.The radial distribution of Mo^(14+)ion simulated by a simplified 1 D transport model indicates that the molybdenum dust mainly deposits in the pedestal bottom region.Moreover,it is observed that the coherent mode(CM)appears atρ=0.94 after the molybdenum impurities enter the main plasma region.The influx of molybdenum impurities results in increasing pedestal electron density and decreasing pedestal electron temperature in contrast to that before the event of impurities dropping.It is also found that the electron density gradient in the pedestal increases when the ablation of the molybdenum impurities is observed in the pedestal region.The qualitative experimental results indicate that the onset of CM is likely related to the increase of the density gradient and edge collisionality in the pedestal.In comparison to the density gradient,the enhancement of CM amplitude largely depends on the increase of the edge collisionality.

Physical design of a new set of high poloidal mode number coils in the EAST tokamak

An external resonant magnetic perturbation(RMP)field,which is an effective method to mitigate or suppress the edge localized mode(ELM),has been planned to be applied on the ELM control issue in ITER.A new set of magnetic perturbation coils,named as high m coils,has been developed for the EAST tokamak.The magnetic perturbation field of the high m coils is localized in the midplane of the low field side,with the spectral characteristic of high m and wide n,where m and n are the poloidal and toroidal mode numbers,respectively.The high m coils generate a strong localized perturbation field.Edge magnetic topology under the application of high m coils should have either a small or no stochastic region.With the combination of the high m coils and the current RMP coils in the EAST,flexible working scenarios of the magnetic perturbation field are available,which is beneficial for ELM control exploration on EAST.Numerical simulations have been carried out to characterize the high m coil system,including the magnetic spectrum and magnetic topology,which shows a great flexibility of magnetic perturbation variation as a tool to investigate the interaction between ELM and external magnetic perturbation.

Towards advanced divertor configurations on the J-TEXT tokamak

Developing advanced magnetic divertor configurations to address the coupling of heat and particle exhaust with impurity control is one of the major challenges currently constraining the further development of fusion research.It has therefore become the focus of extensive attention in recent years.In J-TEXT,several new divertor configurations,including the high-field-side single-null poloidal divertor and the island divertor,as well as their associated fundamental edge divertor plasma physics,have recently been investigated.The purpose of this paper is to briefly summarize the latest progress and achievements in this relevant research field on J-TEXT from the past few years.