Influence of cross correlation step length on the surface stress of thin laser cladding Fe314 alloy coatings

To measure the surface stress of thin laser cladding coatings with Rayleigh waves based on the cross correlation function, this pa- per introduced the influence of cross correlation step length on the stress measurement. Flat-shaped specimens made of laser cladding Fe314 alloy coatings were performed by static tensile tests, and Rayleigh wave signals were collected during the test process with an ultrasonic pulser and receiver instrument combined with two Rayleigh wave transducers. The difference in time of flight between two signals was de- termined based on the cross correlation function. The microstructure was observed by scanning electronic microscopy. The influence of the stress on the propagation velocity of Rayleigh waves and the relationship between the difference in time of flight and tensile stress under dif- ferent cross correlation step lengths were analyzed. The inhomogeneous deformation of the coatings affects the relationship between the dif- ference in time of flight and tensile stress; the stress measurement of the coatings is nearly constant with the increase of cross correlation step length when it attains one cycle.

Tailoring microstructure evolution and mechanical properties of a high-performance alloy steel through controlled thermal cycles of a direct laser depositing process

Direct laser deposition(DLD),as a popular metal additive manufacturing process,shows advantages of technical flexibility and high efficiency to gain a high-performance alloy steel component.However,during the processing of DLD,the deposited steel layer is affected by the subsequent layer depositing.The DLD block shows different microstructure and mechanical properties at the bottom,middle and top of the deposited parts.To date,there are few research works about the effects of inter-layer interval time and laser power on the microstructure evolution and mechanical properties of the deposited layers.In this study,the idle time and laser power layer by layer during DLD of 12CrNi2 steel were controlled to cause the deposited layers to maintain a high cooling rate,while the bottom deposited layer was subjected to a weak tempering effect.Results show that a high proportion of martensite is produced,which improves the strength of the deposited layer.Under the laser scanning strategy of laser power 2,500 W,scanning velocity 5 mm·s^(-1),powder feeding rate 11 g·min^(-1),overlap rate 50%,and a laser power difference of 50 W and a 2 min interval,the tensile strength of the deposited layer of 12CrNi2 steel is in the range of 873-1,022 MPa,and the elongation is in the range of 16.2%-18.9%.This study provides a method to reduce the tempering effect of the subsequent deposition layers on the bottom layers,which can increase the proportion of martensite in the low-alloy high-strength steel,so as to improve the yield strength of the alloy steel.