Decoupling Adaptive Sliding Mode Observer Design for Wind Turbines Subject to Simultaneous Faults in Sensors and Actuators

This paper proposes an adaptive sliding mode observer(ASMO)-based approach for wind turbines subject to simultaneous faults in sensors and actuators.The proposed approach enables the simultaneous detection of actuator and sensor faults without the need for any redundant hardware components.Additionally,wind speed variations are considered as unknown disturbances,thus eliminating the need for accurate measurement or estimation.The proposed ASMO enables the accurate estimation and reconstruction of the descriptor states and disturbances.The proposed design implements the principle of separation to enable the use of the nominal controller during faulty conditions.Fault tolerance is achieved by implementing a signal correction scheme to recover the nominal behavior.The performance of the proposed approach is validated using a 4.8 MW wind turbine benchmark model subject to various faults.Monte-Carlo analysis is also carried out to further evaluate the reliability and robustness of the proposed approach in the presence of measurement errors.Simplicity,ease of implementation and the decoupling property are among the positive features of the proposed approach.

Design and Performance Evaluation of Residual Generators for the FDI of an Aircraft

In this work, several procedures for the fault detection and isolation （FDI） on general aviation aircraft sensors are presented. In order to provide a comprehensive wide-pectrum treatment, both linear and nonlinear, model-based and data-driven methodologies are considered. The main contributions of the paper are related to the development of both FDI polynomial method （PM） and FDI scheme based on the nonLinear geometric approach （NLGA）. As to the PM, the obtained results highlight a good trade-off between solution complexity and resulting performances. Moreover, the proposed PM is especially useful when robust solutions are required for minimising the effects of modelling errors and noise, while maximising fault sensitivity. As to the NLGA, the proposed work is the first development and robust application of the NLGA to an aircraft model in flight conditions characterised by tight-oupled longitudinal and lateral dynamics. In order to verify the robustness of the residual generators related to the previous FDI techniques, the simulation results adopt a typical aircraft reference trajectory embedding several steady-tate flight conditions, such as straight flight phases and coordinated turns. Moreover, the simulations are performed in the presence of both measurement and modelling errors. Finally, extensive simulations are used for assessing the overall capabilities of the developed FDI schemes and a comparison with neural networks （NN） and unknown input Kalman filter （UIKF） diagnosis methods is performed.

Self-Tuning Control Techniques for Wind Turbine and Hydroelectric Plant Systems

The interest on the use of renewable energy resources is increasing, especially towards wind and hydro powers, which should be efficiently converted into electric energy via suitable technology tools. To this aim, self-tuning control techniques represent viable strategies that can be employed for this purpose, due to the features of these nonlinear dynamic processes working over a wide range of operating conditions, driven by stochastic inputs, excitations and disturbances. Some of the considered methods were already verified on wind turbine systems, and important advantages may thus derive from the appropriate implementation of the same control schemes for hydroelectric plants. This represents the key point of the work, which provides some guidelines on the design and the application of these control strategies to these energy conversion systems. In fact, it seems that investigations related with both wind and hydraulic energies present a reduced number of common aspects, thus leading to little exchange and share of possible common points. This consideration is particularly valid with reference to the more established wind area when compared to hydroelectric systems. In this way, this work recalls the models of wind turbine and hydroelectric system, and investigates the application of different control solutions. Another important point of this investigation regards the analysis of the exploited benchmark models, their control objectives, and the development of the control solutions. The working conditions of these energy conversion systems will also be taken into account in order to highlight the reliability and robustness characteristics of the developed control strategies, especially interesting for remote and relatively inaccessible location of many installations.

Hybrid robust fault detection and isolation of satellite reaction wheel actuators

In this paper,a combined robust fault detection and isolation scheme is studied for satellite system subject to actuator faults,external disturbances,and parametric uncertainties.The proposed methodology incorporates a residual generation module,including a bank of filters,into an intelligent residual evaluation module.First,residual filters are designed based on an improved nonlinear differential algebraic approach so that they are not affected by external disturbances.The residual evaluation module is developed based on the suggested series and parallel forms.Further,a new ensemble classification scheme defined as blended learning integrates heterogeneous classifiers to enhance the performance.A wide range of simulations is carried out in a high-fidelity satellite simulator subject to the constant and time-varying actuator faults in the presence of disturbances,manoeuvres,uncertainties,and noises.The obtained results demonstrate the effectiveness of the proposed robust fault detection and isolation method compared to the traditional nonlinear differential algebraic approach.