期刊文献+
共找到3篇文章
< 1 >
每页显示 20 50 100
Effects of Spin Transition and Cation Substitution on the Optical Properties and Iron Partitioning in Carbonate Minerals
1
作者 HU Jun xu liangxu +1 位作者 LIU Jin YUE Donghui 《Acta Geologica Sinica(English Edition)》 SCIE CAS CSCD 2023年第1期350-357,共8页
The high-pressure behavior of deep carbonate dictates the state and dynamics of oxidized carbon in the Earth's mantle,playing a vital role in the global carbon cycle and potentially influencing long-term climate c... The high-pressure behavior of deep carbonate dictates the state and dynamics of oxidized carbon in the Earth's mantle,playing a vital role in the global carbon cycle and potentially influencing long-term climate change.Optical absorption and Raman spectroscopic measurements were carried out on two natural carbonate samples in diamond-anvil cells up to 60 GPa.Mg-substitution in high-spin siderite FeCO_(3)increases the crystal field absorption band position by approximately 1000 cm^(-1),but such an effect is marginal at>40 GPa when entering the low-spin state.The crystal field absorption band of dolomite cannot be recognized upon compression to 45.8 GPa at room temperature but,in contrast,the high-pressure polymorph of dolomite exhibits a strong absorption band at frequencies higher than(Mg,Fe)CO_(3)in the lowspin state by 2000–2500 cm^(-1).Additionally,these carbonate minerals show more complicated features for the absorption edge,decreasing with pressure and undergoing a dramatic change through the spin crossover.The optical and vibrational properties of carbonate minerals are highly correlated with iron content and spin transition,indicating that iron is preferentially partitioned into low-spin carbonates.These results shed new light on how carbonate minerals evolve in the mantle,which is crucial to decode the deep carbon cycle. 展开更多
关键词 carbonate petrology/mineralogy MANTLE high pressure diamond-anvil cell iron spin transition iron partitioning deep carbon cycle
下载PDF
Q235钢表面TIG+激光重熔制备锆基涂层研究 被引量:2
2
作者 高文杰 徐良旭 《焊接技术》 2022年第9期17-21,共5页
为了提高Q235钢的表面耐磨性和耐蚀能力,文中用TIG熔覆+激光重熔方法在Q235钢表面制备了几种不同成分的锆基合金涂层。TIG熔覆有利于涂层与基材良好结合、减少裂纹和气孔,并有利于涂层成分的均匀化,激光重熔还可以提供极快的冷却速度并... 为了提高Q235钢的表面耐磨性和耐蚀能力,文中用TIG熔覆+激光重熔方法在Q235钢表面制备了几种不同成分的锆基合金涂层。TIG熔覆有利于涂层与基材良好结合、减少裂纹和气孔,并有利于涂层成分的均匀化,激光重熔还可以提供极快的冷却速度并利于表面细晶的形成。结果表明:采用TIG熔覆与激光重熔工艺成功地制备出了Zr基合金涂层,整个涂层成分均匀,组织致密,孔隙率低,涂层组织晶粒细小,表面具有高硬度和高耐磨性,显微硬度最高达到了HV700.2,锆基涂层较基体腐蚀电位更偏正向,并且自腐蚀电流密度更低,提高了涂层表面的耐蚀性,能够满足实际使用要求。 展开更多
关键词 TIG熔覆 激光重熔 锆基合金
下载PDF
高压下单晶橄榄石的电导率
3
作者 田浩然 徐良旭 +3 位作者 李娜娜 张茜 林俊孚 刘锦 《高压物理学报》 EI CAS CSCD 北大核心 2019年第6期20-28,共9页
以圣卡洛斯(San Carlos)单晶橄榄石为研究对象,结合交流阻抗谱和金刚石对顶砧(DAC)技术,在300 K、0~19 GPa条件下对其电导率的各向异性进行系统研究。压力标定根据红宝石荧光谱线的漂移以及硅油的拉曼光谱。实验结果表明:在300 K、0~19 ... 以圣卡洛斯(San Carlos)单晶橄榄石为研究对象,结合交流阻抗谱和金刚石对顶砧(DAC)技术,在300 K、0~19 GPa条件下对其电导率的各向异性进行系统研究。压力标定根据红宝石荧光谱线的漂移以及硅油的拉曼光谱。实验结果表明:在300 K、0~19 GPa条件下,橄榄石[100]方向上的电导率最大,从3.8×10^–8 S/m增加到9.0×10^–8 S/m,[010]与[001]方向上的电导率接近,约为[100]方向电导率的1/2~1/3;橄榄石电导率随着压力线性增加,其中[100]方向的电导率随着压力变化的斜率最大。在室温条件下,橄榄石主要的导电机制是小极化子导电,且具有负的活化体积。研究结果表明,在含水量较低的上地幔区域,随着深度增加,压力效应可能导致电导率横向和纵向的不均一性增强。 展开更多
关键词 橄榄石 复阻抗谱 金刚石压腔 电导率 各向异性
下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部