上海软X射线自由电子激光装置(Shanghai Soft X-ray Free Electron Laser,SXFEL)需1个分辨率达到亚μm量级的束流位置测量系统,并采用基于束流准直的方法实现波荡器段电子束与光子束的紧密重合。为此设计研制了1个由C波段腔式探头、单...上海软X射线自由电子激光装置(Shanghai Soft X-ray Free Electron Laser,SXFEL)需1个分辨率达到亚μm量级的束流位置测量系统,并采用基于束流准直的方法实现波荡器段电子束与光子束的紧密重合。为此设计研制了1个由C波段腔式探头、单路混频至低中频的射频前端以及自主研发的专用数字信号束流位置处理器(digital beam position monitor processor,DBPM)构成的腔式束流位置测量(cavity beam position monitor,CBPM)系统。本文对系统的设计、软硬件结构、系统搭建进行了介绍,并基于漂移段搭建的3个紧邻的CBPM阵列完成了在线系统性能评估。束流实验结果表明,在束团电荷量为500 pC、系统动态范围在±800μm的条件下,位置分辨率可达880 nm,这也是国内首次研制成功可在线运行的具有亚μm位置分辨率的CBPM系统。此外,采用CBPM的相位腔进行相对束团电荷量、束团到达时间的测量,其性能评估结果也均优于SXFEL设计要求。展开更多
In this paper,in order to achieve the output signal processing of cavity beam position monitor(CBPM),we develop a digital intermediate frequency receiver architecture based signal processing system,which consists of r...In this paper,in order to achieve the output signal processing of cavity beam position monitor(CBPM),we develop a digital intermediate frequency receiver architecture based signal processing system,which consists of radio frequency(RF) front end and high speed data acquisition board.The beam position resolution in the CBPM signal processing system is superior to 1μm.Two signal processing algorithms,fast Fourier transform(FFT) and digital down converter(DDC),are evaluated offline using MATLAB platform,and both can be used to achieve,the CW input signal,position resolutions of 0.31μm and 0.10μm at -16 dBm.The DDC algorithm for its good compatibility is downloaded into the FPGA to realize online measurement,reaching the position resolution of 0.49μm due to truncation error.The whole system works well and the performance meets design target.展开更多
In order to suppress multi-bunch couple instabilities caused by transverse impedance, a bunch-by-bunch transverse feedback system based on a FPGA digital processor is commissioned at SSRF storage ring. The RF front en...In order to suppress multi-bunch couple instabilities caused by transverse impedance, a bunch-by-bunch transverse feedback system based on a FPGA digital processor is commissioned at SSRF storage ring. The RF front end has two COD pre-rejected attenuators for increasing the system arrangement and signal noise ratio, and the 3*RF Local signal comes from the BPM's sum signal using a FIR filter for avoiding the effect of longitudinal oscillation. The digital processor receives the coupled horizontal and vertical oscillation signals in the base band and transforms the coupled signals to the horizontal and vertical feedback signals with two series double-zeroes FIR filters. A matlab GUI is applied for producing the FIR coefficients when the tune is shifted. The horizontal and vertical Kickers have a special design for increasing the shunt impedance. Then the multi-bunch instabilities are suppressed respectively and the minimum damping time is about 0.4 ms.展开更多
文摘上海软X射线自由电子激光装置(Shanghai Soft X-ray Free Electron Laser,SXFEL)需1个分辨率达到亚μm量级的束流位置测量系统,并采用基于束流准直的方法实现波荡器段电子束与光子束的紧密重合。为此设计研制了1个由C波段腔式探头、单路混频至低中频的射频前端以及自主研发的专用数字信号束流位置处理器(digital beam position monitor processor,DBPM)构成的腔式束流位置测量(cavity beam position monitor,CBPM)系统。本文对系统的设计、软硬件结构、系统搭建进行了介绍,并基于漂移段搭建的3个紧邻的CBPM阵列完成了在线系统性能评估。束流实验结果表明,在束团电荷量为500 pC、系统动态范围在±800μm的条件下,位置分辨率可达880 nm,这也是国内首次研制成功可在线运行的具有亚μm位置分辨率的CBPM系统。此外,采用CBPM的相位腔进行相对束团电荷量、束团到达时间的测量,其性能评估结果也均优于SXFEL设计要求。
基金Supported by National Natural Science Foundaion of China(No.11075198)
文摘In this paper,in order to achieve the output signal processing of cavity beam position monitor(CBPM),we develop a digital intermediate frequency receiver architecture based signal processing system,which consists of radio frequency(RF) front end and high speed data acquisition board.The beam position resolution in the CBPM signal processing system is superior to 1μm.Two signal processing algorithms,fast Fourier transform(FFT) and digital down converter(DDC),are evaluated offline using MATLAB platform,and both can be used to achieve,the CW input signal,position resolutions of 0.31μm and 0.10μm at -16 dBm.The DDC algorithm for its good compatibility is downloaded into the FPGA to realize online measurement,reaching the position resolution of 0.49μm due to truncation error.The whole system works well and the performance meets design target.
文摘In order to suppress multi-bunch couple instabilities caused by transverse impedance, a bunch-by-bunch transverse feedback system based on a FPGA digital processor is commissioned at SSRF storage ring. The RF front end has two COD pre-rejected attenuators for increasing the system arrangement and signal noise ratio, and the 3*RF Local signal comes from the BPM's sum signal using a FIR filter for avoiding the effect of longitudinal oscillation. The digital processor receives the coupled horizontal and vertical oscillation signals in the base band and transforms the coupled signals to the horizontal and vertical feedback signals with two series double-zeroes FIR filters. A matlab GUI is applied for producing the FIR coefficients when the tune is shifted. The horizontal and vertical Kickers have a special design for increasing the shunt impedance. Then the multi-bunch instabilities are suppressed respectively and the minimum damping time is about 0.4 ms.
