A novel control strategy for reproducing the floor motions of high-rise buildings by earthquake-simulating shake tables

To enable the experimental assessment of the seismic performance of full-scale nonstructural elements with multiple engineering parameters(EDPs),a three-layer testbed named Nonstructural Element Simulator on Shake Table(NEST)has been developed.The testbed consists of three consecutive floors of steel structure.The bottom two floors provide a space to accommodate a full-scale room.To fully explore the flexibility of NEST,we propose a novel control strategy to generate the required shake table input time histories for the testbed to track the target floor motions of the buildings of interest with high accuracy.The control strategy contains two parts:an inverse dynamic compensation via simulation of feedback control systems(IDCS)algorithm and an offline iteration procedure based on a refined nonlinear numerical model of the testbed.The key aspects of the control strategy were introduced in this paper.Experimental tests were conducted to simulate the seismic responses of a full-scale office room on the 21^(st)floor of a 42-story high-rise building.The test results show that the proposed control strategy can reproduce the target floor motions of the building of interest with less than 20%errors within the specified frequency range.

Rapid report of seismic damage to buildings in the 2022 M 6.8 Luding earthquake,China

The report summarizes the observed damage to a variety of buildings near the epicenter of the M6.8 Luding earthquake in Sichuan Province,China.They include base-isolated buildings,multi-story reinforced concrete(RC)frame buildings,and masonry buildings.The near-field region is known to be tectonically highly active,and the local intensity level is the highest,that is,0.4g peak ground acceleration(PGA)for the design basis earthquake,in the Chinese zonation of seismic ground motion parameters.The extent of damage ranged from the weak-story collapse that claimed lives to the extensive nonstructural damage that suspended occupancy.The report highlights the first observation of the destruction of rubber bearings and viscous dampers in the isolation layer of Chinese seismically isolated buildings.It also features the rare observation of the brittle shear failure of RC columns in moment-resisting frames in a region of such a high seismic design requirement.Possible reasons that may have attributed to the reported damage are suggested by providing facts observed in the field.However,careful forensic analyses are needed before any conclusive judgment can be made.

Bandgaps and vibration isolation of local resonance sandwich-like plate with simply supported overhanging beam

The concept of local resonance phononic crystals proposed in recent years provides a new chance for theoretical and technical breakthroughs in the structural vibration reduction.In this paper,a novel sandwich-like plate model with local resonator to acquire specific low-frequency bandgaps is proposed.The core layer of the present local resonator is composed by the simply supported overhanging beam,linear spring and mass block,and well connected with the upper and lower surface panels.The simply supported overhanging beam is free at right end,and an additional linear spring is added at the left end.The wave equation is established based on the Hamilton principle,and the bending wave bandgap is further obtained.The theoretical results are verified by the COMSOL finite element software.The bandgaps and vibration characteristics of the local resonance sandwich-like plate are studied in detail.The factors which could have effects on the bandgap characteristics,such as the structural damping,mass of vibrator,position of vibrator,bending stiffness of the beam,and the boundary conditions of the sandwich-like plates,are analyzed.The result shows that the stopband is determined by the natural frequency of the resonator,the mass ratio of the resonator,and the surface panel.It shows that the width of bandgap is greatly affected by the damping ratio of the resonator.Finally,it can also be found that the boundary conditions can affect the isolation efficiency.