Mechanical properties of structural materials are particularly important for design, performance realization and reliability analysis of microelectromechanical systems （MEMS）. Furthermore, accurate database of mecha...Mechanical properties of structural materials are particularly important for design, performance realization and reliability analysis of microelectromechanical systems （MEMS）. Furthermore, accurate database of mechanical properties at the micro scale can provide indispensable reference for establishing MEMS standard. Electroplated nickel film is one of the most favored structural materials used in MEMS, thus its mechanical properties has been studied for many years. However, the measured values show large scatter in Yotmg＇s modulus of nickel film. Young＇s modulus and yield stress of electroplated nickel film are measured by using a micro-tensile testing instrument. The tensile load applied on the specimen is measured by a load cell with accuracy 0.25 mN directly, without additional friction. Through measuring the axial stiffness coefficient of the tensile instnunent in situ, the tensile strain of the specimen is obtained by using two-serial spring model. The electroplated nickel films were fabricated from sulfarnate baths, and the gauge section is 500μm long and 10μm wide nominally, and thickness range between 25 μm and 50μm. The obtained Young＇s modulus from tensile testing is 83＋6 GPa for nickel specimens electroplated at current density of 20 mA/cm2 and it increases to 124＋5 GPa as current density is decreased to 10 mA/cm2. The phenomena are interpreted in terms of porosity of microstructure. The higher current density produced rnicrostucture with low density and high volume fraction of pores, and the microstructure of high porosity corresponds to a lower modulus. The measured values of Young＇s modulus are consistent with those of calculated from the exponential empirical formula between Young＇s modulus and porosity. The micro-tensile testing instrument can also be used for mechanical measurement of other MEMS films.展开更多
基金supported by National Natural Science Foundation of China (Grant No. 50535030)National Basic Research Program of China (973 Program, Grant No. 2006CB300407)
文摘Mechanical properties of structural materials are particularly important for design, performance realization and reliability analysis of microelectromechanical systems （MEMS）. Furthermore, accurate database of mechanical properties at the micro scale can provide indispensable reference for establishing MEMS standard. Electroplated nickel film is one of the most favored structural materials used in MEMS, thus its mechanical properties has been studied for many years. However, the measured values show large scatter in Yotmg＇s modulus of nickel film. Young＇s modulus and yield stress of electroplated nickel film are measured by using a micro-tensile testing instrument. The tensile load applied on the specimen is measured by a load cell with accuracy 0.25 mN directly, without additional friction. Through measuring the axial stiffness coefficient of the tensile instnunent in situ, the tensile strain of the specimen is obtained by using two-serial spring model. The electroplated nickel films were fabricated from sulfarnate baths, and the gauge section is 500μm long and 10μm wide nominally, and thickness range between 25 μm and 50μm. The obtained Young＇s modulus from tensile testing is 83＋6 GPa for nickel specimens electroplated at current density of 20 mA/cm2 and it increases to 124＋5 GPa as current density is decreased to 10 mA/cm2. The phenomena are interpreted in terms of porosity of microstructure. The higher current density produced rnicrostucture with low density and high volume fraction of pores, and the microstructure of high porosity corresponds to a lower modulus. The measured values of Young＇s modulus are consistent with those of calculated from the exponential empirical formula between Young＇s modulus and porosity. The micro-tensile testing instrument can also be used for mechanical measurement of other MEMS films.
