Microstructures and interfacial interactions of Al_(2)O_(3)whiskers and graphene nano-platelets co-reinforced copper matrix composites

The mechanical properties and microstructures of Al_(2)O_(3)whiskers and graphene nano-platelets(GNPs)co-reinforced Cu-matrix composites were studied.Cu-matrix composites with a variation of GNPs amount were fabricated by mechanical alloying followed by vacuum hot-pressing sintering and hot isostatic pressing.The Cu-matrix composite with 0.5 wt.%GNPs(GNPs-0.5)suggests a good interfacial bonding of both Cu/C and Cu/Al_(2)O_(3)interfaces.Both the hardness and compressive strength of Cu-matrix composites show a consistent tendency that firstly increases to a critical value and then decreases with increasing GNPs amount.It is suggested that the most possible strengthening mechanisms of both GNPs and Al_(2)O_(3)whisker working in the Cu-matrix composites involve energy dissipating and load transfer,as well as grain refinements for GNPs.The synergetic effect of GNPs and Al_(2)O_(3)whiskers is highlighted that the embedded GNPs would hinder the crack path generated at the Al_(2)O_(3)/Cu interface and enhance the already outstanding strengthening effect that Al_(2)O_(3)whiskers provide.

Interfacial microstructure and mechanical properties of diffusion-bonded joints of titanium TC4 (Ti-6Al-4V) and Kovar (Fe-29Ni-17Co) alloys

Diffusion bonding is a near net shape forming process that can join dissimilar materials through atomic diffusion under a high pressure at a high temperature.Titanium alloy TC4（Ti-6 Al-4 V）and 4 J29 Kovar alloy（Fe-29 Ni-17 Co）were diffusely bonded by a vacuum hot-press sintering process in the temperature range of 700-850°C and bonding time of 120 min,under a pressure of 34.66 MPa.Interfacial microstructures and intermetallic compounds of the diffusion-bonded joints were characterized by optical microscopy,scanning electron microscopy,X-ray diffraction（XRD）and energy dispersive spectroscopy（EDS）.The elemental diffusion across the interface was revealed by electron probe microanalysis.Mechanical properties of joints were investigated by micro Vickers hardness and tensile strength.Results of EDS and XRD indicated that（Fe,Co,Ni）-Ti,TiNi,Ti_2Ni,TiNi_2,Fe_2 Ti,Ti_（17） Mn_3 and Al_6 Ti_（19） were formed at the interface.When the bonding temperature was raised from 700 to 850°C,the voids of interface were reduced and intermetallic layers were widened.Maximum tensile strength of joints at 53.5 MPa was recorded by the sintering process at 850°C for 120 min.Fracture surface of the joint indicated brittle nature,and failure took place through interface of intermetallic compounds.Based on the mechanical properties and microstructure of the diffusion-bonded joints,diffusion mechanisms between Ti-6 Al-4 Vtitanium and Fe-29 Ni-17 Co Kovar alloys were analyzed in terms of elemental diffusion,nucleation and growth of grains,plastic deformation and formation of intermetallic compounds near the interface.