Structural Design of a Bionic Anti-Clogging Drip Irrigation Emitter Based on Shark Dorsal Fin

Due to the poor anti-clogging performance of the common drip irrigation emitters, this paper designed a new bionic flow channel in the emitter based on the shape of shark dorsal fin. After preliminary structural design, the computational fluid dynamics (CFD) simulation showed that the bionic emitter exhibited superior anti-clogging performance and reasonable hydraulic performance. The passage rate of particles of the bionic emitter in simulation reached 96.3% which was 37.6% higher than 70% of traditional emitter, and the discharge exponent reached 0.4995 which was close to traditional emitter. Physical experiments were consistent with the CFD results, which confirmed the correctness of simulation. After a short cycle anti-clogging performance experiment, the bionic emitter still maintained 96.09% of the initial flow rate.

Fitting of Water Requirement and Yield of Winter Wheat in North China Plain Based on Artificial Neural Network

The fitting of water requirement and yield during the growth period of winter wheat can improve yield effectively and improve irrigation water use efficiency with a certain amount of resource input. This paper selects the irrigation amount, precipitation and yield of winter wheat at the Wuqiao Scientific Observation and Experimental Station. Fitting the water requirement and yield of winter wheat based on three types of artificial neural networks. This paper uses support vector machine (SVM), thought evolution algorithm to optimize BP neural network (MAE-BP) and generalized regression neural network (GRNN) to fit the water requirement and yield of two crops. The SVM is the model with the highest fitting accuracy among the three models, the RMSE, MAE, NS and R2 between predictive value and true value are 7.45 kg/hectares, 213.64 kg/hectares, 0.8086, 0.9409 respectively.

The Additive Manufacturing Process of Electric Power Fittings Fabricated by Metal Droplet Deposition

Metal droplet deposition is a kind of additive manufacturing(3D Printing)technique that fabricates near-net part through droplets deposition with lower cost and higher efficiency.This paper proposed a solution to problems of electric power fittings that large inventories,high procurement costs,low manufacturing efficiency and transportation cost.Using additive Manufacturing technique-metal droplet deposition,electric power fittings fabricated on power construction site.This paper describes the manufacturing process of typical thin-walled samples(the structure optimized based on additive manufacturing principle)and ball head rings of electric power fittings.Aiming at the integral AM forming for ball and ball socket electric power fitting workpiece,a novel easy removal forming support material(ceramics and gypsum mixed with UV cured resin)have been developed.Here this support material was used to fabricate nested integral workpieces.Dimensional accuracy and microstructure of the test pieces were analyzed.The error of the height and width of the forming workpiece is within 5%.No obvious overlap trace(such as overlap line and cracks)observed,and the internal microstructure is equiaxial crystal.The average density of the component is 99.51%,which measured by drainage method and 13.39%higher than the cast raw material.