Engineer Nanoscale Defects into Selective Channels:MOF-Enhanced Li^(+) Separation by Porous Layered Double Hydroxide Membrane

Two-dimensional(2D)membrane-based ion separation technology has been increasingly explored to address the problem of lithium resource shortage,yet it remains a sound challenge to design 2D membranes of high selectivity and permeability for ion separation applications.Zeolitic imidazolate framework functionalized modified layered double hydroxide(ZIF-8@MLDH)composite membranes with high lithium-ion(Li^(+)) permeability and excellent operational stability were obtained in this work by in situ depositing functional ZIF-8 nanoparticles into the nanopores acting as framework defects in MLDH membranes.The defect-rich framework amplified the permeability of Li^(+),and the site-selective growth of ZIF-8 in the framework defects bettered its selectivity.Specifically speaking,the ZIF-8@MLDH membranes featured a high permeation rate of Li^(+) up to 1.73 mol m^(−2) h^(−1) and a desirable selectiv-ity of Li^(+)/Mg^(2+) up to 31.9.Simulations supported that the simultaneously enhanced selectivity and permeability of Li+are attributed to changes in the type of mass transfer channels and the difference in the dehydration capacity of hydrated metal cations when they pass through nanochannels of ZIF-8.This study will inspire the ongoing research of high-performance 2D membranes through the engineering of defects.

Size distribution and source of heavy metals in particulate matter on the lead and zinc smelting affected area

In order to understand the size distribution and the main kind of heavy metals in particulate matter on the lead and zinc smelting affected area, particulate matter （PM） and the source samples were collected in Zhuzhou, Hunan Province from December 2011 to January 2012 and the results were discussed and interpreted. Atmospheric particles were collected with different sizes by a cascade impactor. The concentrations of heavy metals in atmospheric particles of different sizes, collected from the air and from factories, were measured using an inductively coupled plasma mass spectrometry （ICP-MS）. The results indicated that the average concentration of PM, chromium （Cr）, arsenic （As）, cadmium （Cd） and lead （Pb） in PM was 177.3 ± 33.2 μg/m^3, 37.3 ± 8.8 ng/m^3, 17.3 ± 8.1 ng/m^3, 4.8 ± 3.1 ng/m^3 and 141.6 ± 49.1 ng/m^3, respectively. The size distribution of PM displayed a bimodal distribution; the maximum PM size distribution was at 1.1-2.1 μm, followed by 9-10 μm. The size distribution of As, cd and Pb in PM was similar to the distribution of the PM mass, with peaks observed at the range of 1.1-2.1 μm and 9-10 μm ranges while for Cr, only a single-mode at 4.7-5.8 μm was observed. PM （64.7%, As （72.5%）, cd （72.2%） and Pb （75.8%） were associated with the fine mode below 2.1 μm, respectively, while Cr （46.6%） was associated with the coarse mode. The size distribution characteristics, enrichment factor, correlation coefficient values, source information and the analysis of source samples showed that As, Cd and Pb in PM were the typical heavy metal in lead and zinc smelting affected areas, which originated mainly from lead and zinc smelting sources.

Characteristics of atmospheric particles and heavy metals in winter in Chang-Zhu-Tan city clusters, China

To understand the pollution characteristics of atmospheric particles and heavy metals in winter in Chang-Zhu-Tan city clusters, China, total suspended particulate （TSP） and PMI0 samples were collected in cities of Changsha, Zhuzhou and Xiangtan from December 2011 to January 2012, and heavy metals of Cd, Pb, Cr, and As were analyzed. It shows that the average TSP concentration in Changsha, Zhuzhou and Xiangtan were （183 ± 73）, （201± 84） and （190 ±66） μg/m3 respectively, and the average PM10 were （171 ± 82）, （178 ± 65） and （179 ± 55） μg/m3 respectively. The lowest TSP and PM10 concentrations occurred at the background Shaping site of Changsha. The average ratio of p（PM10）/p（TSP） was 91.9%, ranging from 81.3% to 98.9%. Concerning heavy metals, in TSP samples, the concentration of Cr, As, Cd and Pb were 28.8-56.5, 18.1-76.3, 3.9-26.1 and 148.0-460.9 ng/m3, respectively, while in PMI0 samples, were 16.4--42.1, 15.5-67.9, 3.3-22.2 and 127.9-389.3 ng/m3, respectively. The enrichment factor of Cd was the highest, followed by Pb and As, while that of Cr was the lowest.