Cost Minimization of Wireless Sensor Networks with Unlimited-lifetime Energy for Monitoring Oil Pipelines

Cyber-physical-system (CPS) has been widely used in both civil and military applications. Wireless sensor network (WSN) as the part and parcel of CPS faces energy problem because sensors are battery powered, which results in limited lifetime of the network. To address this energy problem, we take advantage of energy harvesting device (EHD) and study how to indefinitely prolong oil pipeline monitoring network lifetime by reasonable selecting EHD. Firstly, we propose a general strategy worst case-energy balance strategy (WC-EBS), which defines worst case energy consumption (WCEC) as the maximum energy sensor node could expend for oil pipeline monitoring WSN. When the energy collected by EHD is equal or greater than WCEC, network can have an unlimited lifetime. However, energy harvesting rate is proportional to the price of EHD, WC-EBS will cause high network cost. To reduce network cost, we present two optimization strategies, optimization workloadenergy balance strategy (OW-EBS ) and optimization first nodeenergy balance strategy (OF-EBS). The main idea of OW-EBS is to cut down WCEC by reducing critical node transmission workload; OF-EBS confirms critical node by optimizing each sensor node transmission range, then we get the optimal energy harvesting rate in OF-EBS. The experimental results demonstrate that OF-EBS can indefinitely extend network lifetime with lower cost than WC-EBS and OW-EBS, and energy harvesting rate P in each strategy satisfies POF-EBS ≤POW-EBS ≤PWC-EBS. © 2014 Chinese Association of Automation.

Electrochemical impedance spectroscopy study on the corrosion of the weld zone of 3Cr steel welded joints in CO_2 environments

The welded joints of 3Cr pipeline steel were fabricated with commercial welding wire using the gas tungsten arc welding （GTAW） technique. Potentiodynamic polarization curves, linear polarization resistance （LPR）, electrochemical impedance spectroscopy （EIS）, scan- ning electron microscopy （SEM）, and energy-dispersive spectrometry （EDS） were used to investigate the corrosion resistance and the growth of a corrosion film on the weld zone （WZ）. The changes in electrochemical characteristics of the film were obtained through fitting of the EIS data. The results showed that the average corrosion rate of the WZ in CO2 environments first increased, then fluctuated, and finally de- creased gradually. The formation of the film on the WZ was divided into three stages： dynamic adsorption, incomplete-coverage layer forma- tion, and integral layer formation.