Effects of Standing Time during Pretreatment on the Nitrite Concentration Detected by Spectrophotometric Method

Food safety problems caused by excessive nitrite addition have been frequently reported and the detection of nitrite in food is particularly important. The standing time during the pretreatment of primary sample has a great influence on the concentration of nitrite tested by spectrophotometric method. In this context, three kinds of food samples are prepared, including canned mustard, canned fish and home-made pickled water. A series of standing times are placed during the sample pretreatments and the corresponding nitrite contents in these samples are detected by spectrophotometric method based on N-ethylenediamine dihydrochloride. This study aims to find out a reasonable standing time during the pretreatment of food sample, providing influence factor for precise detection of nitrite.

Solid-phase extraction of trace Au(Ⅲ) with SDG and determination by the catalytic spectrophotometric method

The new catalytic kinetic spectrophotometric method for Au（III） determination was developed and validated. It was based on the catalytic effect of gold on the oxidation of sudan red III by ammonium peroxodisulfate （（NH4）2S2O8） with nitrilo triacetic acid as an activator in microemulsion and H2SO4 medium. Under optimum conditions, there was the linearity of the calibration curve in the concentration range from 0 to 20 μg/L Au（Ⅲ） at 520 nm. The relative standard deviation was 3.0% with a correlation coefficient of 0.9986. The detection limit achieved was 9.75 × 10^-5 μg/mL. A new method using a column packed with sulfhydryl dextrose gel （SDG） as a solid-phase extractant has been developed for the preconcentration and separation of Au（Ⅲ） ions. The method has been applied to the determination of trace gold with satisfactory results.

Rapid Estimation on the Sperm Concentration in Boar Semen by Spectrophotometric Method

[ Objective] To establish the standardized spectrophotometric method to determine boar sperm concentration. [ Method ] The relation- ships between absorbance （A）, transmittance （T） and sperm concentration （C） of different wavelengths （450, 550, 650 nm） were compared. [ Result] The maximum sperm concentration detected by absorbance presented an upward trend with the increase of the wavelengths, 202 mitliorVml （450 nm）, 224 million/ml （550 nm） and 235 mUlion/ml （650 nm）, respectively, but the stability of repeated measurement was decreased. With the increase of sperm dilution times, the stability of repeated measurement of transmittance was reduced, and when dilution times were more than 10 times （450 nm）, 6 times （550 nm） and 4 times （650 nm）, differences appeared between the observed values of repeated measurement. [ Con- clusion] Wavelength at 450 nm was found to be the most sensitive and reliable, and sperm concentration presented cubic functional regression rela- tionship or power functional regression relationship with absorbance or transmittance, respectively. The regression equation for the standard curve at 450 nm was C400 = 0.48A3 - 0.76A2 ＋ 0.67A - 0.066 （ R = 0.951 ） and C400 = 1.657T -0.108. 8 （ R = 0.940）.

紫外分光光度法测定萘普酮及其胶囊含量的探讨

本文报道了应用紫外分光光度法测定萘普酮及其胶囊的含量。当萘普酮浓度为15～35μg/ml时与吸收度呈良好的线性关系(r=0.9999)。萘普酮乙醇溶液的吸收系数(E_(1c1)^(1%)261nm)为224.0,CV为0.058%。该方法具有简单、快速、准确,回收率达100.2%,CV为0.19%。用此方法测定萘普酮胶囊的含量,同样可以得到满意的效果。

Catalytic Kinetic Spectrophotometric Method for Determination of Phosphate Ion

The kinetic method for the determination of phosphate microamounts was described. The developed method is based on catalytic effect of phosphate on sodium pyrogallol-5-sulphonate （PS） by dissolved oxygen. The reaction was followed spectrophotometrically by measuring the rate of change in the values of the absorbance of the oxidation product at 437 nm. The optimum reaction conditions are PS （0.44×10^-3 mol·L^-1） and HClO4 （3.6×10^-6 mol·L^-1） at 25 ℃. Following this procedure, phosphate can be determined with a linear calibration graph up to 0.23 μg·mL^-1. The interference effect of several species was also investigated and it was found that the most common cations and anions did not interfere with the determination. The developed procedure was successfully applied to the determination of phosphate in natural waters and soil.

THE STUDY ON DETERMINATION OF SELENIUM WITH POTASSIUM BUTYL XANTHATE

A simple and fast ultraviolet spectrophotometric method was used to determineselenium (Ⅳ) through the formation, separaion and quantitative determination of potassium butylxanthae -selenium complex. The complex absorbed light sharply at 375 nm. The optimum acidity ofthe complex formation was between pH 3.4 - 4.0. The absorption value was no change in 120 minutesafter the comlex was extracted by Carbon tetraChioride. The sensitivity of the colour reation was 0.2ng cm-2, The content of selenimp (Ⅳ) was within 0-30 μg and linear rclation was good,Y=0.07X＋0.025, relevent coefficient r＝0.9997. A great quantity of I, Cu, Co, the and SO4-2, PO4-3contained in .the Sample had no effect on the results ofdetenninion when seldsum was determined.When content of Fe was over l00gμg/ml and Zn was over 180μg/ml, there was diotance to the determination, but the disturbance was rem0ved by adding EDTA. When making use of the method todetermine containin seldsum additivef Cv =6.85, rate of recovery was 97.2%, wild jujubef;Cv=3.22,rate of recovery was 90. 1%, soil Samlef Cv=4.64, rate of recovery was 86.2%. The method for sensitivity measured was apprtoate to 2, 3-diamino naphthalene (DAN) fluorescence method.

Synthesis of Different Ligand Complex Mo (VI) with Stillbazo and Cetylpyridinium Chloride

The complex of molybdenum (VI) with stilbene-2,2’-disulfonic acid-4,4’’bis (azo-1’’)-3’’, 4’’ dioxybenzene (stillbazo) in the presence of a cationic surfactant cetylpyridinium chloride (CPCl) was studied spectrophotometrically. It was found that in the presence of CPCl, a mixed-ligand complex with a component ratio of 1:2:4 is formed. The effect of pH, time, temperature, the concentration of reagents, and CPCl in the formation of homogeneous ligand and mixed-ligand complexes were studied. The stability constants (lgβk = 86 × 108) and the molar absorption coefficient of the mixed-ligand complex (εк = 11,835) were determined. It was found that Beer’s law is observed at a concentration of 0.05 - 17.00 μg/ml. A method has been developed for the spectrophotometric determination of molybdenum (VI) in complex industrial facilities.

Evaluating the Efficiency of Cadmium Removal by Alginate Hydrogels from Water Using 5,7-Dibromo-8-hydroxyquinoline as a Complexing Reagent

Cadmium toxicity in wastewater is a rising concern due to industries like batteries,metallurgy,electroplating,plastic stabilizers,and pigments.The quantitative detection of Cd^(2+)and its remediation from wastewater samples are of major concern from an environmental point of view.In the present work,an effective spectrophotometric method has been reported using 5,7-dibromo-8-hydroxyquinoline(DBHQ)as a complexing agent for Cd^(2+).This method has advantages like using recyclable,less toxic solvents and easy sample preparation.The limit of detection,limit of quantification,and sensitivity of the proposed method were found to be 33.30,36.70 mg L^(−1),and 2×10^(−3),respectively.The DBHQ method was validated using atomic absorption spectroscopy,and the recovery percentage was more than 98%.These results indicate that DBHQ can be effectively used for monitoring Cd^(2+)in aqueous systems.The method developed was further employed for monitoring Cd^(2+)adsorption on calcium alginate(AL)hydrogels.Batch adsorption studies were done to optimize parameters of Cd^(2+)removal using AL hydrogels,and the data obtained were used for kinetic and thermodynamic studies.Kinetic studies indicated that the pseudo-first-order model showed better fitting,and thermodynamic studies showed Freundlich-like adsorption.The maximum adsorption capacity of Cd^(2+)on AL hydrogels was found to be 56.45 mg g^(−1).The validation studies of DBHQ were performed using statistical analysis methods like t-tests and one-way variance.