The coupled dynamic characteristics of the conical electromagnetic bearing are presented and their definitions are given. On the basis of the analyses of the characteristics, the dynamic model of five degrees of freed...The coupled dynamic characteristics of the conical electromagnetic bearing are presented and their definitions are given. On the basis of the analyses of the characteristics, the dynamic model of five degrees of freedom (five-DOF) rotor-conical electromagnetic bearing system is made, and the influence of the coupled characteristics on the system optimal controller is analyzed.展开更多
Substations have a large number of signal transmission cables beneath the ground.Both the insulation safety and signal reliability of the cables are affected severely by the electromagnetic field.Under high-amplitude ...Substations have a large number of signal transmission cables beneath the ground.Both the insulation safety and signal reliability of the cables are affected severely by the electromagnetic field.Under high-amplitude impulsive currents,the dispersion of currents can cause soil discharge and thus cause unexpected distortions in an electromagnetic field.This paper focuses on the distortions of the electric field.In general,soil discharge channels occur in the vicinity of the independent rod.Closer development of the channel might enhance the electric field distribution and the potential surrounding the outer insulation of the cables(i.e.the surface potential on the cable).Therefore,this paper establishes a platform for observing the soil discharge channel and measuring the surface potential.Direction characteristic of the channel is extracted from the captured image of soil discharge channels and the surface potential is obtained by the measured coupling capacitive current on the shield experimentally.This paper also presents an improved model considering a dynamic growing discharge channel for the transient analysis of the grounding electrode.Study results show the surface potential increases as the discharge channel approaches the cable.To quantify this enhancement effect,the ratio of the highest to the lowest value of surface potential in different directions is taken as the multiple of the surface potential increase.The calculated multiples of the surface potential increase are in the range of 1 to 1.64 times under different conditions by the improved model.Therefore,taking the soil discharge channel into account is helpful to accurately analyze the impulsive interference of buried cables.展开更多
This paper introduces a novel hybrid FEM-BEM method for calculating 3D eddy cur-rent field. In the eddy current region, the eddy current density J is solved by the finite element method (FEM) which is discretized by b...This paper introduces a novel hybrid FEM-BEM method for calculating 3D eddy cur-rent field. In the eddy current region, the eddy current density J is solved by the finite element method (FEM) which is discretized by brick finite element mesh, while in the eddy current free re-gion, the magnetic field intensity H is solved by the boundary element method (BEM) which is dis-cretized by rectangular boundary element mesh. Under the boundary conditions, an algebraic equation group is obtained that only includes J by eliminating H. This method has many advan-tages over traditional ones, such as fewer variables, more convenient coupling between the FEM and the BEM and wider application to multiply-connected regions. The calculated values of two models are in good agreement with experimental results. This shows the validity of our method.展开更多
文摘The coupled dynamic characteristics of the conical electromagnetic bearing are presented and their definitions are given. On the basis of the analyses of the characteristics, the dynamic model of five degrees of freedom (five-DOF) rotor-conical electromagnetic bearing system is made, and the influence of the coupled characteristics on the system optimal controller is analyzed.
基金supported by the National Natural Science Foundation of China(51777020)supported by the Science and Technology Project of State Grid Corporation of China(“Study on the Transient Characteristics of Grounding System and the Test and Evaluation Method of Current Dispersion Performance Under the Successive Impulse Current”,5500-202026088A-0-0-00)。
文摘Substations have a large number of signal transmission cables beneath the ground.Both the insulation safety and signal reliability of the cables are affected severely by the electromagnetic field.Under high-amplitude impulsive currents,the dispersion of currents can cause soil discharge and thus cause unexpected distortions in an electromagnetic field.This paper focuses on the distortions of the electric field.In general,soil discharge channels occur in the vicinity of the independent rod.Closer development of the channel might enhance the electric field distribution and the potential surrounding the outer insulation of the cables(i.e.the surface potential on the cable).Therefore,this paper establishes a platform for observing the soil discharge channel and measuring the surface potential.Direction characteristic of the channel is extracted from the captured image of soil discharge channels and the surface potential is obtained by the measured coupling capacitive current on the shield experimentally.This paper also presents an improved model considering a dynamic growing discharge channel for the transient analysis of the grounding electrode.Study results show the surface potential increases as the discharge channel approaches the cable.To quantify this enhancement effect,the ratio of the highest to the lowest value of surface potential in different directions is taken as the multiple of the surface potential increase.The calculated multiples of the surface potential increase are in the range of 1 to 1.64 times under different conditions by the improved model.Therefore,taking the soil discharge channel into account is helpful to accurately analyze the impulsive interference of buried cables.
文摘This paper introduces a novel hybrid FEM-BEM method for calculating 3D eddy cur-rent field. In the eddy current region, the eddy current density J is solved by the finite element method (FEM) which is discretized by brick finite element mesh, while in the eddy current free re-gion, the magnetic field intensity H is solved by the boundary element method (BEM) which is dis-cretized by rectangular boundary element mesh. Under the boundary conditions, an algebraic equation group is obtained that only includes J by eliminating H. This method has many advan-tages over traditional ones, such as fewer variables, more convenient coupling between the FEM and the BEM and wider application to multiply-connected regions. The calculated values of two models are in good agreement with experimental results. This shows the validity of our method.
