Analysis Scheme for Density Modulation Experiments to Study Particle Confinements

Density modulation experiments are powerful experimental schemes for the study of particle transport. The diffusion coefficients （D） and convection velocity （V）, which cannot be evaluated from the particle balance in the equilibrium state, can be obtained separately. Further, the estimated values of D and V are determined independent of the absolute value of the particle source rate, which is difficult to obtain experimentally. However, the sensitivities and interpretation of D and V from the modulation experiments need to be considered. This paper describes numerical techniques for solving the particle balance equation of the modulation components. Examples of the analysis are shown regarding the data of LHD experiments, and the results of the modulation experiments are discussed.

Density Modulation Experiments to Determine Particle Transport Coefficients on HT-7 Tokamak

The particle diffusion coefficient and the convection velocity were studied based on the density modulation using D2 gas puffing on the HT-7 tokamak. The density was measured by a five-channel FIR interferometer. The density modulation amplitude was 10% of the central chord averaged background density and the modulation frequency was 10 Hz in the experiments. The particle diffusion coefficient （D） and the convection velocity （V） were obtained for different background plasmas with the central chord averaged density 〈ne〉 = 1.5×10^19m^-3 and 3.0×10^19 m^-3 respectively. It was observed that the influence of density modulation on the main plasma parameters was very weak. This technology is expected to be useful for the analysis of LHW and IBW heated plasmas on HT-7 tokamak in the near future.

A Novel Pulse Density Modulation with Semi-bridgeless Active Rectifier in Inductive Power Transfer System for Rail Vehicle

In this paper,a novel pulse density modulation(PDM)with semi-bridgeless active rectifier(S-BAR)in inductive power transfer(IPT)system for rail vehicle is proposed.It is to reduce switching losses of the active rectifier in pickups.In the control method,the insulated-gate bipolar transistors(IGBTs)in the S-BAR are controlled by synchronous PDM signals,so that zero-voltage switching(ZVS)and zero-current switching(ZCS)can be achieved in the whole output power range.The output power is regulated by changing the pulse density(PD)of the S-BAR since the it is almost linear proportional with the PD in high quality factor of pickup side.The communication device between the primary side and pickup side is not necessary anymore.The detailed theoretical analyses of the PDM method are provided,and its advantages are shown in a 7.5kW IPT prototype for rail vehicle.The experimental results are presented to verify the analysis and demonstrate the performance.The overall efficiency of the system by PDM control is 74.2%which is improved by 4%compared with phase shift(PS)control at light load.

High rate and ultralong life flexible all-solid-state zinc ion battery based on electron density modulated NiCo_(2)O_(4) nanosheets

The development of zinc ion batteries (ZIBs) with large capacity,high rate,and durable cathode material is a crucial and urgent task.Ni Co_(2)O_(4)(NCO) has received ever-growing interest as a potential cathode material for ZIBs,owing to the high theoretical capacity,rich source,cost-effective,and versatile redox nature.However,due to the slow dynamics of the NCO electrodes,its practical application in highperformance systems is severely limited.Herein,we report an electron density modulated NCO nanosheets (N-NCO NSs) with high-kinetics Zn^(2+)-storage capability as an additive-free cathode for flexible all-solid-state (ASS) ZIBs.By virtue of the enhanced electronic conductivity,improved reaction kinetics,and increased active sites,the optimized N-NCO NSs electrode delivers a high capacity of 357.7 m Ah g^(-1)at 1.0 A g^(-1)and a superior rate capacity of 201.4 m Ah g^(-1)at 20 A g^(-1).More importantly,a flexible ASS ZIBs device is manufactured using a solid polymer electrolyte of a poly (vinylidene fluoride hexafluoropropylene)(PVDF-HFP) film.The flexible ASS ZIBs device shows superb durability with 80.2%capacity retention after 20,000 cycles and works well in the range of-20–70℃.Furthermore,the flexible ASS ZIBs achieves an impressive energy density as high as 578.1 W h kg^(-1)with a peak power density of 33.6 k W kg^(-1),substantially outperforming those latest ZIBs.This work could provide valuable insights for constructing high-kinetics and high-capability cathodes with long-term stability for flexible ASS ZIBs.

Magnetic field‐enhanced water splitting enabled by bifunctional molybdenum‐doped nickel sulfide on nickel foam

Herein,we report bifunctional molybdenum-doped nickel sulfide on nickel foam(Mo-NiS_(x)/NF)for magnetic field-enhanced overall water splitting under alkaline conditions.Proper doping of Mo can lead to optimization of the electronic structure of NiS_(x),which accelerates the dissociation of H2O and the adsorption of OH−in the hydrogen evolution reaction(HER)and the oxygen evolution reaction(OER)processes,respectively.In addition,the magnetically active Mo-NiS_(x)/NF can further enhance the HER and OER activity under an applied magnetic field due to the magnetoresistance effect and the ferromagnetic(FM)exchange-field penetration effect.As a result,Mo-NiS_(x)/NF requires low overpotentials of 307 mV at 50mA cm^(−2)(for OER)and 136 mV at 10mA cm^(−2)(for HER)under a magnetic field of 10000 G.Furthermore,the electrolytic cell constructed by the bifunctional Mo-NiS_(x)/NFs as both the cathode and the anode shows a low cell voltage of 1.594 V at 10 mA cm^(−2)with optimal stability over 60 h under the magnetic field.Simultaneous enhancement of the HER and OER processes by an external magnetic field through rational design of electrocatalysts might be promising for overall water splitting applications.

Unlocking high-performance organic cathodes:tailoring active group densities in covalent frameworks for aqueous zinc ion batteries

Aqueous zinc ion batteries(AZIBs)are a promising energy storage technology due to their cost-effectiveness and safety.Organic materials with sustainable and designable structures are of great interest as AZIBs cath-odes.However,small molecules in organic cathode materials face dissolution problems and suboptimal cycle life,whereas large molecules suffer from a low theoretical capacity due to their inert carbon skeletons.Here,we designed two covalent organic framework(COF)materials(benzoquinoxaline benzoquinone-based COF(BB-COF)and triquinoxalinylene benzoquinone-based COF(TB-COF))with the same structure and number of energy storage groups to investigate the correlation between the densities of active sites and electrochemi-cal performance.We conclude that the electrochemical behavior of organic conjugate-based energy storage materials lacks a linear correlation with active site quantity.Adjusting active site densities is crucial for mate-rial advancement.BB-COF and TB-COF with dual active sites(C=O and C=N)exhibit distinct characteristics.TB-COF,which has dense active groups,shows a high initial capacity(222 mAh g^(-1)).Conversely,BB-COF,which features a large conjugated ring diameter,presents superior rate performance and enduring cycle stability.It even maintains stable cycling for 2000 cycles at-40℃.In-situ electrochemical quartz crystal mic-robalance tests reveal the energy storage mechanism of BB-COF,in which H+storage is followed by Zn2+storage.

Nonstationary probability densities of system response of strongly nonlinear single-degree-of-freedom system subject to modulated white noise excitation

The nonstationary probability densities of system response of a single-degree- of-freedom system with lightly nonlinear damping and strongly nonlinear stiffness subject to modulated white noise excitation are studied. Using the stochastic averaging method based on the generalized harmonic functions, the averaged Fokl^er-Planck-Kolmogorov equation governing the nonstationary probability density of the amplitude is derived. The solution of the equation is approximated by the series expansion in terms of a set of properly selected basis functions with time-dependent coefficients. According to the Galerkin method, the time-dependent coefficients can be solved from a set of first-order linear differential equations. Then, the semi-analytical formulae of the nonstationary probability density of the amplitude response as well as the nonstationary probability density of the state response and the statistic moments of the amplitude response can be obtained. A van der Pol-Duffing oscillator subject to modulated white noise is given as an example to illustrate the proposed procedures. The effects of the system parameters, such as the linear damping coefficient and the nonlinear stiffness coefficient, on the system response are discussed.

A Component Selection Framework of Cohesion and Coupling Metrics

Component-based software engineering is concerned with the develop-ment of software that can satisfy the customer prerequisites through reuse or inde-pendent development.Coupling and cohesion measurements are primarily used to analyse the better software design quality,increase the reliability and reduced system software complexity.The complexity measurement of cohesion and coupling component to analyze the relationship between the component module.In this paper,proposed the component selection framework of Hexa-oval optimization algorithm for selecting the suitable components from the repository.It measures the interface density modules of coupling and cohesion in a modular software sys-tem.This cohesion measurement has been taken into two parameters for analyz-ing the result of complexity,with the help of low cohesion and high cohesion.In coupling measures between the component of inside parameters and outside parameters.Thefinal process of coupling and cohesion,the measured values were used for the average calculation of components parameter.This paper measures the complexity of direct and indirect interaction among the component as well as the proposed algorithm selecting the optimal component for the repository.The better result is observed for high cohesion and low coupling in compo-nent-based software engineering.

Performance and Stability of Supercapacitor Modules based on Porous Carbon Electrodes in Hybrid Powertrain

Hybrid power sources have attracted much attention in the electric vehicle area. Particularly, electric-electric hybrid powertrain system consisting of supercapacitor modules and lithium-ion batteries has been widely applied because of the high power density of supercapacitors. In this study, we design a hybrid powertrain system containing two porous carbon electrode-based supercapacitor modules in parallel and one lithium ion battery pack. With the construction of the testing station, the performance and stability of the used supercapacitor modules are investigated in correlation with the structure of the supercapacitor and the nature of the electrode materials applied. It has been shown that the responding time for voltage vibration from 20 V to 48.5 V during charging or discharging process decreases from about 490 s to 94 s with the increase in applied current from 20 A to 100 A. The capacitance of the capacitor modules is nearly independent on the applied current. With the designed setup, the energy efficiency can reach as high as 0.99. The results described here provide a guidance for material selection of supercapacitors and optimized controlling strategy for hybrid power system applied in electric vehicles.

1T′-MoTe_(2)-Based On-Chip Electrocatalytic Microdevice:A Platform to Unravel Oxidation-Dependent Electrocatalysis

Ultrathin transition metal dichalcogenides(TMDs)are of particular interest as low-cost alternatives to highly active electrocatalysts because of their high surface activation energy.However,their striking structural characteristics cause chemical instability and undergo oxidation easily.