Estimation of Thermal Imaging System Operating Range Based on Background Radiation

Traditional operating range prediction methods assume that the atmospheric radiances in a target path and a background path are equal. But they are different in a real-world environment. To solve this problem,the influence of atmospheric radiance on operating range prediction is analyzed in this paper. Range estimation model in thermal imaging based on background radiation（ REBR） is proposed. Infrared image radiometric calibration is used to calculate the background radiation of a system entrance pupil. The result shows that,compared with traditional operating range prediction methods,the REBR method is more suitable for the actual atmospheric transmission process and the physical process of infrared imaging.

Two-stage Optimization for Active Distribution Systems Based on Operating Ranges of Soft Open Points and Energy Storage System

Due to the lack of flexible interconnection devices,power imbalances between networks cannot be relieved effectively.Meanwhile,increasing the penetration of distributed generators exacerbates the temporal power imbalances caused by large peak-valley load differences.To improve the operational economy lowered by spatiotemporal power imbalances,this paper proposes a two-stage optimization strategy for active distribution networks(ADNs)interconnected by soft open points(SOPs).The SOPs and energy storage system(ESS)are adopted to transfer power spatially and temporally,respectively.In the day-ahead scheduling stage,massive stochastic scenarios against the uncertainty of wind turbine output are generated first.To improve computational efficiency in massive stochastic scenarios,an equivalent model between networks considering sensitivities of node power to node voltage and branch current is established.The introduction of sensitivities prevents violations of voltage and current.Then,the operating ranges(ORs)of the active power of SOPs and the state of charge(SOC)of ESS are obtained from models between networks and within the networks,respectively.In the intraday corrective control stage,based on day-ahead ORs,a receding-horizon model that minimizes the purchase cost of electricity and voltage deviations is established hour by hour.Case studies on two modified ADNs show that the proposed strategy achieves spatiotemporal power balance with lower cost compared with traditional strategies.

Exploration of acceptable operating range for a compression system in a double bypass engine

The variable cycle engine is distinguished by its highly adjustable compression system,whose aerodynamic characteristic is extremely complex.To explore the regulation range of a double bypass engine compression system,a multi-dimensional analysis method is developed,through which the coupling mechanism between the compressor component and the bypass is examined.The operation zones of the compressor components and the bypass system are proposed,and the operation range of the compression system is obtained by calculating the overlapping part of the operation zones.The results show that in the double bypass mode,there exists a minimum mode selector valve area and a minimum core driven fan stage stall margin that ensures a feasible bypass flow,the two parameters correspond to each other.Under the given fan and core driven fan stage conditions,the maximum value of the inner bypass ratio is restricted by the upper limit of the forward variable area bypass injector and the maximum Mach number in the total bypass,while the minimum value of the inner bypass ratio depends on the lower limit of the forward variable area bypass injector geometry and the system recirculation margin.The single bypass mode is a unique condition of the double bypass mode,as the operation zone of the compressor component degenerates from a two-dimensional surface to a straight line.There are multiple bypass states available in the single bypass mode,while the regulation range of the bypass ratio is jointly restricted by the operation range of the high pressure compressor and the aerodynamic boundary of the forward variable area bypass injector.

Operating range of magnetic stabilization flow regime for magnetized fluidized bed with Geldart-B magnetizable and nonmagnetizable particles

The magnetic stabilization flow regime could also be created forGeldart-Bnonmagnetizable particles pro-vided some magnetizable particles are introduced and the magnetic field is applied.This study aimed toexplore the size(d_(pM))and density(ρ_(pM))effects of magnetizable particles on its operating range.The upperlimit(Umb;)could not be determined from the △P_(b)-U_(g)↓curve but could from analyzing the variation of △P_(b)-fluctuation with increasing U_(g).Due to the variation of U_(mfH)(lower limit)with d_(pM) and ppw,both U_(mbH)-U_(mfH) and(U_(mbH)-U_(mfH))/U_(mfH) were used to quantify the operating range of magnetic stabilization.U_(mbH)-U_(mfH) varied hardly with ρ_(pM) but increased significantly with decreasing ρ_(pM).(U_(mbH)-U_(mfH))/U_(mfH)increased as d_(pM) or ρ_(pM) decreased.lt was more difficult for the nonmagnetizable particles to escape fromthe network formed by the smaller/lighter magnetizable particles.For the same magnitude of change,dp had a stronger effect than ρ_(pM) on(U_(mbH)-U_(mfH))/U_(mfH).Neither U_(mbH)-U_(mfH) nor(U_(mbH)-U_(mfH):)/Uma variedmonotonously with the minimum fluidization velocity of the magnetizable particles,indicating that nostraightforward criterion for matching the magnetizable particles to the given nonmagnetizable particlescould be established based on their minimum fluidization velocities to maximize the operating range ofmagnetic stabilization.

Nearly Perfect Absorbers Operating Associated with Fano Resonance in the Infrared Range

We fabricate a three-layer metamaterial of metal patterns/dielectric/metal films. The optical properties associated with Fano resonance of the metamaterials are investigated experimentally and theoretically. The results indicate that the introduction of Fano resonance due to symmetry breaking leads to a much wider absorption range. Furthermore, the amplitude and phase of reflection can be modulated effectively by adjusting various free parameters using the proposed structure.

Impact of Typical Steady-state Conditions and Transient Conditions on Flow Ripple and Its Test Accuracy for Axial Piston Pump

The current research about the flow ripple of axial piston pump mainly focuses on the effect of the structure of parts on the flow ripple. Therein, the structure of parts are usually designed and optimized at rated working conditions. However, the pump usually has to work in large-scale and time-variant working conditions. Therefore, the flow ripple characteristics of pump and analysis for its test accuracy with respect to variant steady-state conditions and transient conditions in a wide range of operating parameters are focused in this paper. First, a simulation model has been constructed, which takes the kinematics of oil film within friction pairs into account for higher accuracy. Afterwards, a test bed which adopts Secondary Source Method is built to verify the model. The simulation and tests results show that the angular position of the piston, corresponding to the position where the peak flow ripple is produced, varies with the different pressure. The pulsating amplitude and pulsation rate of flow ripple increase with the rise of pressure and the variation rate of pressure. For the pump working at a constant speed, the flow pulsation rate decreases dramatically with the increasing speed when the speed is less than 27.78% of the maximum speed, subsequently presents a small decrease tendency with the speed further increasing. With the rise of the variation rate of speed, the pulsating amplitude and pulsation rate of flow ripple increase. As the swash plate angle augments, the pulsating amplitude of flow ripple increases, nevertheless the flow pulsation rate decreases. In contrast with the effect of the variation of pressure, the test accuracy of flow ripple is more sensitive to the variation of speed. It makes the test accuracy above 96.20% available for the pulsating amplitude of pressure deviating within a range of ~6% from the mean pressure. However, with a variation of speed deviating within a range of ±2% from the mean speed, the attainable test accuracy of flow ripple is above 93.07%. The model constructed in this research proposes a method to determine the flow ripple characteristics of pump and its attainable test accuracy under the large-scale and time-variant working conditions. Meanwhile, a discussion about the variation of flow ripple and its obtainable test accuracy with the conditions of the pump working in wide operating ranges is given as well.

Influence of heating on the discharge characteristics of a hollow cathode

Hollow cathodes are widely used as electron sources and neutralizers in ion and Hall electric propulsion.Special applications such as commercial aerospace and gravitational wave detection require hollow cathodes with a very wide discharge current range.In this paper,a heater is used to compensate for the temperature drop of the emitter at low current.The self-sustained current can be extended from 0.6 to 0.1 A with a small discharge oscillation and ion energy when the flow rate is constant.This is also beneficial for long-life operation.However,when the discharge current is high(>1 A),heating can cause discharge oscillation,discharge voltage and ion energy to increase,f urther,combined with a rapid decline of pressure inside the cathode and an increase in the temperature in the cathode orifice plate,electron emission in die orifice and outside the orifice increases and the plasma density in the orifice decreases.This leads to a change in the cathode discharge mode.

Monolithic integration of electroabsorption modulators and tunnel injection distributed feedback lasers using quantum well intermixing

Electroabsorption modulators combining Franz-Keldysh effect and quantum confined Stark effect have been mono-lithically integrated with tunnel-injection quantum-well distributed feedback lasers using a quantum well intermixing method. Superior characteristics such as extinction ratio and temperature insensitivity have been demonstrated at wide temperature ranges.

Using Tip Gaps on Tandem Diffuser to Broaden the Operation Range of a Centrifugal Compressor

Gaps in compressors are generally unfavorable because they lead to energy loss.However,gaps on diffuser blades can broaden the operation range of a compressor.To broaden the operation range of a centrifugal compressor with a tandem diffuser,gaps with different sections and widths on the diffuser blades were examined to determine their influence on the compressor performance.The results show that the compressor’s surge margin increased from 33.28% to 49.2% for a 2.5%tip gap ratio,while its stability margin increased from 44% to 60.5%.However,pressure ratio and efficiency losses of 1.16% and 1.14%,respectively,were incurred.Gap widths less than 5%of the height of the diffuser blade are adequate for broadening the operation range,whereas gap ratios greater than 5%cause more energy loss without broadening the operation range further.Gaps can also reduce the Mach number in the diffuser blade channels and can be influenced by the impeller-tip gap.Moreover,diffuser gaps on the shroud side yield better performance than those on the hub side.An experiment was conducted to investigate the reliability of the calculation and conclusions in this study,and the results proved that the conclusions are valid for different types of centrifugal compressors.

Low Power Penalty Operation of a Wide Input Dynamic Range Cross-Phase Modulation Wavelength Converter

We successfully demonstrated low power penalty operation of a cross-phase modulated (XPM) wavelength converter using a semiconductor optical amplifier (SOA) power equalizer. We also clarified the SOA equalizing level for more adaptive wavelength conversion and achieved a power penalty of less than 1 dB over the wide input dynamic range of 15 dB.

Passive location using CDMA mobile communication system based on repeater equipment

To overcome the drawback of a short operation range and low-resolution of a passive location system using a civil communication signal, the new idea that utilizes code division multiple access （CDMA） signal and repeater is disposed off. First, the CDMA passive location model and observation function are given, and the error source and error range are analyzed. Subsequently, the CDMA passive location algorithm in a repeater environment is described and simulated. The simulation result shows that the algorithm can provide the location value with high accuracy.

Ferro-floating memory:Dual-mode ferroelectric floating memory and its application to in-memory computing

Various core memory devices have been proposed for utilization in future inmemory computing technology featuring high energy efficiency.Flash memory is considered as a viable choice owing to its high integration density,stability,and reliability,which has been verified by commercialized products.However,its high operating voltage and slow operation speed issues caused by the tunneling mechanism make its adoption in in-memory computing applications difficult.In this paper,we introduce a dual-mode memory device named“ferro-floating memory”,fabricated using van der Waals(vdW)materials(h-BN,MoS2,andα-In2Se3).The vdW material,α-In2Se3,acts as a polarization control layer for the ferroelectric memory operation and charge storage layer for the conventional flash memory operation.Compared to the tunnelingbased memory operation,the ferro-floating memory operates 1.9 and 3.3 times faster at 6.7 and 5.8 times lower operating voltages for programming and erasing operations,respectively.The dual-mode operation improves the linearity of conductance change by 5 times and the dynamic range by 48%through achieving conductance variation regions.Furthermore,we assess the effects of the variation in device operating voltage on neural networks and suggest a memory array operating scheme for maximizing the networks'performance through various training/inference simulations.