Research of Risk Identification and Prevention of Underground Pressure Pipelines Damage Caused by External Disturbance

External disturbance is an important cause of underground pressure pipeline damage,which leads to accidents,and it is crucial to study the risk of damage caused by external disturbance and come up with proper prevention and control measures.We reviewed literature on risk identification of underground pressure pipelines damage due to external disturbance was conducted,and a list of risk factors was formed.Based on the list of risk factors,fault tree analysis was carried out on underground pressure pipelines damage caused by external disturbances,and risk prevention and control measures were proposed through the calculation of minimum cut sets,minimum path sets,and structural importance,in hopes of providing reference for the normal operation of underground pressure pipelines.

Recent Research Advances in the Risk Assessment Method of an Underground Pressure Pipeline

This paper reviews the risk assessment method of an underground pressure pipeline, introduces the risk assessment method of expert grading, fuzzy integrative assessment, probabilistic risk assessment and extenics assessment in an underground pressure pipeline. Moreover, it puts forward the developing orientation of risk assessment.

Modeling of fluid dynamics interacting with ductile fraction propagation in high pressure pipeline

This paper presents a computational model for the fluid dynamics in a fractured ductile pipe under high pressure. The pressure profile in front of the crack tip, which is the driving source of crack propagation, is computed using a nonlinear wave equation. The solution is coupled with a one dimensional choked flow analysis behind the crack. The simulation utilizes a high order optimized prefactored compact-finite volume method in space, and low dispersion and dissipation Runge-Kutta in time. As the pipe fractures the rapid depressurization take place inside the pipe and the propagation of the crack-induced waves strongly influences the outflow dynamics. Consistent with the experimental observation, the model predicts the expansion wave inside the pipe, and the reflection and outflow of the wave. The model also helps characterize the propagation of the crack dynamics and fluid flows around the tip of the crack.

Failure Pressure Analysis of Corroded Moderate-to-High Strength Pipelines

Based on the elastic-plastic, large-deformation finite element method, burst capacity of steel pipeline with longitudinal corrosion defect subjected to internal pressure is studied. The appropriate stress-based criterion is used to predict the failure pressure of finite element model of corroded pipeline under internal pressure. By considering the pipe steel grades and geometries of corrosion defects, a series of finite element analyses is conducted. The effects of corrosion depth, length and width on burst capacity are also discussed. A specific failure pressure solution for the assessment of corrosion defects in moderate-to-high strength pipeline is proposed on the base of numerical results. The failure pressures predicted by the proposed method are in better agreement with the experimental results than the results by the other methods.

A NEW MODEL FOR CALCULATING PROPAGATION PRESSURE AND INITIATION PRESSURE OF PIPELINES WITH A LOCAL DENT

An analytical model of a ring with six yield hinges and two deformable arc segments is presented for. the prediction of the buckle propagation pressure and initiation pressure in offshore pipelines. The configuration of a fully collapsed ring is considered as a real dumbbell shape with a line touch between two 'bells', instead of the dumbbell shape with a point touch of two diametrically opposite points. Calculations are performed assuming that the dominant effect on the plastic energy dissipation has the circumferential bending mode. For the linear strain-hardening materials it is found that theoretical predictions based on the above model for both propagation pressure and initiation nressure are in good agreement with experimental results of Kyriakides et al.

Influence of soil liquefaction on the vertical mechanical behavior of submarine pipeline under the wave loading

In this paper, the influence of soil liquefaction on the vertical pressure of submarine pipeline was investigated under the wave loading through the wave flume test. The experiment was set with the same waves on the liquefied seabed and unliquefled seabed respectively, and the current pipeline vertical pressure was measured with the pressure transducers installed on the two opposite directions （i.e., straight up and straight down） at the same cross-section of the pipeline. The results showed that when the seabed was unliquefied, the two pressure curves varied periodically and overlapped completely, reaching the maximum and minimum at the same time respectively, and the resultant pressure fluctuated within a limited range. However, when the seabed was liquefied, the two pressure curves varied periodically, but they did not overlap completely. They did not reach the maximum （minimum） value at the same time either, and the resultant pressure fluctuated within a wider range. The experiment showed that the submarine stood higher resultant pressure in the vertical direction when the seabed was liquefied, which may cause the frequent sinking and fioatation of the pipeline, leading to its fatigue damage.

Technologies for Efficient Use of Irrigation Water and Energy in China

While the shortage of water and energy is a well-recognized worldwide natural resources issue, little attention has been given to irrigation energy efficiency. In this paper, we examine the potential energy savings that can be achieved by implementing improved irrigation technologies in China. The use of improved irrigation management measures such as a flow meter, irrigation scheduling, and/or regular maintenance and upgrades, typically reduces the amount of water pumped over the course of a growing season. The total energy saved by applying these improved measures could reach 20%, as compared with traditional irrigation methods. Two methods of irrigation water conveyance by traditional earth canal and low pressure pipeline irrigation （LPPI） were also evaluated. Our study indicated that LPPI could save 6.48x 109 kWh yr1 when applied to 11 Chinese provinces. Also, the COz emission was reduced by 6.72 metric tons per year. Among these 11 surveyed provinces, the energy saving potential for two provinces, Hebei and Shandong, could reach 1.45 x 109 kWh yr^-1. Using LPPI, potential energy saved and CO2 emissions reduced in the other 20 Chinese provinces were estimated at about 2.97×109 kWh yr-1 and 2.69 metric tons per year, respectively. The energy saving potential for Heilongjiang, a major agriculture province, could reach 1.77× 109 kWh yr-1, which is the largest in all provinces. If LPPI is applied to the entire country, average annual energy saving of more than 9 billion kWh and average annual CO2 emission reduction of more than 9.0 metric tons could be realized. Rice is one of the largest users of the world＇s fresh water resources. Compared with continuous flooding irrigation, intermittent irrigation （ITI） can improve yield and water-use efficiency in paddy fields. The total increments of net output energy and yield by ITI in paddy fields across China could reach 2.5× 1016 calories and l07 tons, respectively. So far only a small part of agricultural land in China has adopted water and energy saving technologies. Therefore, potential water and energy savings in China by adapting improved irrigation technology could be significant and should be carefully studied and applied.

Prospects for High-quality Development of Water Resources

The water resources of rivers and reservoirs with a five-meter drop are used to discuss the technical theory and the cost and practical value of equipment cases.The high-quality development technology of water resources explored in this paper provides a feasible plan for achieving the goal of innovation to zero.