Extraction of Gold by Di(2-ethylhexyl)Sulfoxide and N-Octyl Sulfoxide

A long chain aliphatic sulfoxide can be used as an extractant.It can extract almost all metallic ions which can be extracted by tributylphosphate (TBP).The extraction of gold was studied by Chekushin,V. S. and Mojski,M.using petroleum sulfoxide and n-dioctyl sulfoxide(DOSO) as an extractant respectively.

油酸2-乙基己酯的催化合成及性能

层析硅胶负载硫酸钛Ti(SO4)2经高温焙烧制得一种负载型固体酸TSG,采用XRD表征固体酸的组分;以TSG为催化剂,以油酸与2-乙基己醇为反应物,催化合成了油酸2-乙基己酯;通过FT-IR确认酯化产物的结构,并检测了酯化产物的主要理化性能。实验结果表明:固体酸TSG的组分为TiOSO4/Al0.5Si0.75O2.25;硅胶分散负载硫酸氧钛TiOSO4能提高TSG的酯化催化活性;优化条件下:酸醇物质的量比1∶1.2、催化剂5.3%(与油酸的质量比)、带水剂甲苯0.14mol(相对于0.1mol油酸)、反应时间80min,酯化率可达98.1%;酯化产物的黏度、碘值、皂化值(KOH)和酸值(KOH)分别为8.5mm2/s、58.5、141.2mg/g和0.4mg/g。

Investigation on removal pathways of Di 2-ethyl hexyl phthalate from synthetic municipal wastewater using a submerged membrane bioreactor

Highly hydrophobic Di 2-ethyl hexyl phthalate（DEHP） is one of the most prevalent plasticizers in wastewaters. Since its half-life in biological treatment is around 25 days, it can be used as an efficiency indicator of wastewater treatment plant for the removal of hydrophobic emerging contaminants. In this study, the performance of submerged membrane bioreactor was monitored to understand the effect of DEHP on the growth of aerobic microorganisms. The data showed that the chemical oxygen demand（COD）and ammonia concentration were detected below 10 and 1.0 mg/L, respectively for operating conditions of hydraulic retention time（HRT） = 4 and 6 hr, sludge retention time（SRT） = 140 day and sludge concentration between 11.5 and 15.8 g volatile solid（VS）/L. The removal efficiency of DEHP under these conditions was higher and ranged between 91% and 98%. Results also showed that the removal efficiency of DEHP in biological treatment depended on the concentration of sludge, as adsorption is the main mechanism of its removal. For the submerged membrane bioreactor, the pore size is the pivotal factor for DEHP removal, since it determines the amount of soluble microbial products coming out of the process. Highly assimilated microorganisms increase the biodegradation rate, as 74% of inlet DEHP was biodegraded; however, the concentration of DEHP inside sludge was beyond the discharge limit. Understanding the fate of DEHP in membrane bioreactor,which is one of the most promising and futuristic treatment process could provide replacement for conventional processes to satisfy the future stricter regulations on emerging contaminants.

Study on transport of Dy(Ⅲ) by dispersion supported liquid membrane

The transport of Dy（III） through a dispersion supported liquid membrane （DSLM） consisting of polyvinylidene fluoride membrane （PVDF） as the liquid membrane support and dispersion solution including HCI solution as the stripping solution and 2-ethyl hexyl phosphonic acid-mono-2-ethyl hexyl ester （PC-88A） dissolved in kerosene as the membrane solution, was studied. The effects of pH value, initial concentration of Dy（III） and different ionic strength in the feed phase, volume ratio of membrane solution and stripping solution, concentration of HCl solution, concentration of carrier, different stripping agents in the dispersion phase on transport of Dy（III） were also investigated, respectively. As a result, when the concentration of HCI solution was 4.0 mol/L, concentration of PC-88A was 0.10 mol/L, and volume ratio of membrane solution and stripping solution was 40：20 in the dispersion phase, and pH value was 5.0 in the feed phase, the transport effect of Dy（III） was the best. Ionic strength had no obvious effect on transport of Dy（III）. Under the optimum condition studied, when initial concentration of Dy（III） was 0.8×10^-4 mol/L, the transport rate of Dy（III） was up to 96.2% during the transport time of 95 rain. The kinetic equation was developed in terms of the law of mass diffusion and the theory of interface chemistry. The diffusion coefficient of Dy（III） in the membrane and the thickness of diffusion layer between feed phase and membrane phase were obtained and the values were 1.99×10^-7 m^2/s and 15.97 μm, respectively. The results were in good agreement with experimental results.

Study on the Process for Removal of Samarium from NdCl_3 Solution by Solvent Extraction with DEHPA

The process for removal of samarium from NdCl_3 solution containing a little samarium by solvent extrac-tion with unsaponated Di (2-ethyl hexyl) orthosphoric acid (DEHPA) at acidic range is reported. The in-dustrial experiments have been completed on a production line of 150 t Nd_2O_3 per annum in the Baotou ThirdRare Earth Factory. As a result of 9 step counter current extraction , Sm_2 O_3 content in Nd_2 O_3 drops down to0. 08 % from 0. 5% , the purity of neodymium oxide is over 99. 5% and the direct recovery of Nd_2O_3 is 92%～ 93% .

Study on supported combined liquid membrane containing HEH(EH)P and HNO_3 for trivalent gadolinium transfer

A novel kind of supported combined liquid membrane （SCLM） has been studied for the Gd（IIl） transfer. SCLM contained polyvinylidene fluoride membrane （PVDF） as the liquid membrane support and renewal solution including HNO3 solution as the stripping solution and 2-ethyl hexyl phosphonic acid-mono-2-ethyl hexyl ester （HEH（EH）P） as the carrier dissolved in kerosene. The mixed solution of carrier and kerosene was membrane solution. The optimum transport conditions of Gd（III） were that concentration of HNO3 solution was 4.00 tool/L, concentration of carrier was 0.16 mol/L, and volume ratio of membrane solution to stripping solution was 30：30 of the renewal phase, and pH value was 4.80 of the feed phase. Under the optimum condition studied, when initial concentration of Gd（III） was 1.00 × 10^-4 mol/L, the transfer rate of Gd（III） was 96.8% during 130 min.

Modeling of Ce（IV） transport through a dispersion flat combined liquid membrane with carrier P507

A mathematical model for the transport of Ce （IV） from hydrochloric acid solutions through dispersion flat combined liquid membrane （DFCLM） with contain 2- ethyl hexyl phosphonic acid-mono-2-ethyl hexyl ester （P507） as the carrier, dissolved in kerosene as the membrane solution have been studied. This process of facilitated transport, based on membrane technology, is a variation on the conventional technique of solvent extraction and may be described mathematically using Fick＇s second law. The equations for transport velocity are derived considering the diffusion of P507 and its metallic complexes through the liquid membrane. In this work, the system is considered to be in a transient state, and chemical reaction between Ce（IV） and the carrier to take place only at the solvent-aqueous interfaces. Model concentration profiles are obtained for the Ce（IV）, from which extraction velocities are predicted. The experimental and simulated Ce（IV） extractions showed similar tendencies for a high Ce （IV） concentration and acidity case.The model results indicate that high initial Ce（IV） concentrations and acidity both have detrimental effects on Ce（IV） extraction and stripping. The diffusion coefficient of Ce（IV） in the membrane and the thickness of diffusion layer between feed phase and membrane phase are obtained and the values are 6.31 × 10-8m2·s-1 and 31.2 μm, respectively. The results are in good agreement with experimental results.

Stripping dispersion hollow fiber liquid membrane containing carrier PC-88A and HNO_3 for the extraction of Sm^(3+)

Stripping dispersion hollow fiber liquid membrane system（SDHFLM） containing feed phase adding acetate buffer solution and dispersion solution with HNO_3 solution as the stripping solution and membrane solution of 2-ethyl hexyl phosphoric acid-mono-2-ethylhexyl ester（PC-88A） dissolved in kerosene,has been studied for the extraction of Sm^（3＋）.Many factors including pH value, volume ratio of membrane solution to stripping solution（OAV） and carrier concentration on Sm^（3＋） extraction were investigated. Experimental results indicate that the optimum extraction conditions of Sm^（3＋） were obtained as that PC-88A concentration was 0.120 mol/L,and OAV was 1.00 in the dispersion phase,and pH value was 4.80 in the feed phase.When initial Sm^（3＋） concentration was 1.20×10^（-4） mol/L,the extraction percentage of Sm^（3＋） was up to 92.8%in 160 min.