Gas blowing is a valid method to remove the impurities from metallurgical grade silicon（MG-Si） melt.The thermodynamic behavior of impurities Fe,Al,Ca,Ti,Cu,C,B and P in MG-Si was studied in the process of O2 blowing...Gas blowing is a valid method to remove the impurities from metallurgical grade silicon（MG-Si） melt.The thermodynamic behavior of impurities Fe,Al,Ca,Ti,Cu,C,B and P in MG-Si was studied in the process of O2 blowing.The removal efficiencies of impurities in MG-Si were investigated using O2 blowing in ladle.It is found that the removal efficiencies are higher than 90% for Ca and Al and nearly 50% for B and Ti.The morphology of inclusions was analyzed and the phases Al3Ni,NiSi2 and Al3Ni were confirmed in MG-Si by X-ray diffraction.It was found that SiB4 exists in Si？B binary system.The chemical composition of inclusions in MG-Si before and after refining was analyzed by SEM-EDS.It is found that the amount of white inclusion reduces for the removal of most Al and Ca in the forms of molten slag inclusion and the contents of Fe,Ni and Mn in inclusion increase for their inertia in silicon melt with O2 blowing.展开更多
采用小试装置,研究了短好氧污泥龄下A2/O和BAF联合工艺处理低C/N和C/P污水时的脱氮除磷特性。结果表明,通过提高A2/O工艺段的厌氧区有机负荷和缺氧区硝酸盐负荷对反硝化聚磷菌(DPAOs)进行选择和强化后,其在聚磷菌(PAOs)中的比例维持在28...采用小试装置,研究了短好氧污泥龄下A2/O和BAF联合工艺处理低C/N和C/P污水时的脱氮除磷特性。结果表明,通过提高A2/O工艺段的厌氧区有机负荷和缺氧区硝酸盐负荷对反硝化聚磷菌(DPAOs)进行选择和强化后,其在聚磷菌(PAOs)中的比例维持在28%左右,工艺具有部分反硝化除磷能力,能够减少脱氮除磷过程中对碳源的总需求量。但在联合工艺中,好氧除磷仍是主要的除磷方式。在A2/O工艺段内,好氧污泥龄在满足好氧PAOs存活的同时,还必须满足抑制硝化细菌生长的要求,且为了保证工艺对磷的整体去除效果,混合液在好氧区的接触时间须大于30 m in。此外,以保证缺氧区出水中含有1~4 mg/L的硝态氮为原则来控制BAF出水的回流量,可达到较好的脱氮除磷效果。该联合工艺结合了活性污泥工艺和生物膜工艺的优点,运行稳定,出水水质优良,不仅适合于新建污水处理厂,也特别适合于不能脱氮除磷污水处理厂的技术改造。展开更多
A bench-scale anaerobic/anoxic/aerobic process-biological aerated filter （A^2/O-BAF） combined system was carded out to treat wastewater with lower C/N and C/P ratios. The A^2/O process was operated in a short aerobi...A bench-scale anaerobic/anoxic/aerobic process-biological aerated filter （A^2/O-BAF） combined system was carded out to treat wastewater with lower C/N and C/P ratios. The A^2/O process was operated in a short aerobic sludge retention time （SRT） for organic pollutants and phosphorus removal, and denitrification. The subsequent BAF process was mainly used for nitrification. The BAF effluent was partially returned to anoxic zone of the A^2/O process to provide electron acceptors for denitrification and anoxic P uptake. This unique system formed an environment for reproducing the denitdfying phosphate-accumulating organisms （DPAOs）. The ratio of DPAOs to phosphorus accumulating organisms （PAOs） could be maintained at 28% by optimizing the organic loads in the anaerobic zone and the nitrate loads into the anoxic zone in the A^2/O process. The aerobic phosphorus over-uptake and discharge of excess activated sludge was the main mechanism of phosphorus removal in the combined system. The aerobic SRT of the A^2/O process should meet the demands for the development of aerobic PAOs and the restraint on the nitrifiers growth, and the contact time in the aerobic zone of the A^2/O process should be longer than 30 min, which ensured efficient phosphorus removal in the combined system. The adequate BAF effluent return rates should be controlled with 1--4 mg/L nitrate nitrogen in the anoxic zone effluent of A^2/O process to achieve the optimal nitrogen and phosphorus removal efficiencies.展开更多
Nowadays, in China, the bottom-blowing technique plays an important role in accelerating the molten bath stirring and promoting the metallurgical reactions in electric arc furnace (EAF) steelmaking. The innovations of...Nowadays, in China, the bottom-blowing technique plays an important role in accelerating the molten bath stirring and promoting the metallurgical reactions in electric arc furnace (EAF) steelmaking. The innovations of bottom-blowing technologies in EAF steelmaking were reviewed. The optimized bottom-blowing arrangement in EAF based on the furnace structure and the position of electrodes was introduced, and the fluid flow characteristics of EAF molten bath with bottomblowing were analyzed. Furthermore, bottom-blowing CO2 in EAF can facilitate the carbon-oxygen reaction reaching equilibrium and decrease the content of nitrogen in molten steel due to its special metallurgical properties. Pulsating bottom-blowing in EAF can effectively improve the molten bath stirring through the action of the unsteady bottom blowing gas streams, which could make the fluid flow field more disorderly than the steady bottom-blowing. And submerged O2 injection with CO2 in EAF can noticeably strengthen the EAF molten bath stirring, increase the production efficiency and improve the molten steel quality.展开更多
The combination of leachate recirculation and aeration to landfill may be an efficient way for in-situ nitrogen removal.However,nitrogenous substances contained in the landfill layer are concomitantly transformed into...The combination of leachate recirculation and aeration to landfill may be an efficient way for in-situ nitrogen removal.However,nitrogenous substances contained in the landfill layer are concomitantly transformed into N2O and NH3,leading to increased emissions into the atmosphere.In the present study,the emissions of N2O and NH3 were measured under conditions of fresh or partially stabilized refuse with or without leachate recirculation or intermittent aeration.The results showed that the largest N2O emission（12.4 mg-N/L of the column） was observed in the aerated column loaded with partially stabilized refuse and recycled with the leachate of low C/N ratio;while less than 0.33 mg-N/L of the column was produced in the other columns.N2O production was positively correlated with the prolonged aerobic time and negatively related with the C/N ratio in the recycled leachate.NH3 volatilization increased with enhanced gas flow and concentration of free ammonia in the leachate,and the highest cumulative volatilization quantity was 1.7 mg-N/L of the column.展开更多
基金Projects(51104080,u1137601) supported by the National Natural Science Foundation of ChinaProject(2009CD027) supported by the Natural Science Foundation of Yunnan Province,ChinaProject(14118557) supported by the Personnel Training Foundation of Kunming University of Science and Technology,China
文摘Gas blowing is a valid method to remove the impurities from metallurgical grade silicon（MG-Si） melt.The thermodynamic behavior of impurities Fe,Al,Ca,Ti,Cu,C,B and P in MG-Si was studied in the process of O2 blowing.The removal efficiencies of impurities in MG-Si were investigated using O2 blowing in ladle.It is found that the removal efficiencies are higher than 90% for Ca and Al and nearly 50% for B and Ti.The morphology of inclusions was analyzed and the phases Al3Ni,NiSi2 and Al3Ni were confirmed in MG-Si by X-ray diffraction.It was found that SiB4 exists in Si？B binary system.The chemical composition of inclusions in MG-Si before and after refining was analyzed by SEM-EDS.It is found that the amount of white inclusion reduces for the removal of most Al and Ca in the forms of molten slag inclusion and the contents of Fe,Ni and Mn in inclusion increase for their inertia in silicon melt with O2 blowing.
文摘采用小试装置,研究了短好氧污泥龄下A2/O和BAF联合工艺处理低C/N和C/P污水时的脱氮除磷特性。结果表明,通过提高A2/O工艺段的厌氧区有机负荷和缺氧区硝酸盐负荷对反硝化聚磷菌(DPAOs)进行选择和强化后,其在聚磷菌(PAOs)中的比例维持在28%左右,工艺具有部分反硝化除磷能力,能够减少脱氮除磷过程中对碳源的总需求量。但在联合工艺中,好氧除磷仍是主要的除磷方式。在A2/O工艺段内,好氧污泥龄在满足好氧PAOs存活的同时,还必须满足抑制硝化细菌生长的要求,且为了保证工艺对磷的整体去除效果,混合液在好氧区的接触时间须大于30 m in。此外,以保证缺氧区出水中含有1~4 mg/L的硝态氮为原则来控制BAF出水的回流量,可达到较好的脱氮除磷效果。该联合工艺结合了活性污泥工艺和生物膜工艺的优点,运行稳定,出水水质优良,不仅适合于新建污水处理厂,也特别适合于不能脱氮除磷污水处理厂的技术改造。
文摘A bench-scale anaerobic/anoxic/aerobic process-biological aerated filter （A^2/O-BAF） combined system was carded out to treat wastewater with lower C/N and C/P ratios. The A^2/O process was operated in a short aerobic sludge retention time （SRT） for organic pollutants and phosphorus removal, and denitrification. The subsequent BAF process was mainly used for nitrification. The BAF effluent was partially returned to anoxic zone of the A^2/O process to provide electron acceptors for denitrification and anoxic P uptake. This unique system formed an environment for reproducing the denitdfying phosphate-accumulating organisms （DPAOs）. The ratio of DPAOs to phosphorus accumulating organisms （PAOs） could be maintained at 28% by optimizing the organic loads in the anaerobic zone and the nitrate loads into the anoxic zone in the A^2/O process. The aerobic phosphorus over-uptake and discharge of excess activated sludge was the main mechanism of phosphorus removal in the combined system. The aerobic SRT of the A^2/O process should meet the demands for the development of aerobic PAOs and the restraint on the nitrifiers growth, and the contact time in the aerobic zone of the A^2/O process should be longer than 30 min, which ensured efficient phosphorus removal in the combined system. The adequate BAF effluent return rates should be controlled with 1--4 mg/L nitrate nitrogen in the anoxic zone effluent of A^2/O process to achieve the optimal nitrogen and phosphorus removal efficiencies.
基金The authors would like to express their thanks for the support by the National Natural Science Foundation of China (No.51734003).
文摘Nowadays, in China, the bottom-blowing technique plays an important role in accelerating the molten bath stirring and promoting the metallurgical reactions in electric arc furnace (EAF) steelmaking. The innovations of bottom-blowing technologies in EAF steelmaking were reviewed. The optimized bottom-blowing arrangement in EAF based on the furnace structure and the position of electrodes was introduced, and the fluid flow characteristics of EAF molten bath with bottomblowing were analyzed. Furthermore, bottom-blowing CO2 in EAF can facilitate the carbon-oxygen reaction reaching equilibrium and decrease the content of nitrogen in molten steel due to its special metallurgical properties. Pulsating bottom-blowing in EAF can effectively improve the molten bath stirring through the action of the unsteady bottom blowing gas streams, which could make the fluid flow field more disorderly than the steady bottom-blowing. And submerged O2 injection with CO2 in EAF can noticeably strengthen the EAF molten bath stirring, increase the production efficiency and improve the molten steel quality.
基金supported by the National Key Technology R&D Program of China(No.2006BAJ04A06)the National High Technology Research and Development Program(863) of China(No.2003AA644020)the Program of Shanghai Subject Chief Scientist(No. 10XD1404200)
文摘The combination of leachate recirculation and aeration to landfill may be an efficient way for in-situ nitrogen removal.However,nitrogenous substances contained in the landfill layer are concomitantly transformed into N2O and NH3,leading to increased emissions into the atmosphere.In the present study,the emissions of N2O and NH3 were measured under conditions of fresh or partially stabilized refuse with or without leachate recirculation or intermittent aeration.The results showed that the largest N2O emission（12.4 mg-N/L of the column） was observed in the aerated column loaded with partially stabilized refuse and recycled with the leachate of low C/N ratio;while less than 0.33 mg-N/L of the column was produced in the other columns.N2O production was positively correlated with the prolonged aerobic time and negatively related with the C/N ratio in the recycled leachate.NH3 volatilization increased with enhanced gas flow and concentration of free ammonia in the leachate,and the highest cumulative volatilization quantity was 1.7 mg-N/L of the column.
