Literature overview of basic characteristics and flotation laws of flocs

Flocculation flotation is the most efficient method for recovering fine-grained minerals,and its essence lies in flotation and recovery of flocs.Fundamental physical characteristics of flocs are mainly determined by their apparent particle size and structure(density and morphology).Substantial researches have been conducted regarding the effect of floc characteristics on particle settling and water treatment.However,the influence of floc characteristics on flotation has not been widely studied.Based on the floc formation and flocculation flotation,this study reviews the fundamental physical characteristics of flocs from the perspectives of floc particle size and structure,summarizing the interaction between floc particle size and structure.Moreover,it thoroughly discusses the effect of floc particle size and structure on floc floatability,further revealing the influence of floc characteristics on bubble collision and adhesion and elucidating the mechanisms of interaction between flocs and bubbles.Thus,it is observed that floc particle size is not the only factor influencing flocculation flotation.Within the appropriate apparent particle size range,flocs with a compact structure exhibit higher efficiency in bubble collision and adhesion during flotation,thereby resulting in enhanced flotation performance.This study aims to provide a reference for flocculation flotation,targeting the development of more efficient and refined flocculation flotation processes in the future.

Basic characteristics of Australian iron ore concentrate and its effects on sinter properties during the high-limonite sintering process

The basic characteristics of Australian iron ore concentrate (Ore-A) and its effects on sinter properties during a high-limonite sintering process were studied using micro-sinter and sinter pot methods. The results show that the Ore-A exhibits good granulation properties, strong liquid flow capability, high bonding phase strength and crystal strength, but poor assimilability. With increasing Ore-A ratio, the tumbler index and the reduction index (RI) of the sinter first increase and then decrease, whereas the softening interval (Delta T) and the softening start temperature (T (10%)) of the sinter exhibit the opposite behavior; the reduction degradation index (RDI+3.15) of the sinter increases linearly, but the sinter yield exhibits no obvious effects. With increasing Ore-A ratio, the distribution and crystallization of the minerals are improved, the main bonding phase first changes from silico-ferrite of calcium and aluminum (SFCA) to kirschsteinite, silicate, and SFCA and then transforms to 2CaO center dot SiO2 and SFCA. Given the utilization of Ore-A and the improvement of the sinter properties, the Ore-A ratio in the high-limonite sintering process is suggested to be controlled at approximately 6wt%.

Basic Characteristics of Waterfalls in the Yarlung Zangbo River

The Great Bent in the lower reaches of the Yarlung Zangbo River in Tibet houses the largest fluvial gorge in the world. On October 18, 1998, the Chinese government named the gorge the Grand Canyon of the Yarlung Zangbo. Later, from October to December, the first trekking exploration through the canyon was successfully conducted by a group of Chinese scientists. In the meantime, the scientists carfled out a multi-disciplinary and comprehensive survey and made many discoveries in the region.

Reservoir Characteristics and Favorable Area Prediction of Chang-6 Reservoir in Zhouguan Area, Ordos Basin

Based on the analysis of a large number of core samples, logging results, logging interpretation data and dynamic data in the study area, the characteristics of Chang 6 reservoir in Zhouguan area of Baihe area are studied, and the favorable reservoir areas in the study area are predicted. The results show that the lithology of Chang 6 reservoir is mainly light gray and gray fine-grained to very fine-grained feldspar lithic sandstone. The pore types are mainly residual intergranular pores and feldspar dissolved pores, including debris dissolved pores and microfractures. The porosity and permeability values are low, which belongs to low porosity-low permeability and ultra-low permeability reservoirs. According to the reservoir distribution characteristics and related data, the Chang 6 reservoir in the study area is divided into two types, mainly Class II and Class III reservoirs. The comprehensive evaluation predicts that the spatial distribution of the favorable area of Chang 6 reservoir is not uniform, but the distribution area is large, which has broad exploration and development value, and provides the necessary conditions for the distribution study of the favorable oil-bearing zone in this area and the preparation for the next exploration and development.

Some Characteristic Parameters of the Basic Components of the Solar Radio Emission

Four basic components of the solar radio emission: the quiet sun, the slowly varying component (SVC), the radio burst and the ultra-fast varying component (UFVC) are studied. As their six characteristic parameters: radiation source, brightness temperature, radiation lifetime, polarized radiation, radiation mechanism, and character of superposition are affirmed.

Insights into multisource sludge distributed in the Yangtze River basin, China: Characteristics,correlation, treatment and disposal

Sludge is the by-product of wastewater treatment process. Multisource sludge can be defined as sludge from different sources. Based on the sludge properties of five typical cities in the Yangtze River basin, including Jiujiang, Wuhu, Lu’an, Zhenjiang and Wuhan, this study investigated and summarized the characteristic variations and distribution differences of multiple indicators and substances from municipal sludge, dredged sludge, and river and lake sediments. The results demonstrated pH of multisource sludge was relatively stable in the neutral range. Organic matter and water content among municipal sludge were high and varied considerably between different wastewater treatment plants. Dredged sludge had an obviously higher sand content and wider particle distribution, which could be considered for graded utilization depending on its size. The nutrients composition of river and lake sediments was usually stable and special, with lower nitrogen and phosphorus content but higher potassium levels. The sources of heavy metals and persistent organic pollutants in multisource sludge were correlated, generally much higher among municipal sludge than dredged sludge and river and lake sediments, which were the most important limitation for final land utilization. Despite various properties of multisource sludge, the final fate and destination have some overall similarities, which need to be supplemented and improved by standards and laws. The study provided a preliminary analysis of suitable technical routes for municipal sludge, dredged sludge, river and lake sediments based on their different characteristics respectively, which was of great significance for multisource sludge co-treatment and disposal in the future of China.

苏芸金杆菌187菌株的研究进展

苏芸金杆菌１８７菌株自１９７８年发现以来，经近２０年的研究，现已在如下方面取得了重要成果：１．苏芸金杆菌１８７菌株的生物学特性；２．其毒力与对蚊幼虫的致病机理；３．其伴孢晶体和芽孢的超微结构、生理生化与抗原特性；４．其发酵条件与特性；５．

Distribution Characteristics of Geohazards Induced by the Lushan Earthquake and Their Comparisons with the Wenchuan Earthquake

The Lushan Earthquake induced a large number of geohazards. They are widely distributed and caused serious damages. The basic characteristics, formation mechanisms and typical cases of geohazards induced by Lushan Earthquake are described, and compares to the relationships of Lushan and Wenchuan earthquakes between geohazards and earthquake magnitude, geomorphology, slope angle, elevation and seismic intensity in the most affected areas in the article.（1） The numbers and volumes of landslides and rockslides differ significantly between the two earthquakes due to their differing magnitudes. The Lushan Earthquake is associated with fewer and smaller-magnitude geohazards, within the immediate area, which mainly consist of small-and medium-sized shallow landslides and rockslides, and occur on steep slopes and mountain valleys. The largest landslide induced by Lushan Earthquake is the Gangoutou Landslide debris flow with a residual volume of about 2.48×106 m3. The most dangerous debris flow is at Lengmugou gulley in Baoxing County, which has similar geomorphological features and disaster modes as a previous disaster in Zhouqu County, Gansu Province.（2） Geohazards induced by the Lushan Earthquake show four mechanisms： cracking-rockslides-collision- scraping and then debris flows, cracking-rockslides, vibration-rainfall-rockslides-landslide and then debris flow, vibration-throwing or scrolling.（3） There are significant similarities and differences between the geohazards induced by these two earthquakes. The types of geohazards are the same but the volume, quantity and other factors differ： geohazards are concentrated on slope angles of 10°-40° in the Lushan Earthquake area, especially within 10°-20°, and at absolute elevation of 500-2000 m above sea level（a.s.l.）. Geohazards within the Wenchuan Earthquake area are concentrated on steeper slope angles of 30°-40° at higher absolute elevations of 1500-2000 m.s.l..