The design and the deposition of a rugate filter for broadband applications are discussed.The bandwidth is extended by increasing the rugate period continuously with depth.The width and the smoothness of the reflectio...The design and the deposition of a rugate filter for broadband applications are discussed.The bandwidth is extended by increasing the rugate period continuously with depth.The width and the smoothness of the reflection band with the distribution of the periods are investigated.The improvement of the steepness of the stopband edges and the suppression of the side lobes in the transmission zone are realized by adding two apodized rugate structures with fixed periods at the external broadband rugate filter interfaces.The rapidly alternating deposition technology is used to fabricate a rugate filter sample.The measured transmission spectrum with a reflection bandwidth of approximately 505 nm is close to that of the designed broadband rugate filter except a transmittance peak in the stopband.Based on the analysis of the cross-sectional scanning electron microscopic image of the sample,it is found that the transmission peak is most likely to be caused by the instability of the deposition rate.展开更多
针对宽带雷达检测门限值设置难度大、系统复杂度高、实时性差等问题,提出了一种UWB-SOSCA(Ultra-Wide Band-Smallest of Ordered Statistics and Cell Average)检测算法。该算法主要包括多相滤波、SOSCA恒虚警检测和二元积累。其中,多...针对宽带雷达检测门限值设置难度大、系统复杂度高、实时性差等问题,提出了一种UWB-SOSCA(Ultra-Wide Band-Smallest of Ordered Statistics and Cell Average)检测算法。该算法主要包括多相滤波、SOSCA恒虚警检测和二元积累。其中,多相滤波将宽带信号划分为多个子信道,降低通道速率;SOSCA恒虚警检测分别对各子信道进行自适应门限调整,提高各子信道检测概率;二元积累对各子信道的检测结果进行时域联合,优化宽带时域连续检测性能。实验结果表明,在信噪比等于7.33 dB,虚警概率为10~(-5)时,SOSCA恒虚警检测算法与传统恒虚警算法相比,检测概率可提升14%;当多相滤波输入信噪比为-5 dB时,UWB-SOSCA算法的宽带线性调频信号脉冲宽度测量偏差优于6.5 ns。该算法具有大监视带宽、大动态范围和高检测概率,可广泛应用于侦察接收机的雷达侦测工作。展开更多
In modern active and passive sonar systems, broadband beamforming for acoustic arrays is widely used to suppress unwanted interference and to detect target signals of interest. A broadband low sidelobe beamforming sch...In modern active and passive sonar systems, broadband beamforming for acoustic arrays is widely used to suppress unwanted interference and to detect target signals of interest. A broadband low sidelobe beamforming scheme in time domain is proposed in this paper. The first step of this scheme is to delay the outputs of each element in the acoustic array by a tapped-delay-line (TDL) to accomplish the integer part of the time delay need to form a beam. Then, finite impulse response (FIR) digital filters are used to implement the fractional part of the time delay. The weighting coefficients for all array elements at different frequencies to realize the low sidelobe beams are also implemented with the FIR digital filters. Finally, the outputs of the digital filters are summed up to yield the time domain beam output. The design of low sidelobe beam pattern and that of the FIR digital filters are two crucial technical issues in this beamforming procedure. The low sidelobe beams of each sub-band are designed using the optimized beam synthesis approach based on the principle of MVDR beamforming. An improved adaptive approach are used for the design of FIR digital filters, and the design requirements of these filters were specified by the weights of low sidelobe beams of each sub-band over the broad frequency band. Results of computer simulation for a twelve-element arc array show that the beamforming scheme is very effective in forming low sidelobe broadband beam.展开更多
Two methods for improving the equidriving power-frequency characteristics of broad-band high power klystrons are presented. One is that a comb-line bandpass filter with someattenuation properties is inserted between t...Two methods for improving the equidriving power-frequency characteristics of broad-band high power klystrons are presented. One is that a comb-line bandpass filter with someattenuation properties is inserted between the TWT driver and the klystron for compensatingthe gain-frequency characteristics of the klystron to get the required equidriving power-frequencycharacteristics. The other is that a reactive element is connected with the input cavity to changeits resonance frequencies f<sub>0</sub> and Q<sub>L</sub>, and thus to improve the power-frequency characteristics ofthe klystron.展开更多
基金Project supported by the National Natural Science Foundation of China (Grant No. 10704079)the NSAF Joint Fund,China(Grant No. 10976030)
文摘The design and the deposition of a rugate filter for broadband applications are discussed.The bandwidth is extended by increasing the rugate period continuously with depth.The width and the smoothness of the reflection band with the distribution of the periods are investigated.The improvement of the steepness of the stopband edges and the suppression of the side lobes in the transmission zone are realized by adding two apodized rugate structures with fixed periods at the external broadband rugate filter interfaces.The rapidly alternating deposition technology is used to fabricate a rugate filter sample.The measured transmission spectrum with a reflection bandwidth of approximately 505 nm is close to that of the designed broadband rugate filter except a transmittance peak in the stopband.Based on the analysis of the cross-sectional scanning electron microscopic image of the sample,it is found that the transmission peak is most likely to be caused by the instability of the deposition rate.
文摘In modern active and passive sonar systems, broadband beamforming for acoustic arrays is widely used to suppress unwanted interference and to detect target signals of interest. A broadband low sidelobe beamforming scheme in time domain is proposed in this paper. The first step of this scheme is to delay the outputs of each element in the acoustic array by a tapped-delay-line (TDL) to accomplish the integer part of the time delay need to form a beam. Then, finite impulse response (FIR) digital filters are used to implement the fractional part of the time delay. The weighting coefficients for all array elements at different frequencies to realize the low sidelobe beams are also implemented with the FIR digital filters. Finally, the outputs of the digital filters are summed up to yield the time domain beam output. The design of low sidelobe beam pattern and that of the FIR digital filters are two crucial technical issues in this beamforming procedure. The low sidelobe beams of each sub-band are designed using the optimized beam synthesis approach based on the principle of MVDR beamforming. An improved adaptive approach are used for the design of FIR digital filters, and the design requirements of these filters were specified by the weights of low sidelobe beams of each sub-band over the broad frequency band. Results of computer simulation for a twelve-element arc array show that the beamforming scheme is very effective in forming low sidelobe broadband beam.
文摘Two methods for improving the equidriving power-frequency characteristics of broad-band high power klystrons are presented. One is that a comb-line bandpass filter with someattenuation properties is inserted between the TWT driver and the klystron for compensatingthe gain-frequency characteristics of the klystron to get the required equidriving power-frequencycharacteristics. The other is that a reactive element is connected with the input cavity to changeits resonance frequencies f<sub>0</sub> and Q<sub>L</sub>, and thus to improve the power-frequency characteristics ofthe klystron.
