Insight into MgO promoter with low concentration for the carbon-deposition resistance of Ni-based catalysts in the CO_2 reforming of CH_4

The CO2reforming of CH4is studied over MgO‐promoted Ni catalysts,which were supported on alumina prepared from hydrotalcite.This presents an improved stability compared with non‐promoted catalysts.The introduction of the MgO promoter was achieved through the‘‘memory effect’’of the Ni‐Al hydrotalcite structure,and ICP‐MS confirmed that only0.42wt.%of Mg2+ions were added into the Ni‐Mg/Al catalyst.Although no differences in the Ni particle size and basicity strength were observed,the Ni‐Mg/Al catalyst showed a higher catalytic stability than the Ni/Al catalyst.A series of surface reaction experiments were used and showed that the addition of a MgO promoter with low concentration can promote CO2dissociation to form active surface oxygen arising from the formation of the Ni‐MgO interface sites.Therefore,the carbon‐resistance promotion by nature was suggested to contribute to an oxidative environment around Ni particles,which would increase the conversion of carbon residues from CH4cracking to yield CO on the Ni metal surface.?2018,Dalian Institute of Chemical Physics,Chinese Academy of Sciences.Published by Elsevier B.V.All rights reserved.

Glow Discharge Plasma-Assisted Preparation of Nickel-Based Catalyst for Carbon Dioxide Reforming of Methane

A plasma-assisted method was employed to prepare Ni/γ-All2O3 catalyst for carbon dioxide reforming of methane reaction. The novel catalyst possessed higher activity and better coke-suppression performance than those of the conventional calcination catalyst. To achieve the same CH4 conversion, the conventional catalyst needed higher reaction temperature, about 50 ℃ higher than that of the N2 plasma-treated catalyst. After the evaluation test, the deactivation rate of the novel catalyst was 1.7%, compared with 15.2% for the conventional catalyst. Different from the characterization results of the calcined catalyst, a smaller average pore diameter and a higher specific surface area were obtained for the plasma-treated catalyst. The variations of the reduction peak temperatures and areas indicated that the catalyst reducibility was promoted by plasma assistance. The dispersion of nickel was also remarkably improved, which was helpful for controlling the ensemble size of metal atoms on the catalyst surface. The modification effect of plasma- assisted preparation on the surface property of alumina supported catalyst was speculated to account for the concentration increase of absorbed CO2. An enhancement of CO2 adsorption was propitious to the inhibition of carbon formation. The coke amount deposited on plasma treated catalyst was much smaller than that on the conventional catalyst.

A Novel Catalyst for CO_(2) Reforming of CH_4

A novel Ni-Co/SiO2 catalyst which exhibits high activity and excellent anti-carbon deposition property for CO2 reforming of CH4 to synthesis gas is developed.

Thermodynamic analysis of mixed and dry reforming of methane for solar thermal applications

Thermodynamic analysis of the reforming of methane with carbon dioxide alone （＂dry reforming＂） and with carbon dioxide and steam together （＂mixed reforming＂） is performed as part of a project which investigates the suitability of these endothermic reactions for the storage of solar thermal energy. The Gibbs free energy minimization method was employed to identify thermodynamically optimal operating conditions for dry reforming as well as mixed reforming with a desired H2/CO molar ratio of 2. The non-stoichiometric equilibrium model was developed using FactSage software to conduct the thermodynamic calculations for carbon formation, H2/CO ratio, CH4 conversion and H2 yield as a function of reaction temperature, pressure and reactant molar ratios. Thermodynamic calculations demonstrate that in the mixed reforming process, optimal operating conditions in a carbon-free zone are under H2O/CH4 /CO2 =1.0/1.0/0.5, p = 1 to 10 bar and T = 800 to 850℃ for the production of syngas with a H2 /CO molar ratio of 2. Under the optimal conditions, the maximum H2 yield of 88.0% is achieved at 1 bar and 850℃ with a maximum CH4 conversion of 99.3%. In the dry reforming process, a carbon formation regime is always present at a CO2/CH4 molar ratio of 1 for T = 700 1000℃ and p = 1-30 bar, whereas a carbon-free regime can be obtained at a CO2/CH4 molar ratio greater than 1.5 and T≥800℃.