A high-performance LED-side-pumped two-rod Nd,Ce:YAG laser with continuous-wave(CW) and acousto–optical(A-O) Q-switched operation is demonstrated in this work. A symmetrically shaped flat–flat cavity with two identi...A high-performance LED-side-pumped two-rod Nd,Ce:YAG laser with continuous-wave(CW) and acousto–optical(A-O) Q-switched operation is demonstrated in this work. A symmetrically shaped flat–flat cavity with two identical LEDside-pumped laser modules is employed for power scalability. In the CW regime, the maximum output average power of laser at 1064 nm is 4.41 W, corresponding to a maximum optical conversion efficiency of 5.3% and a slope efficiency is 12.4%. In the active Q-switched regime, the pulse energy of laser reaches as high as 0.89 m J at a repetition rate of 800 Hz with a pulse width of 457.2 ns, the corresponding highest peak output power is 1.94 k W and the M~2 factor is measured to be about 8.8. To the best of the authors' knowledge, this is the first demonstration and the highest performance of a CW LED-side-pumped two-rod laser Nd,Ce:YAG with Watt-level output reported so far.展开更多
YAG： Ce^3 ＋ phosphor particles were prepared using polyacrylamide gel method. The structure evolution of powders during annealing process was followed by X-ray diffraction determination. It is found that some interm...YAG： Ce^3 ＋ phosphor particles were prepared using polyacrylamide gel method. The structure evolution of powders during annealing process was followed by X-ray diffraction determination. It is found that some intermediate phases, including θ-Al2O3, YAM and YAP, are formed when calcining polyacrylamide gel, however, the pure YAG phase can be formed directly when calcining polyacrylamide gel with α-Al2O3 as seed crystal. These facts show that the existence of α- Al2O3 seed crystal can block the formation of θ-Al2O3, YAM and YAP, and accelerate its reaction with Y2O3 to form YAG phase directly at lower temperature. The emission peak of prepared YAG ： Ce^3 ＋ phosphor is wide with maximum at 550 nm and the exitation band has two peaks, the major one is around at 460 nm, which matches the blue emission of GaN LED and is suitable for the assemble of white LED. Some fluxes can enhance the photoluminescence intensity of phosphor particles, that can be attributed both to the improvement of crystallization processes of YAG and to the stabilization of trivalence cerium ion in YAG：Ce^3 ＋.展开更多
Ce (3+) doped Y_3Al_5O_(12) (Ce (3+)∶YAG) single crystal is an good scintillator due to its excellent thermal,mechanic and scintillant performances. In this paper,its vacuum ultraviolet and fluorescence spectra using...Ce (3+) doped Y_3Al_5O_(12) (Ce (3+)∶YAG) single crystal is an good scintillator due to its excellent thermal,mechanic and scintillant performances. In this paper,its vacuum ultraviolet and fluorescence spectra using the synchrotron radiation as the excitation source was studied. The ultraviolet-visible excitation and absorption spectra of Ce (3+)∶YAG were also measured. The excitation energy transfer process and the luminescent differences under direct excitation into the 5d bands of Ce (3+) and excitation of valence band in Ce (3+)∶YAG scintillator were studied.展开更多
A novel synthesis process, based on the polyacrylamide gel method, was used to prepare Ce-doped YAG phosphor powders. Effects of heat treatment parameters, temperature and holding time, the fluxes, and atmosphere on m...A novel synthesis process, based on the polyacrylamide gel method, was used to prepare Ce-doped YAG phosphor powders. Effects of heat treatment parameters, temperature and holding time, the fluxes, and atmosphere on microstructure and particle morphology as well as luminescent properties of YAG:Ce3+ phosphor powders were studied by X-ray powder diffractometry, scanning electron microscopy, and fluorescence spectrophotometry. The results show that the formation temperature (1 000 ℃) of pure YAG phase is significant low when being synthesized by the polyacrylamide gel method, compared with solid-state reaction. For luminescent properties, the intensity of emission of YAG:Ce3+ phosphor increases steadily with increasing temperature from 900 ℃ to 1 300 ℃ and prolonging holding time from 100 min to 400 min. But blue shift phenomenon is observed for 400 min calcination. Fluxes as BaF2 and H3BO3 can enhance the intensity of emission of phosphor due to the improvement of crystallization of YAG and the stabilization of trivalence cerium ion in YAG host lattice at high temperature. Weak reduction atmosphere can contribute to improvement of the emission intensity of YAG:Ce3+ phosphor powders.展开更多
基金Project supported by the Fund from Nanjing University of Posts and Telecommunications,China(Grant Nos.JUH219002 and JUH219007)the Key Research and Development Program of Shandong Province,China(Grant No.2021CXGC010202)。
文摘A high-performance LED-side-pumped two-rod Nd,Ce:YAG laser with continuous-wave(CW) and acousto–optical(A-O) Q-switched operation is demonstrated in this work. A symmetrically shaped flat–flat cavity with two identical LEDside-pumped laser modules is employed for power scalability. In the CW regime, the maximum output average power of laser at 1064 nm is 4.41 W, corresponding to a maximum optical conversion efficiency of 5.3% and a slope efficiency is 12.4%. In the active Q-switched regime, the pulse energy of laser reaches as high as 0.89 m J at a repetition rate of 800 Hz with a pulse width of 457.2 ns, the corresponding highest peak output power is 1.94 k W and the M~2 factor is measured to be about 8.8. To the best of the authors' knowledge, this is the first demonstration and the highest performance of a CW LED-side-pumped two-rod laser Nd,Ce:YAG with Watt-level output reported so far.
文摘YAG： Ce^3 ＋ phosphor particles were prepared using polyacrylamide gel method. The structure evolution of powders during annealing process was followed by X-ray diffraction determination. It is found that some intermediate phases, including θ-Al2O3, YAM and YAP, are formed when calcining polyacrylamide gel, however, the pure YAG phase can be formed directly when calcining polyacrylamide gel with α-Al2O3 as seed crystal. These facts show that the existence of α- Al2O3 seed crystal can block the formation of θ-Al2O3, YAM and YAP, and accelerate its reaction with Y2O3 to form YAG phase directly at lower temperature. The emission peak of prepared YAG ： Ce^3 ＋ phosphor is wide with maximum at 550 nm and the exitation band has two peaks, the major one is around at 460 nm, which matches the blue emission of GaN LED and is suitable for the assemble of white LED. Some fluxes can enhance the photoluminescence intensity of phosphor particles, that can be attributed both to the improvement of crystallization processes of YAG and to the stabilization of trivalence cerium ion in YAG：Ce^3 ＋.
文摘Ce (3+) doped Y_3Al_5O_(12) (Ce (3+)∶YAG) single crystal is an good scintillator due to its excellent thermal,mechanic and scintillant performances. In this paper,its vacuum ultraviolet and fluorescence spectra using the synchrotron radiation as the excitation source was studied. The ultraviolet-visible excitation and absorption spectra of Ce (3+)∶YAG were also measured. The excitation energy transfer process and the luminescent differences under direct excitation into the 5d bands of Ce (3+) and excitation of valence band in Ce (3+)∶YAG scintillator were studied.
文摘A novel synthesis process, based on the polyacrylamide gel method, was used to prepare Ce-doped YAG phosphor powders. Effects of heat treatment parameters, temperature and holding time, the fluxes, and atmosphere on microstructure and particle morphology as well as luminescent properties of YAG:Ce3+ phosphor powders were studied by X-ray powder diffractometry, scanning electron microscopy, and fluorescence spectrophotometry. The results show that the formation temperature (1 000 ℃) of pure YAG phase is significant low when being synthesized by the polyacrylamide gel method, compared with solid-state reaction. For luminescent properties, the intensity of emission of YAG:Ce3+ phosphor increases steadily with increasing temperature from 900 ℃ to 1 300 ℃ and prolonging holding time from 100 min to 400 min. But blue shift phenomenon is observed for 400 min calcination. Fluxes as BaF2 and H3BO3 can enhance the intensity of emission of phosphor due to the improvement of crystallization of YAG and the stabilization of trivalence cerium ion in YAG host lattice at high temperature. Weak reduction atmosphere can contribute to improvement of the emission intensity of YAG:Ce3+ phosphor powders.
