The influence of charge characteristics of suspension droplets on the ion flow field in different temperatures and humidity

In order to clarify the charging characteristics of suspension droplets in ion flow field under different temperatures and humidity,the effective charging factor used to characterize the charging characteristics of suspension droplets is introduced in this paper,and a calculation method of charging factor is proposed based on the upstream finite element method(FEM).Then,the charging factor under different temperatures and humidity is calculated,and the analytic expression of the charging factor considering the influence of temperature and humidity is obtained by fitting the calculation results.The influence of suspension droplets on the ion flow field is analyzed.The results show that the charging factor is small and increases little with the relative humidity when the relative humidity is less than 60%,and the charging factor is large and increases rapidly with the relative humidity when the relative humidity is more than 60%.At the same relative humidity,the charging factor increases linearly with the temperature.The influence of charged suspension droplets on the ion flow field can be ignored when the relative humidity is less than 60%and must be considered under high temperature and humidity.The calculation method and analytic expression of the charging factor proposed in this paper can be used to model of ion flow field considering the influence of temperature and humidity and provide technical support for the construction of HVDC transmission lines across high temperature and humidity.

Distributing Characteristics of the Charge on the Bomb Body with Capacitance Fuze

For establishing the equation of the capacitive target detection accurately, the distributing characteristics of the charges on the bomb body with capacitance fuze were explored. Continuous charges were analyzed dispersively. Based on the Coulomb's law, the dynamic equilibrium equations of the inducing charges on the bomb body were set up. For the four cases of d 0/L (the ratio between the electrode distance and the bomb length), the curves of the charge's distribution were given. It was concluded that: ① the charge density decreases steadily from the end near the frontal electrode to the bomb tail; ② the declining rate of the density is governed by d 0/L , the larger the value of d 0/L ,the higher the declining rate, and vice versa.

Simulation and Analysis of Photo-charge Transfer Characteristics ofBipolar Junction Photogate Transistor for CMOS Imagers

The principle of the two carriers contributing to carry the pixel signal charges is firstly presented,and then the bipolar junction photogate transistor(BJPT)with high performance is proposed for the CMOS image sensor.The numerical analytical model of the photo-charge transfer for the bipolar junction photogate is established in detail. Some numerical simulations are obtained under 0.6 μm CMOS process,which show that its readout rate increases exponentially with the increase of the photo-charge at applied voltage.

Improvement of Operation Characteristics for MONOS Charge Trapping Flash Memory with SiGe Buried Channel

We propose and investigate a novel metal/SiO_2/Si_3N_4/SiO_2/SiGe charge trapping flash memory structure（named as MONOS）, utilizing Si Ge as the buried channel. The fabricated memory device demonstrates excellent programerasable characteristics attributed to the fact that more carriers are generated by the smaller bandgap of Si Ge during program/erase operations. A flat-band voltage shift 2.8 V can be obtained by programming at ＋11 V for 100 us. Meanwhile, the memory device exhibits a large memory window of ~7.17 V under ±12 V sweeping voltage, and a negligible charge loss of 18% after 104 s＇ retention. In addition, the leakage current density is lower than 2.52 × 10^（-7） A·cm^（-2） below a gate breakdown voltage of 12.5 V. Investigation of leakage current-voltage indicates that the Schottky emission is the predominant conduction mechanisms for leakage current. These desirable characteristics are ascribed to the higher trap density of the Si_3N_4 charge trapping layer and the better quality of the interface between the SiO_2 tunneling layer and the Si Ge buried channel. Therefore, the application of the Si Ge buried channel is very promising to construct 3 D charge trapping NAND flash devices with improved operation characteristics.

Experiment Study on the Ending Criteria of Charge and Discharge of Nickel-Hydride Battery

Charge and discharge characteristics of Ni/MH batteries are investigated with experiments. During battery’s working, the voltage, capacity, temperature and internal resistance were recorded, corresponding curves were depicted. Variations of the aforementioned four parameters are differently obvious. Ending criteria of charge and discharge of Ni/MH batteries are discussed on the basis of the curves. Voltage, capacity and temperature of a battery can be used as ending criteria during charge. When discharge takes place, voltage, capacity and internal resistance can be chosen as ending criteria. As a whole, capacity is more suitable for being used as ending criteria of charge and discharge than the other three parameters. At last, the capacity of a battery is recommended to be ending criteria of charge and discharge. The conclusions will provide references to different capacity Ni/MH batteries for electric vehicles.

Charging and absorption characteristics of small particulates under alternative and electrostatic voltages in an electrostatic precipitator

The charge quantity of small particulates such as PM2.5 plays a key role in the collection efficiency of an electrostatic precipitator（ESP）. Under a single electrostatic voltage, it is difficult to charge and absorb small particulates. A new method of superimposing an alternative voltage on the electrostatic voltage is provided in this paper. Characteristics of small particulates are analyzed under alternative and electrostatic voltages. It is demonstrated that an alternative voltage can significantly improve the collection efficiency in three aspects： preventing anti-corona, increasing the charge quantity of small particulates, and increasing the median particulate size by electric agglomeration. In addition, practical usage with the superposition of alternative voltage is provided, and the results are in agreement with the theoretical analysis.

Detonation Propagation Characteristics of Superposition Explosive Materials

In order to investigate detonation propagation characteristics of different charge patterns,the detonation velocities of superposition strip shaped charges made up of a detonating cord and explosives were measured by a detonation velocity measuring instrument under conditions of different ignition.The experimental results and theoretical analysis show that the maximum detonation propagation velocity depends on the explosive materials with the maximum velocity among all the explosive materials.Using detonating cord in a superposition charge can shorten detonation propagation time and improve the efficiency of explosive energy.The measurement method of detonation propagation velocity and experimental results are presented and investigated.

FABRICATION OF POROUS GLASS FIBRES AND ITS CHARGING CHARACTERISTICS

Glass fibers, cc diameter of 350 mum to 500 mum, were made of glasses with an initial composition of 66. 55iO(2) - 25B(2)O(2) - 8. 5 Na2O. Being heated at 580 C for 24 hours and leached in HCl solution at 90 C: for 12 hours, the glass fibers were made into porous glass fibers, pore size in the range 25nm to 35nm. The influence of the glass composition cold condition on glass phase separation Is discussed. The transparence of the porous glass fibers before and after being charged with sensitive reagents and the anti-resolve characteristics of sensitized reagent charged were also studied. The results have shown that the transparence of porous glass fibers after being charged with sensitive reagents and the anti-resolve characteristics of sensitive reagents charged in the materials were very well. By combining with special sensitive reagents, the porous glass fibers could be made into a series of fiber optic chemical sensors with different characteristics.

Evaluation of Four Measurement Operation Modes of Streaming Potential for Microfiltration and Ultrafiltration Membranes

Surface charge characteristics of a membrane can be determined by the streaming potential. In order to obtain more accurate streaming potential value during the measurement, four measurement operation modes were investigated in this study, and among the four modes, the steady mode with pressure stepped downward was considered the best one. Experimental results showed that the effects of compaction on the streaming potential measurement for a microfiltration membrane was more obvious than that for a ultrafiltration membrane. Both feed pH and presoaking could affect the measurement of streaming potential.

Charge and separation characteristics of nanofiltration membrane embracing dissociated functional groups

The current work focused on the investigation of charge and separation characteristics of nanofiltration （NF） membrane embracing dissociated functional groups under different electrolyte solutions. The electro-kinetic method was carried out to assess the membrane volume charge density （X） with different salt concentrations ranging from 0.1 to 10 mol. m-3 and different electrolyte species, such as type 1-1, type 2-1 and type 3-1. The Donnan steric pore model-dielectric exclusion （DSPM- DE） model was employed to evaluate the separation characteristics of the NF membrane for wide range of electrolyte concentration （from 25.7 to 598.9mol·m^-3）. The results indicated that the dissociation of the hydro- philic functional groups and the specific adsorption contributed to charge formation on membrane surface. The former played a dominant role in type 1-1 and type 2-1 electrolytes at dilute aqueous solutions （0.1-0.5 mol · m^3）. However, for type 3-1 electrolyte, specific adsorp- tion should contribute to the charge effect to a large extent. Moreover, the correlation between the volume charge density and feed concentration was in accordance with Freundlich isotherm. Furthermore, it was found that the separation characteristic of NF membrane could be evaluated well by DSPM-DE model coupling with electro-kinetic method in a whole concentration range.

Design and Application of Automatic Test System of Soil Water Characteristic Curve

[Objective] In order to better meet the requirement of crops on a more and more accurate water content under various planting environment of modern agri-culture, an automatic test system of soil water characteristic curve was designed by combining the conceptions of soil moisture content and soil water potential. [Method] Electronic soil moisture tension meter was used to determine the real-time tension value of soil moisture in the tested container, and the electronic Weigh sensor was used to determine soil Weigh. Minusing method was used to calculate soil moisture content, based on which the soil water characteristic curve was plotted. [Result] Through the filed survey of 2 different kinds of soil in Jiangsu Province, the results were as fol ows： soil of different composition showed different trend in soil water characteristic curve that the soil water characteristic relation of the sandy soil in the old course of the Yel ow River in Xuzhou was Y=-0.000 2X3＋0.027 7X2-1.644 5X＋38.161, R2=0.991 9; while the soil water characteristic relation of the saline-alkali soil in Jinhai Farm of Dafeng was Y=-0.00 2X2-0.426X＋39.905, R2=0.991 3. [Con-clusion] The automatic test system of soil water characteristic curve soil water char-acteristics curve could reflect soil moisture content and soil water potential, as wel as reflect the effectiveness of soil water to plant growth, providing basis for the sci-entific irrigation.

Experimental research on charging characteristics of a pressure-controlled VRLA battery in high-temperature environments

Valve-regulated-lead-acid (VRLA) battery charging performed in high-temperature environments is extremely risky under overcharge conditions, and may lead to a subsequent thermal runaway. A new pressure-controlled charging method was adopted and the charging characteristics of the pressure-controlled VRLA battery in high-temperature environments were ex-perimentally studied. The concept was tested in a large temperature gradient to obtain more details about the effects of users' accustomed charging and discharging modes on battery capacity. The premature capacity loss (PCL) phenomenon under high temperature exposure was analyzed. The results showed that the capacity loss could be recovered by charging using a large current.

Experimental research on charging characteristics of a solar photovoltaic system by the pressure-control method

The charging characteristics of the valve-regulated lead acid(VRLA) battery driven by solar energy were experimentally studied through the pressure-control method in this paper.The aims of the research were to increase charging efficiency to make the most of solar energy and to improve charging quality to prolong life of battery.The charging process of a 12 V 12 A·h VRLA battery has been tested under the mode of a stand-alone photovoltaic(PV) system.Results show that the pressure-control method can effectively control PV charging of the VRLA battery and make the best of PV cells through the maximum power point tracking(MPPT).The damage of VRLA battery by excess oxygen accumulation can be avoided through the inner pressure control of VRLA battery.Parameters such as solar radiation intensity,charging power,inner pressure of the battery,and charging current and voltage during the charging process were measured and analyzed.

Empowering highway network:Optimal deployment and strategy for dynamic wireless charging lanes

Amid escalating energy crises and environmental pressures,electric vehicles(EVs)have emerged as an effective measure to reduce reliance on fossil fuels,combat climate change,uphold sustainable energy and environmental development,and strive towards carbon peaking and neutrality goals.This study introduces a nonlinear integer programming model for the deployment of dynamic wireless charging lanes(DWCLs)and EV charging strategy joint optimization in highway networks.Taking into account established charging resources in highway service areas(HSAs),the nonlinear charging characteristics of EV batteries,and the traffic capacity constraints of DWCLs.The model identifies the deployment of charging facilities and the EV charging strategy as the decision-making variables and aims to minimize both the DWCL construction and user charging costs.By ensuring that EVs maintain an acceptable state of charge(SoC),the model combines highway EV charging demand and highway EV charging strategy to optimize the DWCL deployment,thus reducing the construction cost of wireless charging facilities and user charging expenses.The efficacy and universality of the model are demonstrated using the classical Nguyen-Dupius network as a numerical example and a real-world highway network in Guangdong Province,China.Finally,a sensitivity analysis is conducted to corroborate the stability of the model.The results show that the operating speed of EVs on DWCLs has the largest impact on total cost,while battery capacity has the smallest.This comprehensive study offers vital insights into the strategic deployment of DWCLs,promoting the sustainable and efficient use of EVs in highway networks.