Origin of condensate oil and natural gas in Bozhong 19-6 gas field,Bohai Bay Basin

The discovery of the Bozhong 19-6 gas field has opened a new frontier for deep gas exploration in the Bohai Bay Basin,with a great potential for further gas exploration.However,poor understanding of oil and gas origin has been limiting the exploration progress in this area.To clarify the origin of condensate oil and gas in Bozhong 19-6 gas field,this study adequately utilized the organic geochemical analysis data to investigate the composition and geochemical characteristics of condensate oil and natural gas,and analyzed the relationship between condensate oil and the three sets of source rocks in the nearby subsags.Results show that the lighter components dominate the condensate oil,with a forward type predominance.The parent material of crude oil was primarily deposited in a shallow,clay-rich,low-salinity,weakly reducing aquatic environment.The condensate and natural gas have similar parent source characteristics and maturity,with Ro ranging from 1.4%to 1.6%.Both are products of high maturity stage,indicating that they are hydrocarbon compounds produced by the same group of source rocks in the same stage.Oil-sources correlation shows that condensate oil and gas mainly originate from the source rocks of the third member of Shahejie Formation in the nearby subsags of the Bozhong 19-6 structural belt.

Laboratory Investigation into the Evaporation of Natural-Gas Condensate Oils: Hints for the Sanchi Oil Spill

The Sanchi oil tanker collision in the East China Sea on January 6th, 2018 has caused worldwide attention due to its uniqueness. A considerable amount of highly volatile natural-gas condensate oil was spilled, burned and sank with the Sanchi tanker, this entirely new kind of maritime disaster has posed massive unknowns to the public. In this study, for better understanding of the evaporative behavior of condensate oils, two condensate oils were investigated under various laboratory conditions. The overall result demonstrates that the evaporation of condensate oils is highly dependent on the air-exposed time and the total loss of condensate oils could be more than 90% within a short time. However, a certain amount of the high-molecular weight and toxic oil contents such as phenanthrenes still highly remain in the aquatic system even after a long evaporation process, indicating their detrimental potentials to the aquatic organisms. Based on these data, for the Sanchi oil spill accident, it is assumed that although the evaporation weathering of the total condensate oil mass is probably tremendous, the long-term ecological risks of the remaining oil components in the marine environment are strongly recommended to be carefully evaluated.

Test of the Relative Permeability Curve of a Gas and Oil Condensate System and its Effect on the Recovery of Oil and Gas

The relative permeability curve has been measured with simulation oil (refined oil) and gas (nitrogen or air) at room temperature and a lowpressure, both of which are very important parameters for depicting the flow of fluid through porous media in a hydrocarbon reservoir. This basic measurement is often applied in exploitation evaluation, but the underground conditions with high temperature and pressure, and the phase equilibrium of oil and gas, are not taken into consideration when the relative permeability curve is tested. There is an important theoretical and practical sense in testing the diphase relative permeability curve of the equilibrium of oil and gas under the conditions of high temperature and pressure. The test method for the relative permeability curve is proposed in this paper. The relative permeability of the equilibrium of oil and gas and the standard one are tested in two fluids, and the differences between these two methods are stated. The research results can be applied to the simulation and prediction of CVD in long cores and then the phenomenon can better explain that the recovery of condensate gas rich in condensate oil is higher than that of CVD test in PVT. Meanwhile, the research shows that the relative permeability curve of equilibrium oil and gas is sensitive to the rate of exploitation, and the viewpoint proves that an improved gas recovery rate can properly increase the recovery of condensate oil.

MATHEMATICAL AND COMPUTER SIMULATION TECHNOLOGY OF CONDENSATE OIL AND GAS WELLS STIMULATED BY ELECTROMAGNETIC HEATING

In this article, the recent research achievements on the theory and technology of condensate oil and gas wells stimulated by electromagnetic induction heating during middle or late exploitation period were introduced for the first time at home and abroad. A new kind of electromagnetic wave induction heating equipment XAEMH-1 was developed. Taking near wellbore zone temperature field as the main research object, which is the key factor for the condensation and retrograde vaporization during electromagnetic heating, the mathematical simulation model for a condensate oil and gas well stimulated by electromagnetic heating to eliminate blockage near wellbore region was established. A corresponding computer system was developed to dynamically predict and evaluate the efficiency of this electromagnetic heating process. Through this computer system, the near wellbore region distributions of several important factors such as temperature, pressure, condensate oil saturation and relative permeability can be described quantitatively. A condensate gas well in a late exploitation period reservoir here in China was chosen as a practical example to test the effectiveness of this new technology and some satisfactory results were obtained. These results proved that it is feasible to eliminate the near wellbore region blockage by electromagnetic heating. A new prospective stimulation method was given for the condensate oil and gas reservoirs during middle or late exploitation period.

Synergistic action of erosion-corrosion on L360N in different condensate oil-contained NaCl solutions

The experiments studying on the components of pure erosion, pure corrosion and their synergism were performed in multiphase systems containing sand particles, NaCl solution and condensate oil. The influence of condensate oil content on damage degree for each component was investigated by designing four different levels (0, 5, 10 and 20 vol.%). The mechanism about erosion-corrosion was analyzed by measurements of thinning rate, electrochemical experiments, scanning electron morphology and white light interferometer. The results showed that the presence of condensate oil enhanced mechanical damage of L360N pipeline steel because of the increase in viscosity. The erosion-corrosion and pure erosion were significantly accelerated with the increase in condensate oil content. However, the condensate oil content had basically no effect on pure corrosion, and the thinning rate for it was much lower than that for pure erosion. Therefore, the pure erosion component dominated the erosion-corrosion damage in such multiphase systems.

Daily Variation of Natural Emission of Methane to the Atmosphere and Source Identification in the Luntai Fault Region of the Yakela Condensed Oil/Gas Field in the Tarim Basin,Xinjiang,China

The static flux chamber method was applied to study natural emissions of methane to the atmosphere in the Luntai fault region of Yakela Condensed Oil/Gas Field in the Tarim Basin, Xinjiang Municipality, northwestern China. Using an online method, which couples together a gas chromatography/high-temperature conversion/isotope ratio mass spectrometry （GC/C/MS）, 13^C/12^C ratios of methane in flux chambers were measured and showed that methane gases are liable to migrate from deep oil/gas reservoirs to the surface through fault regions and that a part of the migrated methane, which remains unoxidized can be emitted into the atmosphere. Methane emission rates were found to be highest in the mornings, lowest in the afternoons and then increase gradually in the evenings. Methane emission rates varied dramatically in different locations in the fault region. The highest methane emission rate was 10.96 mg/m^2·d, the lowest 4.38 mg/m^2, and the average 7.55 mg/ m^2·d. The 13^C/12^C ratios of the methane in the flux chambers became heavier as the enclosed methane concentrations increased gradually, which reveals that methane released from the fault region might come from thermogenic methane of the deep condensed oil/gas reservoir.

Geological emission of methane from the Yakela condensed oil/gas field in Talimu Basin, Xinjiang, China

A static flux chamber method was applied to study natural emissions of methane into the atmosphere in the Yakela condensed oil/gas field in Talimu Basin, Xinjiang, China. Using an online method, which couples a gas chromatography/high-temperature conversion/isotope ratio mass spectrometry (GC/C/MS) together, the 13C/12C ratios of methane in the flux chambers were measured. The results demonstrated that methane gases were liable to migrate from deep oil/gas reservoir to the surface through microseepage and p...

Topology Chemical Process Research on the Condensing and Growing Phase Multi Micro Oil Droplets Based on Hydrodynamics

The hydrodynamic research about the droplet condensing of the multi phase liquid state on the surface of the coal glass and water discusses the deepening process of convex shape curve and the formation of S shape, and puts emphasis on describing the diagram formation method of the later. In the induction period the active diagram of the micro droplet is decided by pH value forming as convex shape diagram or S shape diagram. When pH value is above 4.0, the damage of convex shape diagram cannot be recovered, in that case produce S shape activity diagram. When pH value is equal to or above 12.0, the hard surface with alkali liquid state loses adhesion, so that the micro droplet condensing of the multi phase liquid state stops completely. The research result shows that the water cleaning conditions of getting rid of the oil micro droplets can be decided by the pH value.

Formation mechanism of condensates, waxy and heavy oils in the southern margin of Junggar Basin, NW China

It is a challenge to determine the source and genetic relationship of condensate, waxy and heavy oils in one given complicated petroliferous area, where developed multiple sets of source rocks with different maturity and various chemical features.The central part of southern margin of Junggar Basin, NW China is such an example where there are condensates, light oils, normal density oils, heavy crude oils and natural gases. The formation mechanism of condensates has been seriously debated for long time;however, no study has integrated it with genetic types of waxy and heavy oils. Taking the central part of southern margin of Junggar Basin as a case, this study employs geological and geochemical methods to determine the formation mechanism of condensates,waxy and heavy oils in a complicated petroliferous area, and reveals the causes and geochemical processes of the co-occurrence of different types of crude oils in this region. Based on detailed geochemical analyses of more than 40 normal crude oils, light oils,condensates and heavy oils, it is found that the condensates are dominated by low carbon number n-alkanes and enriched in light naphthenics and aromatic hydrocarbons. Heptane values of these condensates range from 19% to 21%, isoheptane values from1.9 to 2.1, and toluene/n-heptane ratios from 1.5 to 2.0. The distribution of n-alkanes in the condensates presents a mirror image with high density waxy crude oils and heavy oils. Combined with the oil and gas-source correlations of the crude oils, condensates and natural gas, it is found that the condensates are product of evaporative fractionation and/or phase-controlled fractionation of reservoir crude oils which were derived from mature Cretaceous lacustrine source rocks in the relatively early stage. The waxy oils are the intermediate products of evaporative fractionation and/or phase-controlled fractionation of reservoir crude oils, while the heavy oils are in-situ residuals. Therefore, evaporative fractionation and/or phase-controlled fractionation would account for the formation of the condensate, light oil, waxy oil and heavy oil in the central part of southern margin of Junggar Basin, resulting in a great change of the content in terms of light alkanes, naphthenics and aromatics in condensates, followed by great uncertainties of toluene/n-heptane ratios due to migration and re-accumulation. The results suggest that the origin of the condensate cannot be simply concluded by its ratios of toluene/n-heptane and n-heptane/methylcyclohexane on the Thompson's cross-plot, it should be comprehensively determined by the aspects of geological background, thermal history of source rocks and petroleum generation,physical and chemical features of various crude oils and natural gas, vertical and lateral distribution of various crude oils in the study area.

Molten waste plastic pyrolysis in a vertical falling film reactor and the influence of temperature on the pyrolysis products

Molten plastics are characterised with high viscosity and low thermal conductivity. Applying falling film pyrolysis reactor to deal with waste plastics can not only improve heat transfer efficiency, but also solve the flow problem. In this work, the pyrolysis process of molten polypropylene （PP） in a vertical falling film reactor is experimentally studied, and the influence of heating temperature on pyrolysis products is discussed. It has been found that with the temperature increases from 550 ℃ to 625 ℃, the yield of pyrolysis oil decreases from 74.4 wt% （ 4- 2.2 wt/%） to 53.5 wt% （± 1.3 wt%）. The major compositions of the pyrolysis oil are C9, C12 and C18, and β-scission reactions are predominant. The content of the light fraction C6-C12 of pyrolysis oil is 69.7 wt%. Compared with other pyrolysis reactors, the yield ofoil from vertical falling film pyrolysis reactor is slightly higher than that from tubular reactor, equal to that from rotary kiln reactor, and slightly lower than that in medium fluidised-bed reactor.

Origin,Distribution and Geochemical Significance of Isopropyltoluene Isomers in Crude Oil

With comprehensive two-dimensional gas chromatography linked to time-of-flight mass spectrometry(GC × GC-TOFMS),ten light hydrocarbon(LH) compounds were qualitatively and quantitatively studied in light hydrocarbons(LHs) components of crude oils.For significant differences in the concentrations of 3-isoproyltoluene(3-iPT),4-isoproyltoluene(4-iPT) and 2-isoproyltoluene(2-iPT) in crude oils,and the 2-iPT probably derived mainly from similar skeleton monocyclic terpenoids via dehydrogenation and aromatization,the ratios of(3+4)-/2-iPT(iPTr),3-/2-iPT(iPTr1) and 4-/2-iPT(iPTr2) are proposed to distinguish the organic matter origin of crude oils.Relatively higher iPTr(>8.0),iPTr1(>7.0) and iPTr2(>4.0) values indicate that crude oils are sourced from the co-contribution of lower aquatic organisms,bacteria,algae,and terrestrial higher plants,whereas lower iPTr(<5.0),iPTr1(<3.0),iPTr2(<2.0) values suggest that crude oils originated from terrestrial higher plants.The iPTr,iPTr1,and iPTr2 values show notable distinction which is mainly controlled by 2-iPT concentrations,while the concentrations of 3-iPT and 4-iPT have similar distribution range in all studied oils.The 2-iPT depleted in marine oils from the Tarim Basin and lacustrine oils from the Beibuwan Basin is less than 0.30 mg/g LHs,whereas 2-iPT enriched in swamp oils from the Tarim Basin is greater than 0.50 mg/g LHs.The iPTr,iPTr1,and iPTr2 ratios and 2-iPT concentrations can be used to distinguish the organic matter origin of crude oils,especially for light oils and condensates with low concentrations of biomarkers.

Petroleum Characteristics and Controlling Factors in Lunnan Low Uplift,Tarim Basin

The Lunnan （轮南） low uplift is a complex basin that is situated in northwestern China. This area had undergone a range of tectonic events, and there are multi-production zones and reservoir types. Also, heavy oil, common black oil, volatilization oil, condensate oil and natural gas are approximately under the same stratum pressure grads and geothermal grads. The east Lunnan low uplift is mainly composed of condensate oil and natural gas, the middle part has many types of petroleum and the west part mostly has heavy oil. The petroleum geochemistry may be the principal reason for the great difference of the oil and gas characteristics. The heavy oil in the west part is established by the biodegradation and mixing effect. The mixing effect in the middle part produced the complex petroleum distribution, and the oil cracking effect and mixing effect, or air cutting effect in the east part is proof of the existence of the industrial condensate gas reservoir and waxy oil. Understanding of the complex petroleum reservoir can further supervise the development of petroleum exploration in the Lunnan low uplift.