Viscosities and densities for 1-butyl-3-methylimidazolium hexafluorophosphate ([C4mim][PF6]) and N, N-dimethylformamide (DMF) binary mixtures have been measured at the temperature range from 293.15 K to 318.15 K. ...Viscosities and densities for 1-butyl-3-methylimidazolium hexafluorophosphate ([C4mim][PF6]) and N, N-dimethylformamide (DMF) binary mixtures have been measured at the temperature range from 293.15 K to 318.15 K. It is shown that the viscosities and densities decrease monotonously with temperature and the content of DMF. Various correlation methods including Arrhenius-like equation, Sedclon et al.'s equation, Redlich-Kister equation with four parameters, and other empirical equations were applied to evaluate these experimental data. A model based on an equation of state Ior estimating the viscosity of mixtures containing ionic liquids were proposed by coupling with the excess Gibbs free energy model of viscosity, which can synchronously calculate the viscosity and the molar volume. The results show that the model gives a deviation of 8.29% for the viscosity, and a deviation of 1.05% for the molar volume when only one temperature-independent adjustable parameter is adopted. The correlation accuracy is further improved when two parameters or one temperature-dependent parameter is used.展开更多
The cyclic voltammetry, current time curve at potential step and potential time curve of galvanostatic method were used to investigate the electrochemical behavior of Er(Ⅲ) in ErCl 3 LiClO 4 DMF(N, N dimethylformamid...The cyclic voltammetry, current time curve at potential step and potential time curve of galvanostatic method were used to investigate the electrochemical behavior of Er(Ⅲ) in ErCl 3 LiClO 4 DMF(N, N dimethylformamide) system on Pt and Cu electrodes. Results indicate that the electroreducation of Er(Ⅲ) to Er(0) is irreversible on Pt and Cu electrodes, the diffusion coefficient and electron transfer coefficient of Er(Ⅲ) in 0.01 mol/L ErCl 3 0.1 mol/L LiClO 4 DMF system at 303 K are 1.96×10 -6 cm 2·s -1 and 0.081 respectively. The Er metal film was prepared by galvanostatic electrolysis on Cu electrode in ErCl 3 LiClO 4 DMF system at 40 A·m -2 (current density). The deposites composed of Er over 95%(mass fraction) were obtained.展开更多
A novel coordination polymer [(C10H16N)2(Pb2I6)·2DMF·H2O]n (C10H16N=N-butyl-2-Methy-Pyridinium) was synthesized by the reaction of Pb(NO3)2 with C6H10NI at room temperature in DMF solvent and structurally ch...A novel coordination polymer [(C10H16N)2(Pb2I6)·2DMF·H2O]n (C10H16N=N-butyl-2-Methy-Pyridinium) was synthesized by the reaction of Pb(NO3)2 with C6H10NI at room temperature in DMF solvent and structurally characterized by means of X-ray single diffraction. The title compound crystallizes in triclinic system, space group P1 with a=1.123 7(2) nm, b=1.253 30(16) nm, c=0.808 00(12) nm, 穖-3, F(000)=738, chemical formula C26H48N4O3Pb2I6 and Mr=1 640.46, ombined by static attracting forces in the crystal. DMF and H2O locate between the organic and inorganic moiety. CCDC: 210812.展开更多
A new recovery technology is developed to recycle N,N-dimethyl formamide (DMF) in waste gas from wet type polyurethane synthetic leather industry. Given that the concentration of DMF in waste gas was as low as 325.6...A new recovery technology is developed to recycle N,N-dimethyl formamide (DMF) in waste gas from wet type polyurethane synthetic leather industry. Given that the concentration of DMF in waste gas was as low as 325.6- 688.3 mg·m^-3, it was necessary to make sure two phases contact adequately and strengthen the mass transfer by increasing contact area and enhancing the turbulence. Therefore, two-stage countercurrent absorption and two-stage fog removing system were introduced into the technology. The top section of the absorption column was filled with structured wire-ripple stainless steel packing BX500, while the lower section with sting-ripple packing CB250Y. Total height of packing material was 6 m. In addition, there were both two-stage fog removing layer and high efficiency liquid distributor at the column top. All the operating parameters, including temperature, pressure, flow rate and liquid position, could be controlled by computers without manual operation, making sure the outlet gas achieved the national emission standard that the DMF concentration should be below 40 mg·m^-3. The whole equipment could recover 237.6 t of DMF each year, with the profit up to CNY 521×10^3.展开更多
A new compound [Cu(AFO)2(N3)2](DMF)(H2O)(AFO=4,5-diazafluorene-9-one)was synthesized.Its structure was determined by single X-ray diffraction.The crystal belongs to monoclinic system,space group C2/c.The cry...A new compound [Cu(AFO)2(N3)2](DMF)(H2O)(AFO=4,5-diazafluorene-9-one)was synthesized.Its structure was determined by single X-ray diffraction.The crystal belongs to monoclinic system,space group C2/c.The crystallographic data,were determined a=1.2609(2)nm,b=0.8000(1)nm,c=2.6220(4)nm,β=109.964(6)°,V=2.4859(6)nm3,Z=4,F(000)=1236,Mr=603.07,Dc=1.611 Mg/m3,μ=0.937 nm-1,R1=0.0561,and wR2=0.1290.In the crystal Cu(II) atom is coordinated with four nitrogen from two AFO ligands and two nitrogen atoms from two azide ions to form an elonged-octahedron geometry.展开更多
The isobaric vapor-liquid equilibrium data of butanone(1)-N, N-dimethylformamide (DMF)(2) at 100.92kPa, 93.32kPa, and 79.99kPa and of toluene(1)-DMF(2) at 100.92kPa were measured using a modified Rose-Williams still. ...The isobaric vapor-liquid equilibrium data of butanone(1)-N, N-dimethylformamide (DMF)(2) at 100.92kPa, 93.32kPa, and 79.99kPa and of toluene(1)-DMF(2) at 100.92kPa were measured using a modified Rose-Williams still. The above data met the thermodynamic consistency test and were correlated with the Wilson,NRTL, and UNIQUAC equations. These data can be used in the analysis and design of the process that involves separating DMF from butanone and toluene in the leather synthesis industry.展开更多
基金Supported by the National Natural Science Foundation of China (20476025, 20776040), Shanghai Municipal Science and Technology Commission of China (05DJ14002) and Hubei Key Laboratory of Novel Chemical Reactor and Green Chemical Technology of China (XLHX2007002).
文摘Viscosities and densities for 1-butyl-3-methylimidazolium hexafluorophosphate ([C4mim][PF6]) and N, N-dimethylformamide (DMF) binary mixtures have been measured at the temperature range from 293.15 K to 318.15 K. It is shown that the viscosities and densities decrease monotonously with temperature and the content of DMF. Various correlation methods including Arrhenius-like equation, Sedclon et al.'s equation, Redlich-Kister equation with four parameters, and other empirical equations were applied to evaluate these experimental data. A model based on an equation of state Ior estimating the viscosity of mixtures containing ionic liquids were proposed by coupling with the excess Gibbs free energy model of viscosity, which can synchronously calculate the viscosity and the molar volume. The results show that the model gives a deviation of 8.29% for the viscosity, and a deviation of 1.05% for the molar volume when only one temperature-independent adjustable parameter is adopted. The correlation accuracy is further improved when two parameters or one temperature-dependent parameter is used.
文摘The cyclic voltammetry, current time curve at potential step and potential time curve of galvanostatic method were used to investigate the electrochemical behavior of Er(Ⅲ) in ErCl 3 LiClO 4 DMF(N, N dimethylformamide) system on Pt and Cu electrodes. Results indicate that the electroreducation of Er(Ⅲ) to Er(0) is irreversible on Pt and Cu electrodes, the diffusion coefficient and electron transfer coefficient of Er(Ⅲ) in 0.01 mol/L ErCl 3 0.1 mol/L LiClO 4 DMF system at 303 K are 1.96×10 -6 cm 2·s -1 and 0.081 respectively. The Er metal film was prepared by galvanostatic electrolysis on Cu electrode in ErCl 3 LiClO 4 DMF system at 40 A·m -2 (current density). The deposites composed of Er over 95%(mass fraction) were obtained.
文摘A novel coordination polymer [(C10H16N)2(Pb2I6)·2DMF·H2O]n (C10H16N=N-butyl-2-Methy-Pyridinium) was synthesized by the reaction of Pb(NO3)2 with C6H10NI at room temperature in DMF solvent and structurally characterized by means of X-ray single diffraction. The title compound crystallizes in triclinic system, space group P1 with a=1.123 7(2) nm, b=1.253 30(16) nm, c=0.808 00(12) nm, 穖-3, F(000)=738, chemical formula C26H48N4O3Pb2I6 and Mr=1 640.46, ombined by static attracting forces in the crystal. DMF and H2O locate between the organic and inorganic moiety. CCDC: 210812.
基金the Science and Technology Fund of Zhejiang Province, China (2006C13072)
文摘A new recovery technology is developed to recycle N,N-dimethyl formamide (DMF) in waste gas from wet type polyurethane synthetic leather industry. Given that the concentration of DMF in waste gas was as low as 325.6- 688.3 mg·m^-3, it was necessary to make sure two phases contact adequately and strengthen the mass transfer by increasing contact area and enhancing the turbulence. Therefore, two-stage countercurrent absorption and two-stage fog removing system were introduced into the technology. The top section of the absorption column was filled with structured wire-ripple stainless steel packing BX500, while the lower section with sting-ripple packing CB250Y. Total height of packing material was 6 m. In addition, there were both two-stage fog removing layer and high efficiency liquid distributor at the column top. All the operating parameters, including temperature, pressure, flow rate and liquid position, could be controlled by computers without manual operation, making sure the outlet gas achieved the national emission standard that the DMF concentration should be below 40 mg·m^-3. The whole equipment could recover 237.6 t of DMF each year, with the profit up to CNY 521×10^3.
文摘A new compound [Cu(AFO)2(N3)2](DMF)(H2O)(AFO=4,5-diazafluorene-9-one)was synthesized.Its structure was determined by single X-ray diffraction.The crystal belongs to monoclinic system,space group C2/c.The crystallographic data,were determined a=1.2609(2)nm,b=0.8000(1)nm,c=2.6220(4)nm,β=109.964(6)°,V=2.4859(6)nm3,Z=4,F(000)=1236,Mr=603.07,Dc=1.611 Mg/m3,μ=0.937 nm-1,R1=0.0561,and wR2=0.1290.In the crystal Cu(II) atom is coordinated with four nitrogen from two AFO ligands and two nitrogen atoms from two azide ions to form an elonged-octahedron geometry.
基金Supported by the National Natural Science Foundation of China (No.20376073).
文摘The isobaric vapor-liquid equilibrium data of butanone(1)-N, N-dimethylformamide (DMF)(2) at 100.92kPa, 93.32kPa, and 79.99kPa and of toluene(1)-DMF(2) at 100.92kPa were measured using a modified Rose-Williams still. The above data met the thermodynamic consistency test and were correlated with the Wilson,NRTL, and UNIQUAC equations. These data can be used in the analysis and design of the process that involves separating DMF from butanone and toluene in the leather synthesis industry.