为高效精确模拟航空动力系统的液态燃料横向射流多尺度雾化过程,分别采用离散相模型(discrete phase model,DPM)、流体体积(volume of fluid,VOF)法耦合DPM(VOF-DPM)对横向射流雾化过程进行数值模拟,对比2种模型对横向射流雾化过程的仿...为高效精确模拟航空动力系统的液态燃料横向射流多尺度雾化过程,分别采用离散相模型(discrete phase model,DPM)、流体体积(volume of fluid,VOF)法耦合DPM(VOF-DPM)对横向射流雾化过程进行数值模拟,对比2种模型对横向射流雾化过程的仿真结果,并研究模型转换直径与破碎模型对横向射流雾化过程仿真结果的影响。仿真结果表明:相比DPM,VOF-DPM仿真得到的射流穿透深度更接近试验结果,射流雾化过程更真实,并且能够捕捉到更详细的流场信息;当模型转换直径较小时,不能转换为离散相颗粒的液滴相对较多,这些液滴仍由VOF求解,并阻挡气流导致在其周围产生小涡团;添加破碎模型对射流穿透深度和流场结构几乎没有影响,但导致离散相颗粒继续破碎成更多更小的颗粒。展开更多
The diesel particulate matter(DPM) emission from diesel powered equipment in underground mines can cause health hazards including cancer to the miners. The understanding of the DPM propagation pattern under realistic ...The diesel particulate matter(DPM) emission from diesel powered equipment in underground mines can cause health hazards including cancer to the miners. The understanding of the DPM propagation pattern under realistic mining condition is required for selecting proper DPM control strategies and to improve working practices in underground mines. In this paper, three dimensional simulations of DPM emission from the exhaust tail pipe of a load-haul-dump(LHD) vehicle and its subsequent distribution inside an isolated zone in the typical underground mine are carried out using two different solution models available in Ansys Fluent. The incoming fresh air into the isolated zone is treated as a continuous phase and DPM is treated either as a continuous phase(gas) or as a secondary discrete phase(particle). Species transport model is used when DPM is treated as gas and discrete phase model is used when DPM is assumed to behave like a particle. The distributions of DPM concentration inside the isolated zone obtained from each method are presented and compared. From the comparison results, an accurate and economical solution technique for DPM evaluation can be selected.展开更多
本文利用DPM(Dust Production Model)模型模拟计算了我国北方沙漠地区不同的土壤微团粒在不同的地表粗糙度和地表摩擦风速下的水平跃移通量、粉尘释放通量、粉尘释放效率以及在特定量中粉尘粒子的质量和数浓度的分布,并对上述计算结果...本文利用DPM(Dust Production Model)模型模拟计算了我国北方沙漠地区不同的土壤微团粒在不同的地表粗糙度和地表摩擦风速下的水平跃移通量、粉尘释放通量、粉尘释放效率以及在特定量中粉尘粒子的质量和数浓度的分布,并对上述计算结果进行了讨论和分析。通过与实际观测结果进行对比的粗糙度和地表摩擦风速下粉尘释放通量后发现二者基本一致,从而证明了DPM模型是可以用来初步模拟中国北方沙漠地区的粉尘释放过程,这将有利于进一步较准确得模拟沙尘的输送、沉降以及气候效应。展开更多
通过实验,研究了多孔介质布膜元件对水膜除尘器除尘效率的影响,讨论了进气量、用水量、气水比对除尘效率的作用效果。在此基础上,采用计算流体力学DPM模型,研究了进气量和颗粒粒径对除尘效率的影响。研究表明,在除尘实验中,采用多孔介...通过实验,研究了多孔介质布膜元件对水膜除尘器除尘效率的影响,讨论了进气量、用水量、气水比对除尘效率的作用效果。在此基础上,采用计算流体力学DPM模型,研究了进气量和颗粒粒径对除尘效率的影响。研究表明,在除尘实验中,采用多孔介质布膜元件可有效提高除尘效率,用水量越低,提高效果越明显;进气量和进水量对除尘效率具有显著的正向影响,但进气量的影响要大于进水量;不论是否存在多孔介质,除尘效率在气水比为21 m 3/kg达到最大值。模拟结果显示,在实验最大风量的条件下,对粒径94.55μm及以上的颗粒,具有100%的除尘效果;对于粒径68.58μm及以上的颗粒,能具有良好的除尘效率,数值可以在90%以上。展开更多
文摘为高效精确模拟航空动力系统的液态燃料横向射流多尺度雾化过程,分别采用离散相模型(discrete phase model,DPM)、流体体积(volume of fluid,VOF)法耦合DPM(VOF-DPM)对横向射流雾化过程进行数值模拟,对比2种模型对横向射流雾化过程的仿真结果,并研究模型转换直径与破碎模型对横向射流雾化过程仿真结果的影响。仿真结果表明:相比DPM,VOF-DPM仿真得到的射流穿透深度更接近试验结果,射流雾化过程更真实,并且能够捕捉到更详细的流场信息;当模型转换直径较小时,不能转换为离散相颗粒的液滴相对较多,这些液滴仍由VOF求解,并阻挡气流导致在其周围产生小涡团;添加破碎模型对射流穿透深度和流场结构几乎没有影响,但导致离散相颗粒继续破碎成更多更小的颗粒。
基金financial support provided by the Western US Mining Safety and Health Training&Translation Center by the National Institute for Occupational Safety and Health(NIOSH)
文摘The diesel particulate matter(DPM) emission from diesel powered equipment in underground mines can cause health hazards including cancer to the miners. The understanding of the DPM propagation pattern under realistic mining condition is required for selecting proper DPM control strategies and to improve working practices in underground mines. In this paper, three dimensional simulations of DPM emission from the exhaust tail pipe of a load-haul-dump(LHD) vehicle and its subsequent distribution inside an isolated zone in the typical underground mine are carried out using two different solution models available in Ansys Fluent. The incoming fresh air into the isolated zone is treated as a continuous phase and DPM is treated either as a continuous phase(gas) or as a secondary discrete phase(particle). Species transport model is used when DPM is treated as gas and discrete phase model is used when DPM is assumed to behave like a particle. The distributions of DPM concentration inside the isolated zone obtained from each method are presented and compared. From the comparison results, an accurate and economical solution technique for DPM evaluation can be selected.
文摘本文利用DPM(Dust Production Model)模型模拟计算了我国北方沙漠地区不同的土壤微团粒在不同的地表粗糙度和地表摩擦风速下的水平跃移通量、粉尘释放通量、粉尘释放效率以及在特定量中粉尘粒子的质量和数浓度的分布,并对上述计算结果进行了讨论和分析。通过与实际观测结果进行对比的粗糙度和地表摩擦风速下粉尘释放通量后发现二者基本一致,从而证明了DPM模型是可以用来初步模拟中国北方沙漠地区的粉尘释放过程,这将有利于进一步较准确得模拟沙尘的输送、沉降以及气候效应。
文摘通过实验,研究了多孔介质布膜元件对水膜除尘器除尘效率的影响,讨论了进气量、用水量、气水比对除尘效率的作用效果。在此基础上,采用计算流体力学DPM模型,研究了进气量和颗粒粒径对除尘效率的影响。研究表明,在除尘实验中,采用多孔介质布膜元件可有效提高除尘效率,用水量越低,提高效果越明显;进气量和进水量对除尘效率具有显著的正向影响,但进气量的影响要大于进水量;不论是否存在多孔介质,除尘效率在气水比为21 m 3/kg达到最大值。模拟结果显示,在实验最大风量的条件下,对粒径94.55μm及以上的颗粒,具有100%的除尘效果;对于粒径68.58μm及以上的颗粒,能具有良好的除尘效率,数值可以在90%以上。
