Generalized ionospheric dispersion simulation method for wideband satellite-ground-link radio systems

A generalized ionospheric dispersion simulation method is presented to verify and test wideband satellite-ground-link radio systems for dispersion robustness. In the method, ionospheric dispersive effects on wideband radio waves are modeled as an allpass nonlinear phase system, thus greatly decreasing the need for signal priori information. To accurately simulate the ionospheric dis- persion and reduce the implementation complexity, the system is decomposed into three new allpass subsystems： with a linear phase passing through zero frequency, a constant phase, and a nonlinear phase with zero-offset and quasi-parabolic form respectively. The three subsystems are implemented respectively by the combination of integer-interval delay and fractional delay filter, digital shifting phase and the complex-coefficient finite impulse response （ FIR ） filter. The ionospheric dispersion simulation can be achieved by cascading the three subsystems in a complex baseband and converting the frequency to a radio frequency. Simulation results show that the method has the ability to accu- rately simulate the ionospheric dispersion characteristics without knowing the signal priori informa- tion and has a low implementation complexity.

Computational fluid dynamics simulation of gas dispersion in complex facilities using Kit Fox field experiments:Validation and statistical evaluation

Gas release and its dispersion is a major concern in chemical industries.In order to manage and mitigate the risk of gas dispersion and its consequences,it is necessary to predict gas dispersion behavior and its concentration at various locations upon emission.Therefore,models and commercial packages such as Phast and ALOHA have been developed.Computational fluid dynamics(CFD)can be a useful tool to simulate gas dispersion in complex areas and conditions.The validation of the models requires the employment of the experimental data from filed and wind tunnel experiments.It appears that the use of the experimental data to validate the CFD method that only includes certain monitor points and not the entire domain can lead to unreliable results for the intended areas of concern.In this work,some of the trials of the Kit Fox field experiment,which provided a wide-range database for gas dispersion,were simulated by CFD.Various scenarios were considered with different mesh sizes,physical conditions,and types of release.The results of the simulations were surveyed in the whole domain.The data matching each scenario was varied by the influence of the dominant displacement force(wind or diffusivity).Furthermore,the statistical parameters suggested for the heavy gas dispersion showed a dependency on the lower band of gas concentration.Therefore,they should be used with precaution.Finally,the results and computation cost of the simulation could be affected by the chosen scenario,the location of the intended points,and the release type.

Effects of supply air temperature and inlet location on particle dispersion in displacement ventilation rooms

The effects of supply temperature and vertical location of inlet air on particle dispersion in a displacement ventilated （DV） room were numerically modeled with validation by experimental data from the literature. The results indicate that the temperature and vertical location of inlet supply air did not greatly affect the air distribution in the upper parts of a DV room, but could significantly influence the airflow pattern in the lower parts of the room, thus affecting the indoor air quality with contaminant sources located at the lower level, such as particles from working activities in an office. The numerical results also show that the inlet location would slightly influence the relative ventilation efficiency for the same air supply volume, but particle concentration in the breathing zone would be slightly lower with a low horizontal wall slot than a rectangular diffuser. Comparison of the results for two different supply temperatures in a DV room shows that, although lower supply temperature means less incoming air volume, since the indoor flow is mainly driven by buoyancy, lower supply temperature air could more efficiently remove passive sources （such as particles released from work activities in an office）. However, in the breathing zone it gives higher concentration as compared to higher supply air temperature. To obtain good indoor air quality, low supply air temperature should be avoided because concentration in the breathing zone has a stronger and more direct impact on human health.

Key emergency response technologies for abrupt air pollution accidents in China

Abrupt air pollution accidents can endanger people’s health and destroy the local ecological environment.The appropriate emergency response can minimize the harmful effects of accidents and protect people’s lives and property.This paper provides an overview of the key emergency response technologies for abrupt air pollution accidents around the globe with emphasis on the major achievements that China has obtained in recent years.With decades of effort,China has made significant progress in emergency monitoring technologies and equipment,source estimation technologies,pollutant dispersion simulation technologies and others.Many effective domestic emergency monitoring instruments(e.g.,portable DOAS/FT-IR systems,portable FID/PID systems,portable GC-MS systems,scanning imaging remote sensing systems,and emergency monitoring vehicles)had been developed which can meet the demands for routine emergency response activities.A monitoring layout technique combining air dispersion simulation,fuzzy comprehensive evaluation,and a post-optimality analysis was proposed to identify the optimal monitoring layout scheme under the constraints of limited monitoring resources.Multiple source estimation technologies,including the forward method and the inversion method,have been established and evaluated under various scenarios.Multi-scale dynamic pollution dispersion simulation systems with high temporal and spatial resolution were further developed.A comprehensive emergency response platform integrating database support,source estimation,monitoring schemes,fast monitoring of pollutants,pollution predictions and risk assessment was developed based on the technical idea of"source identification-model simulation-environmental monitoring"dynamic interactive feedback.It is expected that the emergency response capability for abrupt air pollution accidents will gradually improve in China.