HIGH TEMPERATURE DISPLACEMENT SENSOR

A high temperature displacement sensor based on the principle of eddy-current is investigated. A new temperature compensation technique by using eddy-current effect is presented to satisfy the special requirement at high temperature up to 550℃. The experiment shows that the temperature compensation technique leads to good temperature stability for the sensors. The variation of the sensitivity as well as the temperature drift of the sensor with temperature compensation technique is only about 7.4% and 90-350 mV at 550 ℃ compared with that at room temperature, and that of the sensor without temperature compensation technique is about 31.2% and 2-3 V at 550 ℃ compared with that at room temperature. A new dynamic calibration method for the eddy-current displacement sensor is presented, which is very easy to be realized especially in high frequency and at high temperatures. The high temperature displacement sensors developed are successfully used at temperature up to 550 ℃ in a magnetic bearing system for more than 100 h.

Convective Schrodinger Equation:Insights on the Potential Energy’s Role to Wave Particle Decay

In this paper, we coupled the Quantum Mechanics conventional Schrödinger’s equation, for the particles, with the Maxwell’s wave equation, in order to study the potential’s role on the conversion of the electromagnetic field energy to mass and vice versa. We show that the dissipation (“conductivity”) factor and the particle implicit proper frequency are both related to the potential energy. We have also derived a new expression for the Schrödinger’s Equation considering the potential energy into this equation not as an ad hoc term, but also as an operator (Hermitian), which has the scalar potential energy as a natural eigenvalue of this operator.

Parameters optimization and nonlinearity analysis of grating eddy current displacement sensor using neural network and genetic algorithm

A grating eddy current displacement sensor(GECDS) can be used in a watertight electronic transducer to realize long range displacement or position measurement with high accuracy in difficult industry conditions.The parameters optimization of the sensor is essential for economic and efficient production.This paper proposes a method to combine an artificial neural network(ANN) and a genetic algorithm(GA) for the sensor parameters optimization.A neural network model is developed to map the complex relationship between design parameters and the nonlinearity error of the GECDS,and then a GA is used in the optimization process to determine the design parameter values,resulting in a desired minimal nonlinearity error of about 0.11%.The calculated nonlinearity error is 0.25%.These results show that the proposed method performs well for the parameters optimization of the GECDS.

Characteristics analysis and parameters optimization for the grating eddy current displacement sensor

The grating eddy current displacement sensor (GECDS) for distance or position measurement used in watertight electronic calipers was described. The sensor relies on repetitive variation of inductance against displacement caused by the change of coupling areas between moving coils and static reflectors. The investigations focused on setting up and utilizing a computer model of the 3D eddy current fields and geometry to analyze causes of the production of measurement blind areas, and to investigate effects of the sensor parameters, such as axial gap between coils and reflectors, reflector length and reflector width on characteristics of the sensor. Simulation results indicated that the sensor has the smallest nonlinearity error of 0.15%, which agrees well with the experimental results.

Synergetic Effects of Runaway Electron and Vertical Instability on the Wall Damage on HL-2A Tokamak

1 Generation of vertical instability Tokamak experiments show that the energy confinement time and performance are better, and the larger plasma current can be achieved for non-circular cross-sectional shape of plasma than circular cross-section. However, the external magnetic fields which are used to produce the non-circular cross sectional shape also cause the confined plasma to become unstable to small vertical displacement. In general, the ratio of elongation k is larger, the possibility of instability is more. In practice, this vertical displacement mode stabilized by feedback control system or other provided external radial magnetic field to balance out the plasma motion. Under some of situations the control system may be fail due to rapid growth rate of instability exceeding the ability of controlling. The plasma will then move vertically upwards or downwards depending upon the characteristics of instability and control failure.

Theoretical foundations of triboelectric nanogenerators(TENGs)

Triboelectric nanogenerator(TENG) is an emerging powerful technology for converting ambient mechanical energy into electrical energy through the effect of triboelectricity. Starting from the expanded Maxwell’s equations, the theoretical framework of TENGs has been gradually established. Here, a review is given about its recent progress in constructing of this general theory. The fundamental mechanism of TENGs is constructed by the driving force—Maxwell’s displacement current, which is essentially different from that of electromagnetic generators. Theoretical calculations of the displacement current from a threedimensional mathematical model are presented, as well as the theoretical studies on the TENGs according to the capacitor models. Furthermore, the figure-of-merits and standards for quantifying the TENG’s output characteristics are discussed, which will provide important guidelines for optimizing the structure and performance of TENGs toward practical applications. Finally,perspectives and challenges are proposed about the basic theory of TENGs and its future technology development.

Modulation of field emission by small AC signals

In a microwave tube the energy of electrons in an electron beam, which are usually generated by a thermionic cathode, is modulated such that it is transformed into electromagnetic wave energy. In this paper, we modulated the field emission using AC signals.A field emission current with AC components was attained by adding a small AC voltage to a high extracting DC voltage. We observed two phenomena related to the AC components of the field emission current. First, when the DC component of the extracting voltage was low, the current measured in the circuit was dominated by the displacement current. Second, besides the fundamental frequency component, higher order harmonics were also observed in the field emission current.