ADSORPTION OF DYES ON ACTIVATED CARBON FIBERS

The adsorplion behavior of dyes on a variety of sisal based activated carbonfibers (SACF) has been studied in this paper The results show that this kind of ACFhas excellent adsorption capacities for some organic (dye) molecules. SACF canremove nearly all methylene blue, crystal violet, bromophenol blue and Eriochromeblue black R from water after static adsorption for 24 h. at 30℃ The adsorptionamounts can reach more than 400 mg/g when adding 50 mg SACF into 50 ml dyesolution. Under the same conditions, the absorption amounts of xylenol orangefluorescein and Eriochrome black T were lower On the other hand, the adsorptionamounts change along with the characteristics of adsorbents. The SACFs activatedabove 840 ℃ which have higher specific surface areas and wider pore radii, havehigher adsorption amounts for the dyes. The researching results also show that foeadsorption rates of dyes onto SACFs decrease by the order of methylene blue,Eriochrome blue black R and crystal violet.

Enhancement of electroluminescent properties of organic optoelectronic integrated device by doping phosphorescent dye

Organic optoelectronic integrated devices（OIDs） with ultraviolet（UV） photodetectivity and different color emitting were constructed by using a thermally activated delayed fluorescence（TADF） material 4, 5-bis（carbazol-9-yl）-1, 2-dicyanobenzene（2 CzPN） as host. The OIDs doping with typical red phosphorescent dye [tris（1-phenylisoquinoline）iridium（Ⅲ）, Ir（piq）3], orange phosphorescent dye {bis[2-（4-tertbutylphenyl）benzothiazolato-N,C-（2＇）]iridium（acetylacetonate）,（tbt）2 Ir（acac）}, and blue phosphorescent dye [bis（2, 4-di-fluorophenylpyridinato）-tetrakis（1-pyrazolyl）borate iridium（Ⅲ）, FIr6] were investigated and compared. The（tbt）2 Ir（acac）-doped orange device showed better performance than those of red and blue devices, which was ascribed to more effective energy transfer. Meanwhile, at a low dopant concentration of 3 wt.%, the（tbt）2 Ir（acac）-doped OIDs showed the maximum luminance, current efficiency, power efficiency of 70786 cd/m^2, 39.55 cd/A, and 23.92 lm/W, respectively, and a decent detectivity of 1.07 × 10^11 Jones at a bias of -2 V under the UV-350 nm illumination. This work may arouse widespread interest in constructing high efficiency and luminance OIDs based on doping phosphorescent dye.

Sonocatalytic activity of LuFeO_3 crystallites synthesized via a hydrothermal route

LuFeO3 crystallites of different sizes and morphologies were synthesized via a hydrothermal route. The sonocatalytic properties of the as-synthesized samples were investigated by degrading various organic dyes, including acid orange 7 （AOT）, rhodamine B （RhB）, methyl orange （MO）, and methylene blue （MB）, under ultrasonic irradiation, revealing that they exhibit excellent sonocatalytic activity toward the degradation of these dyes. Particularly, the synthesized bar-like particles with lengths of-3 μm and widths of-1μm have the highest sonocatalytic activity, and the degradation percentage of AO7 reaches 89% after 30 min of sonocatalysis. The effects of inorganic anions such as CI-, NO3-, SO42-, PO43-, and HCO3- on the sonocatalysis efficiency were investigated. Hydroxyl radicals （·OH） detected by fiuorimetry using terephthalic acid as a probe molecule were found to be produced over the ultrasonic-irradiated LuFeO3 particles. The addition of ethanol, which acts as a· OH scavenger, leads to quenching of ＂OH radicals and a simultaneous decrease in the dye degrada- tion. This suggests that ＂OH is the dominant active species responsible for the dye degradation.

A Facile Method for Dye and Heavy Metal Elimination by p H Sensitive Acid Activated Montmorillonite/Polyethersulfone Nanocomposite Membrane

Modified clay/polyethersulfone（PES） mixed matrix membranes（MMMs） were prepared by acid activated montmorillonite（AA-MMT） with different concentrations and used to eliminate dyes and remove heavy metals from aqueous solution. The morphology and physiochemical properties of prepared clay nanoparticles and MMMs were characterized using X-ray diffraction（XRD）, Fourier transform infrared（FTIR） spectroscopy, scanning electron microscopy（SEM）, enegy dispersive X-ray（EDX） spectroscopy, Brunauer-Emmett-Teller（BET） analysis, atomic force microscopy（AFM）, contact angle measurement and fouling studies. The filtration study showed that removal of dyes and heavy metals was strongly dependent on p H so that dyes with positive and negative charges showed different separation efficiency in acidic and alkaline conditions. The modified membranes possessed better heavy metal removal in acidic and alkaline p Hs. When the rejection of heavy metals was measured in an alkaline environment, it was observed that the rejection had a great increase compared to the neutral values for Zn^（2＋） and Ni^（2＋） ions, while rejection of Cu^（2＋） and Cd^（2＋） did not undergo significant changes. So it can be concluded that modified membranes show good selectivity for elimination of Zn^（2＋） and Ni^（2＋） ions with respect to other cations.

Electrochemical decolorization of dye wastewater by surface-activated boron-doped nanocrystalline diamond electrode

Complex organics contained in dye wastewater are difficult to degrade and often require electrochemical advanced oxidation processes（EAOPs） to treat it. Surface activation of the electrode used in such treatment is an important factor determining the success of the process.The performance of boron-doped nanocrystalline diamond（BD-NCD） film electrode for decolorization of Acid Yellow（AY-36） azo dye with respect to the surface activation by electrochemical polarization was studied. Anodic polarization found to be more suitable as electrode pretreatment compared to cathodic one. After anodic polarization, the originally H-terminated surface of BD-NCD was changed into O-terminated, making it more hydrophilic.Due to the oxidation of surface functional groups and some portion of sp2 carbon in the BD-NCD film during anodic polarization, the electrode was successfully being activated showing lower background current, wider potential window and considerably less surface activity compared to the non-polarized one. Consequently, electrooxidation（EO） capability of the anodically-polarized BD-NCD to degrade AY-36 dye was significantly enhanced, capable of nearly total decolorization and chemical oxygen demand（COD） removal even after several times of re-using. The BD-NCD film electrode favored acidic condition for the dye degradation; and the presence of chloride ion in the solution was found to be more advantageous than sulfate active species.

Efficient treatment of azo dye containing wastewater in a hybrid acidogenic bioreactor stimulated by biocatalyzed electrolysis

In this study, a novel scaled-up hybrid acidogenic bioreactor（HAB） was designed and adopted to evaluate the performance of azo dye（acid red G, ARG） containing wastewater treatment. Principally, HAB is an acidogenic bioreactor coupled with a biocatalyzed electrolysis module. The effects of hydraulic retention time（HRT） and ARG loading rate on the performance of HAB were investigated. In addition, the influent was switched from synthetic wastewater to domestic wastewater to examine the key parameters for the application of HAB. The results showed that the introduction of the biocatalyzed electrolysis module could enhance anoxic decolorization and COD（chemical oxygen demand） removal. The combined process of HAB-CASS presented superior performance compared to a control system without biocatalyzed electrolysis（AB-CASS）. When the influent was switched to domestic wastewater, with an environment having more balanced nutrients and diverse organic matters, the ARG, COD and nitrogen removal efficiencies of HAB-CASS were further improved, reaching 73.3% ± 2.5%, 86.2% ± 3.8% and 93.5% ± 1.6% at HRT of 6 hr, respectively, which were much higher than those of AB-CASS（61.1% ± 4.7%,75.4% ± 5.0% and 82.1% ± 2.1%, respectively）. Moreover, larger TCV/TV（total cathode volume/total volume） for HAB led to higher current and ARG removal. The ARG removal efficiency and current at TCV/TV of 0.15 were 39.2% ± 3.7% and 28.30 ± 1.48 mA,respectively. They were significantly increased to 62.1% ± 2.0% and 34.55 ± 0.83 mA at TCV/TV of 0.25. These results show that HAB system could be used to effectively treat real wastewater.