The purpose of this study was to prepare high-quality Al-Si-Mg-Mn alloy with a good combination of strength and ductility employing the vacuum-assisted high-pressure die cast process. An orthogonal study of heat treat...The purpose of this study was to prepare high-quality Al-Si-Mg-Mn alloy with a good combination of strength and ductility employing the vacuum-assisted high-pressure die cast process. An orthogonal study of heat treatments was conducted to design an optimized T6 heat treatment process for both Al-10%Si-0.3%Mg-Mn and Al-11%Si-0.6%Mg-Mn alloys. The results demonstrate that no obvious blisters and warpage were observed in these two alloys with solid solution treatment. After the optimal T6 heat treatment of 530°C×3 h + 165°C×6 h, Al-11%Si-0.6%Mg-Mn alloy has better mechanical properties, of which tensile strength, yield strength and elongation reached 377.3 MPa, 307.8 MPa and 9%, respectively. The improvement of mechanical properties can be attributed to the high density of needle-like β″(Mg_5Si_6) precipitation after aging treatment and the fine and spherical eutectic Si particles uniformly distributed in the α-Al matrix.展开更多
The striations on the surface of 3Cr2W8V die steel were processed by laser. The microstructure, hardness, wear resistance and thermal fatigue behavior of the specimens processed by laser were measured. The appearance ...The striations on the surface of 3Cr2W8V die steel were processed by laser. The microstructure, hardness, wear resistance and thermal fatigue behavior of the specimens processed by laser were measured. The appearance and mechanism of thermal fatigue crack propagation in the zone processed by laser were observed and discussed. The results show that the wear resistance and thermal fatigue resistance of materials processed by laser are all better than those of the unprocessed material. The processed zone by laser plays a role in baffling wearing process and crack propagation. The pile-nail effect of processed zone is the main factor for improving the wear resistance and thermal fatigue resistance of material.展开更多
基金financially supported by the Jiangsu province transformation of scientific and technological achievements program(BA2015041)the Jiangsu key laboratory for advanced metallic materials(BM2007204)
文摘The purpose of this study was to prepare high-quality Al-Si-Mg-Mn alloy with a good combination of strength and ductility employing the vacuum-assisted high-pressure die cast process. An orthogonal study of heat treatments was conducted to design an optimized T6 heat treatment process for both Al-10%Si-0.3%Mg-Mn and Al-11%Si-0.6%Mg-Mn alloys. The results demonstrate that no obvious blisters and warpage were observed in these two alloys with solid solution treatment. After the optimal T6 heat treatment of 530°C×3 h + 165°C×6 h, Al-11%Si-0.6%Mg-Mn alloy has better mechanical properties, of which tensile strength, yield strength and elongation reached 377.3 MPa, 307.8 MPa and 9%, respectively. The improvement of mechanical properties can be attributed to the high density of needle-like β″(Mg_5Si_6) precipitation after aging treatment and the fine and spherical eutectic Si particles uniformly distributed in the α-Al matrix.
基金Item Sponsored by National Natural Science Foundation of China (50635030)
文摘The striations on the surface of 3Cr2W8V die steel were processed by laser. The microstructure, hardness, wear resistance and thermal fatigue behavior of the specimens processed by laser were measured. The appearance and mechanism of thermal fatigue crack propagation in the zone processed by laser were observed and discussed. The results show that the wear resistance and thermal fatigue resistance of materials processed by laser are all better than those of the unprocessed material. The processed zone by laser plays a role in baffling wearing process and crack propagation. The pile-nail effect of processed zone is the main factor for improving the wear resistance and thermal fatigue resistance of material.
