It was shown observationally that there existed a close relation between flare occur-rence and filament motion at the same time. Van Tend and Kuperus andmany authors afterwards studied theoretically the physical relat...It was shown observationally that there existed a close relation between flare occur-rence and filament motion at the same time. Van Tend and Kuperus andmany authors afterwards studied theoretically the physical relationship between flare processand the evolution and motion of the filament current in active regions. However, due tothe difficulty in obtaining observational material of high quality and the complexity展开更多
Characteristics and evolution of the Kuroshio frontal eddies and warm filaments are analyzed according to two series of satellite images (March 5 to 7, 1986 and April 14 to 16, 1988). The results show that the frontal...Characteristics and evolution of the Kuroshio frontal eddies and warm filaments are analyzed according to two series of satellite images (March 5 to 7, 1986 and April 14 to 16, 1988). The results show that the frontal eddies in the East China Sea are generated at the shelf break and move along the continental slope at a speed of 15 cm/s with the Kuroshio. The frontal eddies occur about every 10 d and evolve to be warm filaments a few hundred km in length and 30-40 km in width in the area west of the Yaku-shima. Meanwhile, the existence of the warm filament was also found in the area by analysing the hydrographic data in the area west of Kyushu during May 24-June 5, 1988.The Kuroshio warm filaments move westward opposite to the Kuroshio and then turn northward at the shelf break and become the main source of the warm water of the Tsushima Warm Current. A simple dynamic explanation for the process is presented in this paper.展开更多
为了进一步提高电子束流发生系统工作的可靠性和稳定性,提高电子束加工质量,采用AC-DC-AC-DC-AC-DC的拓扑电路、新型功率变压器、高压脉冲检测技术、优化的束流反馈控制与灯丝加热电流闭环反馈控制技术等,分别优化了高压加速电源、偏压...为了进一步提高电子束流发生系统工作的可靠性和稳定性,提高电子束加工质量,采用AC-DC-AC-DC-AC-DC的拓扑电路、新型功率变压器、高压脉冲检测技术、优化的束流反馈控制与灯丝加热电流闭环反馈控制技术等,分别优化了高压加速电源、偏压电源与灯丝加热电源。将所研制逆变电源与150 k V/30 k W电子枪、真空系统等组成了一套电子束流发生系统,测试了该电子束流发生系统输出的高压、最大束流以及灯丝加热电流、偏压变化对束流输出的影响。试验结果表明:经过优化的逆变电源高压输出达到-150 k V,高压输出线性度较好,最大束流达到200 m A;高压、灯丝加热电流给定时,随着偏压降低,束流输出逐渐增大;高压、偏压给定时,随着灯丝加热电流增大,束流输出存在死区、线性增大区和恒流区。展开更多
基金Project supported by the National Natural Science Foundation of China.
文摘It was shown observationally that there existed a close relation between flare occur-rence and filament motion at the same time. Van Tend and Kuperus andmany authors afterwards studied theoretically the physical relationship between flare processand the evolution and motion of the filament current in active regions. However, due tothe difficulty in obtaining observational material of high quality and the complexity
文摘Characteristics and evolution of the Kuroshio frontal eddies and warm filaments are analyzed according to two series of satellite images (March 5 to 7, 1986 and April 14 to 16, 1988). The results show that the frontal eddies in the East China Sea are generated at the shelf break and move along the continental slope at a speed of 15 cm/s with the Kuroshio. The frontal eddies occur about every 10 d and evolve to be warm filaments a few hundred km in length and 30-40 km in width in the area west of the Yaku-shima. Meanwhile, the existence of the warm filament was also found in the area by analysing the hydrographic data in the area west of Kyushu during May 24-June 5, 1988.The Kuroshio warm filaments move westward opposite to the Kuroshio and then turn northward at the shelf break and become the main source of the warm water of the Tsushima Warm Current. A simple dynamic explanation for the process is presented in this paper.
文摘为了进一步提高电子束流发生系统工作的可靠性和稳定性,提高电子束加工质量,采用AC-DC-AC-DC-AC-DC的拓扑电路、新型功率变压器、高压脉冲检测技术、优化的束流反馈控制与灯丝加热电流闭环反馈控制技术等,分别优化了高压加速电源、偏压电源与灯丝加热电源。将所研制逆变电源与150 k V/30 k W电子枪、真空系统等组成了一套电子束流发生系统,测试了该电子束流发生系统输出的高压、最大束流以及灯丝加热电流、偏压变化对束流输出的影响。试验结果表明:经过优化的逆变电源高压输出达到-150 k V,高压输出线性度较好,最大束流达到200 m A;高压、灯丝加热电流给定时,随着偏压降低,束流输出逐渐增大;高压、偏压给定时,随着灯丝加热电流增大,束流输出存在死区、线性增大区和恒流区。
