Evaluation of the cement bond quality through filtering the reflected ultrasonic waves

High cement bond quality is required to keep an oil well from hydraulic commu- nication between zones. In the cement bond evaluation, the ultrasonic echo method is widely used for its capability of channeling azimuth detection. Full waveforms reflected from the cased hole are simulated for different bonding conditions by the generalized transfer matrix method. Because of the high acoustic impedance of casing, the amplitudes of the reflected waves from the cement and the formation are small and cannot easily be used to evaluate the cementing condition. The wave that can propagate into the cement and the formation through the casing concentrates closely on the casing resonant frequency. To reduce the amplitude of the reflected wave from the casing inner surface and highlight the part of the reflected wave which carries the cementing quality information, the reflected full wave is filtered according to the casing resonant frequency. There are several wave packets in the filtered waveform. When the amplitude of the second wave packet is low, the cement bonds well with the casing, otherwise poorly. A low amplitude third wave packet is an indication of a good bond of the cement with the formation, otherwise poor. To reveal the sensitivity of the reflection wave amplitudes to the incident angle, reflected full waveform is modeled when an acoustic beam with finite width is incident on the casing. It is shown that the bond evaluation method based on filtered wave packets is valid for incident angle less than 5 degrees.

A novel control scheme for simultaneous elimination of imbalance, disturbance and voltage harmonic in power systems

In recent years, the increasing application of nonlinear and unbalanced electronic equipment and large single phase loads have made voltage imbalance a serious problem in power distribution systems. A novel approach has been proposed to eliminate voltage imbalance and disturbances. The main strategy of this scheme is based on series active filter. By improving control circuit toward existing schemes and proposing a new strategy to control the voltage amplitude, simultaneous elimination of voltage imbalance, faults, voltage harmonics and also compensation of voltage drop in transmission lines become possible. Eventually, the voltage on the load side is a perfectly balanced three phase voltage with specific proper amplitude. The proposed scheme has been simulated in a test network and the results show high capability of this scheme for the complete elimination of imbalance without phase shift.

Performanceanalysisofalowpowerlownoisetunablebandpassfilterformultiband RF front end

This paper presents a low power tunable active inductor and RF band pass filter suitable for multiband RF front end circuits. The active inductor circuit uses the PMOS cascode structure as the negative transconductor of a gyrator to reduce the noise voltage. Also, this structure provides possible negative resistance to reduce the inductor loss with wide inductive bandwidth and high resonance frequency. The RF band pass filter is realized using the proposed active inductor with suitable input and output buffer stages. The tuning of the center frequency for multiband operation is achieved through the controllable current source. The designed active inductor and RF band pass filter are simulated in 180 nm and 45 nm CMOS process using the Synopsys HSPICE simulation tool and their performances are compared. The parameters, such as resonance frequency, tuning capability, noise and power dissipation, are analyzed for these CMOS technologies and discussed. The design of a third order band pass filter using an active inductor is also presented.