Applicability of regional P/S amplitude ratios for the discrimination of low-magnitude seismic events was tested and proved using earthquakes and explosions in Central Asia. Results obtained show that regional P/S amp...Applicability of regional P/S amplitude ratios for the discrimination of low-magnitude seismic events was tested and proved using earthquakes and explosions in Central Asia. Results obtained show that regional P/S amplitude ratios which may discriminate medium or large magnitude events well, are also applicable to low magnitude events Their performances for low magnitude events are almost as good as that for medium or large events. Statistical comparisons based on 25 P/S discriminate from the four seismic stations WMQ, BLK, MUL and MAK showed that the average misclassification rate for low-magnitude seismic events averagely was only 2 percent higher than that for medium and large magnitude seismic events.展开更多
Cataracts are the leading cause of blindness worldwide. Current methods for discriminating cataractous lenses from healthy lenses of Sprague-Dawley rats during preclinical studies are based on either histopathological...Cataracts are the leading cause of blindness worldwide. Current methods for discriminating cataractous lenses from healthy lenses of Sprague-Dawley rats during preclinical studies are based on either histopathological or clinical assessments which are weakened by subjectivity. In this work, both cataractous and healthy lens tissues of Sprague-Dawley rats were studied using multispectral imaging technique in combination with multivariate analysis. Multispectral images were captured in transmission, reflection and scattering modes. In all, five spectral bands were found to be markers for discriminating cataractous lenses from healthy lenses;470 nm and 625 nm discriminated in reflection mode whereas 435 nm, 590 nm and 700 nm discriminated in transmission mode. With Fisher’s Linear discriminant analysis, the midpoints for classifying cataractous from healthy lenses were found to be 14.718 × 10−14 and 3.2374 × 10−14 for the two spectra bands in the reflection mode and the three spectral bands in the transmission mode respectively. Images in scattering mode did not show significant discrimination. These spectral bands in reflection and transmission modes may offer potential diagnostic markers for discriminating cataractous lenses from healthy lenses thereby promising multispectral imaging applications for characterizing cataractous and healthy lenses.展开更多
In order to apply the performance-based seismic design, an engineer must first find out whether the column is expected to fail in shear before or after flexural yielding. According to column failure characteristics an...In order to apply the performance-based seismic design, an engineer must first find out whether the column is expected to fail in shear before or after flexural yielding. According to column failure characteristics and failure mode of reinforced concrete column, the UW-PEER structure performance database was discussed and analyzed. In order to investigate the relevance of failure mode and factors such as longitudinal reinforcement ratio, transverse reinforcement ratio, hoop spacing to depth ratio, aspect ratio, shearing resistance demand to shear capacity ratio and axial load ratio, Fisher's discriminant analysis(FDA) of the above factors was carried out. A discriminant function was developed to identify column failure mode. Results show that three factors, i.e., Vp /Vn, hoop spacing to depth ratio and aspect ratio have important influence on the failure mode. The failure mode has less to do with longitudinal reinforcement ratio, transverse reinforcement ratio and axial load ratio. Through using these three factors and the model proposed, over 85.6% of the original grouped cases were correctly classified. The value of coefficient of Vp /Vn is the largest, which means that discriminant equation is most sensitive to the shearing resistance demand to shear capacity ratio.展开更多
Correction maps of P/S amplitude ratios for seismic events distributed in Xinjiang, China and its adjacent areas were established using a Bayesian Kriging method for the two seismic stations WMQ and MAK. The relations...Correction maps of P/S amplitude ratios for seismic events distributed in Xinjiang, China and its adjacent areas were established using a Bayesian Kriging method for the two seismic stations WMQ and MAK. The relationship between correction maps and variations of along-path features was analyzed and the validity of applying the correction maps to improve performances of P/S discriminants for seismic discrimination was investigated. Results show that obtained correction maps can generally reflect event-station path effects upon corresponding P/S discriminants; and the correction of these effects could further reduce scatters of distance-corrected P/S measurements within earthquake and explosion populations as well as improve their discriminating performances if path effects are a significant factor of such scatters. For example, as corresponding Kriging correction map was applied, the misidentification rate of earthquakes by Pn（2-4 Hz）/Lg（2-4 Hz） at MAK was reduced from 16.3% to 5.2%.展开更多
Feature reduction is a key process in pattern recognition. This paper deals with the feature reduction methods for a time-shift invariant feature, power spectrum, in Radar Automatic Target Recognition (RATR) using Hig...Feature reduction is a key process in pattern recognition. This paper deals with the feature reduction methods for a time-shift invariant feature, power spectrum, in Radar Automatic Target Recognition (RATR) using High-Resolution Range Profiles (HRRPs). Several existing feature reduction methods in pattern recognition are analyzed, and a weighted feature reduction method based on Fisher's Discriminant Ratio (FDR) is proposed in this paper. According to the characteristics of radar HRRP target recognition, this proposed method searches the optimal weight vector for power spectra of HRRPs by means of an iterative algorithm, and thus reduces feature dimensionality. Compared with the method of using raw power spectra and some existing feature reduction methods, the weighted feature reduction method can not only reduce feature dimensionality, but also improve recognition performance with low computation complexity. In the recognition experiments based on measured data, the proposed method is robust to different test data and achieves good recognition results.展开更多
Analysis of arterial pulse waveforms is important for non-invasive diagnosis of cardiovascular functions. Large samples of IPG signal records of radial arterial pulse show presence of eight different types of shapes (...Analysis of arterial pulse waveforms is important for non-invasive diagnosis of cardiovascular functions. Large samples of IPG signal records of radial arterial pulse show presence of eight different types of shapes (morphological patterns) in the pulse waveforms. In this paper we present an efficient computational method for automatic identification of these morphological patterns. Our algorithm uses likelihood ratio of cumulative periodogram of pulse signals and some geometrical criteria. The algorithm is presented with necessary details on signal processing aspects. Results for a large sample of pulse records of adult Indian subjects show high accuracy of our algorithm in detecting pulse-morphology patterns. Variation of pulse-morphology with respect to time is also analyzed using this algorithm. We have identified some characteristic features of pulse-morphology variation in patients of certain cardiac problems, hypertension, and diabetes. These are found relevant and significant in terms of physiological interpretation of the associated shapes of pulse waveforms. Importance of these findings is highlighted along with discussion on overall scope of our study in automatic analysis of heart rate variability and in other applications for non-invasive prognosis/diagnosis.展开更多
Fisher [1] proposed a simple method to combine p-values from independent investigations without using detailed information of the original data. In recent years, likelihood-based asymptotic methods have been developed...Fisher [1] proposed a simple method to combine p-values from independent investigations without using detailed information of the original data. In recent years, likelihood-based asymptotic methods have been developed to produce highly accurate p-values. These likelihood-based methods generally required the likelihood function and the standardized maximum likelihood estimates departure calculated in the canonical parameter scale. In this paper, a method is proposed to obtain a p-value by combining the likelihood functions and the standardized maximum likelihood estimates departure of independent investigations for testing a scalar parameter of interest. Examples are presented to illustrate the application of the proposed method and simulation studies are performed to compare the accuracy of the proposed method with Fisher’s method.展开更多
基金Foundation of Verification Researches for Army Control Technology (513310101).
文摘Applicability of regional P/S amplitude ratios for the discrimination of low-magnitude seismic events was tested and proved using earthquakes and explosions in Central Asia. Results obtained show that regional P/S amplitude ratios which may discriminate medium or large magnitude events well, are also applicable to low magnitude events Their performances for low magnitude events are almost as good as that for medium or large events. Statistical comparisons based on 25 P/S discriminate from the four seismic stations WMQ, BLK, MUL and MAK showed that the average misclassification rate for low-magnitude seismic events averagely was only 2 percent higher than that for medium and large magnitude seismic events.
文摘Cataracts are the leading cause of blindness worldwide. Current methods for discriminating cataractous lenses from healthy lenses of Sprague-Dawley rats during preclinical studies are based on either histopathological or clinical assessments which are weakened by subjectivity. In this work, both cataractous and healthy lens tissues of Sprague-Dawley rats were studied using multispectral imaging technique in combination with multivariate analysis. Multispectral images were captured in transmission, reflection and scattering modes. In all, five spectral bands were found to be markers for discriminating cataractous lenses from healthy lenses;470 nm and 625 nm discriminated in reflection mode whereas 435 nm, 590 nm and 700 nm discriminated in transmission mode. With Fisher’s Linear discriminant analysis, the midpoints for classifying cataractous from healthy lenses were found to be 14.718 × 10−14 and 3.2374 × 10−14 for the two spectra bands in the reflection mode and the three spectral bands in the transmission mode respectively. Images in scattering mode did not show significant discrimination. These spectral bands in reflection and transmission modes may offer potential diagnostic markers for discriminating cataractous lenses from healthy lenses thereby promising multispectral imaging applications for characterizing cataractous and healthy lenses.
基金Project(2011ZA05) supported by the State Key Laboratory’s Autonomous Project of Subtropical Building Science in South China University of Technology
文摘In order to apply the performance-based seismic design, an engineer must first find out whether the column is expected to fail in shear before or after flexural yielding. According to column failure characteristics and failure mode of reinforced concrete column, the UW-PEER structure performance database was discussed and analyzed. In order to investigate the relevance of failure mode and factors such as longitudinal reinforcement ratio, transverse reinforcement ratio, hoop spacing to depth ratio, aspect ratio, shearing resistance demand to shear capacity ratio and axial load ratio, Fisher's discriminant analysis(FDA) of the above factors was carried out. A discriminant function was developed to identify column failure mode. Results show that three factors, i.e., Vp /Vn, hoop spacing to depth ratio and aspect ratio have important influence on the failure mode. The failure mode has less to do with longitudinal reinforcement ratio, transverse reinforcement ratio and axial load ratio. Through using these three factors and the model proposed, over 85.6% of the original grouped cases were correctly classified. The value of coefficient of Vp /Vn is the largest, which means that discriminant equation is most sensitive to the shearing resistance demand to shear capacity ratio.
基金Foundation of Verification Researches for Army Control Technology (513310101).
文摘Correction maps of P/S amplitude ratios for seismic events distributed in Xinjiang, China and its adjacent areas were established using a Bayesian Kriging method for the two seismic stations WMQ and MAK. The relationship between correction maps and variations of along-path features was analyzed and the validity of applying the correction maps to improve performances of P/S discriminants for seismic discrimination was investigated. Results show that obtained correction maps can generally reflect event-station path effects upon corresponding P/S discriminants; and the correction of these effects could further reduce scatters of distance-corrected P/S measurements within earthquake and explosion populations as well as improve their discriminating performances if path effects are a significant factor of such scatters. For example, as corresponding Kriging correction map was applied, the misidentification rate of earthquakes by Pn（2-4 Hz）/Lg（2-4 Hz） at MAK was reduced from 16.3% to 5.2%.
基金Partially supported by the National Natural Science Foundation of China (No.60302009)the National Defense Advanced Research Foundation of China (No.413070501).
文摘Feature reduction is a key process in pattern recognition. This paper deals with the feature reduction methods for a time-shift invariant feature, power spectrum, in Radar Automatic Target Recognition (RATR) using High-Resolution Range Profiles (HRRPs). Several existing feature reduction methods in pattern recognition are analyzed, and a weighted feature reduction method based on Fisher's Discriminant Ratio (FDR) is proposed in this paper. According to the characteristics of radar HRRP target recognition, this proposed method searches the optimal weight vector for power spectra of HRRPs by means of an iterative algorithm, and thus reduces feature dimensionality. Compared with the method of using raw power spectra and some existing feature reduction methods, the weighted feature reduction method can not only reduce feature dimensionality, but also improve recognition performance with low computation complexity. In the recognition experiments based on measured data, the proposed method is robust to different test data and achieves good recognition results.
文摘Analysis of arterial pulse waveforms is important for non-invasive diagnosis of cardiovascular functions. Large samples of IPG signal records of radial arterial pulse show presence of eight different types of shapes (morphological patterns) in the pulse waveforms. In this paper we present an efficient computational method for automatic identification of these morphological patterns. Our algorithm uses likelihood ratio of cumulative periodogram of pulse signals and some geometrical criteria. The algorithm is presented with necessary details on signal processing aspects. Results for a large sample of pulse records of adult Indian subjects show high accuracy of our algorithm in detecting pulse-morphology patterns. Variation of pulse-morphology with respect to time is also analyzed using this algorithm. We have identified some characteristic features of pulse-morphology variation in patients of certain cardiac problems, hypertension, and diabetes. These are found relevant and significant in terms of physiological interpretation of the associated shapes of pulse waveforms. Importance of these findings is highlighted along with discussion on overall scope of our study in automatic analysis of heart rate variability and in other applications for non-invasive prognosis/diagnosis.
文摘Fisher [1] proposed a simple method to combine p-values from independent investigations without using detailed information of the original data. In recent years, likelihood-based asymptotic methods have been developed to produce highly accurate p-values. These likelihood-based methods generally required the likelihood function and the standardized maximum likelihood estimates departure calculated in the canonical parameter scale. In this paper, a method is proposed to obtain a p-value by combining the likelihood functions and the standardized maximum likelihood estimates departure of independent investigations for testing a scalar parameter of interest. Examples are presented to illustrate the application of the proposed method and simulation studies are performed to compare the accuracy of the proposed method with Fisher’s method.
