Effect of stimulated Brillouin scattering on the gain saturation of distributed fiber Raman amplifier and its suppression by phase modulation

For distributed fiber Raman amplifiers（DFRAs）, stimulated Brillouin scattering（SBS） can deplete the pump once occurring and consequently generate gain saturation. On the basis of such a theory, theoretical gain saturation powers in DFRAs with various pump schemes are obtained by calculating SBS thresholds in them, and the experimental results show that they are in excellent agreement with the calculation results. The saturation power of the DFRA with a 300 m W forward pump is as low as 0 d Bm, which needs to be enhanced by phase modulation, and the effect is quantitatively studied. A simple model taking both modulation frequency and index into consideration is presented by introducing a correction factor to evaluate the effect of phase modulation on the enhancement of saturation power. Experimentally, it is shown that such a correction factor decreases as the modulation frequency increases and approaches zero when the modulation frequency becomes high enough. In particular, a phase modulation with a modulation frequency of 100 MHz and a modulation index of 1.380 can enhance the saturation power by 4.44 d B, and the correction factor is 0.25 d B, in which the modulation frequency is high enough. Additionally, the factor is 1.767 d B for the modulation frequency of 25 MHz. On this basis,phase modulations with various indexes and a fixed frequency of 25 MHz are adopted to verify the modified model, and the results are positive. To obtain the highest gain saturation power, the model is referable. The research results provide a guide for the design of practical DFRAs.

Topological laser on square lattice with gain–loss-induced higher-order corner modes

We investigate the higher-order topological laser in the two-dimensional(2D) coupled-cavity array. By adding staggered on-site gain and loss to the 2D Hermitian array with a trivial phase, the system will emerge degenerate topological corner modes, which are protected by bulk band gap. For such a non-Hermitian model, by adjusting the parameters of the system and introducing the pumping into the cavity at the corner, a single-mode lasing with topological protection emerges.Furthermore, single-mode lasing exists over a wide range of pumping strengths. No matter where the cavity is initially stimulated, after enough time evolution, all the cavities belonging to the topological corner mode can emit a stable laser.

Wavelength-Dependent Transient Characteristics Caused by Gain Saturation in Highly Nonlinear Fiber-Based Raman Amplifiers

We have investigated the transient characteristics of discrete Raman Amplifiers and found that the response time caused by gain saturation is dependent upon the wavelength, which corresponds to the effective length of the pump light.

Pressure Dependence of the Small-Signal Gain and Saturation Intensity of a Copper Bromide Laser

A pair of copper bromide lasers in an oscillator–amplifier configuration is used to investigate the small signal gain and saturation intensity as amplifying parameters and output power of lasers, versus pressure of buffer gas. It is shown that the amplifying parameters and laser output power have a maximum value at optimum buffer gas pressure of 11？Torr. The challenge between microscopic parameters such as stimulated emission cross section, laser upper level lifetime, and population inversion, which determine the values of laser characteristics respective to the operational pressure of buffer gas, are investigated. Thus an optimum delay time of about 10？ns is determined, and a maximum output power equivalent to about 12？W is extracted. The amplifying parameters and measured output power of laser versus delay times show some local maxima and minima at the delay time interval of 6–43？ns.

Numerical study of spatial chirp distortion in quasi-parametric chirped-pulse amplification

Optical parametric chirped-pulse amplification is inevitably subject to high-order spatial chirp,particularly under the condition of saturated amplification and a Gaussian pump;this corresponds to an irreversible spatiotemporal distortion and consequently degrades the maximum attainable focused intensity.In this paper,we reveal that such spatial chirp distortion can be significantly mitigated in quasi-parametric chirped-pulse amplification(QPCPA)with idler absorption.Simulation results show that the quality of focused intensity in saturated QPCPA is nearly ideal,with a spatiotemporal Strehl ratio higher than 0.98.As the seed bandwidth increases,the idler absorption spectrum may not be uniform,but the Strehl ratio in QPCPA can be still high enough due to stronger idler absorption.