The Hoek-Brown （HB） strength criterion has been widely applied to the estimation of strength of intact rock and rock mass, while evolving ever since. However, negligence of the effect of the intermediate principal s...The Hoek-Brown （HB） strength criterion has been widely applied to the estimation of strength of intact rock and rock mass, while evolving ever since. However, negligence of the effect of the intermediate principal stress still remains in the criterion＇s latest version. At the same time, several three-dimensional （3D） HB strength, which can takes into account the influence of the intermediate principal stress, have already been proposed, among which the 3D HB criterion proposed by Zhang and Zhu seems to be the most reasonable one. However, the Zhang 3D HB criterion may have problems with some stress path close to triaxial extension state because of the non-convexity characteristic of its failure surface. In this paper, a new 3D HB strength criterion is presented based on a generalized form of the HB criterion, which also considers the effect of the intermediate principal stress and inherits all the merits of the original version of the HB criterion. In addition, this new criterion can remedy to some extent the shortcomings observed in the Zhang 3D HB criterion. Polyaxial tests for five different rocks from pub- lished literatures are used for evaluating this new criterion and comparing it with the Zhang 3D HB criterion. The re- sults show that this new criterion may over-predict or under- predict the polyaxial strength of rocks but the errors are rela- tively small, and similar results are also found for the Zhang 3D HB criterion, which one is better depends on the type of the rock under estimation.展开更多
Hoek–Brown(HB)strength criterion can reflect rock’s inherent failure nature,so it is more suitable for analyzing the stability of rock slopes.However,the traditional limit equilibrium methods are at present only sui...Hoek–Brown(HB)strength criterion can reflect rock’s inherent failure nature,so it is more suitable for analyzing the stability of rock slopes.However,the traditional limit equilibrium methods are at present only suitable for analyzing the rock slope stability using the linear equivalent Mohr–Coulomb(EMC)strength parameters instead of the nonlinear HB strength criterion.Therefore,a new method derived to analyze directly the rock slope stability using the nonlinear HB strength criterion for arbitrary curve slip surface was described in the limit equilibrium framework.The current method was established based on certain assumptions concerning the stresses on the slip surface through amending the initial normal stressσ0 obtained without considering the effect of inter-slice forces,and it can satisfy all static equilibrium conditions of the sliding body,so the current method can obtain the reasonable and strict factor of safety(FOS)solutions.Compared with the results of other methods in some examples,the feasibility of the current method was verified.Meanwhile,the parametric analysis shows that the slope angleβhas an important influence on the difference of the results obtained using the nonlinear HB strength criterion and its linear EMC strength parameters.Forβ≤45°,both of the results are similar,showing the traditional limit equilibrium methods using the linear EMC strength parameters and the current method are all suitable to analyze rock slope stability,but forβ>60°,the differences of both the results are obvious,showing the actual slope stability state can not be reflected in the traditional limit equilibrium methods,and then the current method should be used.展开更多
The HoekeBrown criterion was introduced in 1980 to provide input for the design of underground excavations in rock.The criterion now incorporates both intact rock and discontinuities,such as joints,characterized by th...The HoekeBrown criterion was introduced in 1980 to provide input for the design of underground excavations in rock.The criterion now incorporates both intact rock and discontinuities,such as joints,characterized by the geological strength index(GSI),into a system designed to estimate the mechanical behaviour of typical rock masses encountered in tunnels,slopes and foundations.The strength and deformation properties of intact rock,derived from laboratory tests,are reduced based on the properties of discontinuities in the rock mass.The nonlinear HoekeBrown criterion for rock masses is widely accepted and has been applied in many projects around the world.While,in general,it has been found to provide satisfactory estimates,there are several questions on the limits of its applicability and on the inaccuracies related to the quality of the input data.This paper introduces relatively few fundamental changes,but it does discuss many of the issues of utilization and presents case histories to demonstrate practical applications of the criterion and the GSI system.展开更多
The triaxial strength of twenty rockmass types was predicted using two non-linear triaxial strength criteria for rockmass i.e. Modified Mohr-Coulomb(MMC) criterion and Generalized Hoek-Brown(GHB)criterion. Four differ...The triaxial strength of twenty rockmass types was predicted using two non-linear triaxial strength criteria for rockmass i.e. Modified Mohr-Coulomb(MMC) criterion and Generalized Hoek-Brown(GHB)criterion. Four different rockmass classification systems were used for the calculation of MMC criterion parameters while only GSI classification system has been used for calculation of GHB parameters. The representative value of the uniaxial compressive strength and elastic modulus of rockmass have been estimated using probabilistic approach. A hypothetical case of an unsupported tunnel has been analyzed considering both MMC and GHB criteria. The analysis was done using the convergence-confinement method with two different approaches. The first approach predicts the tunnel response using GHB criterion directly. The second approach predicts the tunnel response using equivalent Mohr-Coulomb parameters obtained by linearization of triaxial data points obtained from MMC and GHB criteria. The tunnel response has been estimated in terms of radius of plastic zone, tunnel convergence and tunnel convergence strain. For very poor rockmasses the tunnel response predicted by MMC criterion is less than that predicted by GHB criterion. For poor and fair rockmass, the tunnel response estimated considering both the criteria are comparable except for few cases. Squeezing condition in rockmass has been also evaluated.展开更多
基金supported by Western Transportation Technology Funds of China (200731800038)the Special Fund for Basic Scientific Research of Central Colleges,Chang’an University(CHD2011JC175)
文摘The Hoek-Brown （HB） strength criterion has been widely applied to the estimation of strength of intact rock and rock mass, while evolving ever since. However, negligence of the effect of the intermediate principal stress still remains in the criterion＇s latest version. At the same time, several three-dimensional （3D） HB strength, which can takes into account the influence of the intermediate principal stress, have already been proposed, among which the 3D HB criterion proposed by Zhang and Zhu seems to be the most reasonable one. However, the Zhang 3D HB criterion may have problems with some stress path close to triaxial extension state because of the non-convexity characteristic of its failure surface. In this paper, a new 3D HB strength criterion is presented based on a generalized form of the HB criterion, which also considers the effect of the intermediate principal stress and inherits all the merits of the original version of the HB criterion. In addition, this new criterion can remedy to some extent the shortcomings observed in the Zhang 3D HB criterion. Polyaxial tests for five different rocks from pub- lished literatures are used for evaluating this new criterion and comparing it with the Zhang 3D HB criterion. The re- sults show that this new criterion may over-predict or under- predict the polyaxial strength of rocks but the errors are rela- tively small, and similar results are also found for the Zhang 3D HB criterion, which one is better depends on the type of the rock under estimation.
基金Project(2015M580702)supported by China Postdoctoral Science FoundationProject(51608541)supported by the National Natural Science Foundation of ChinaProject(2014122066)supported by the Guizhou Provincial Department of Transportation Foundation,China
文摘Hoek–Brown(HB)strength criterion can reflect rock’s inherent failure nature,so it is more suitable for analyzing the stability of rock slopes.However,the traditional limit equilibrium methods are at present only suitable for analyzing the rock slope stability using the linear equivalent Mohr–Coulomb(EMC)strength parameters instead of the nonlinear HB strength criterion.Therefore,a new method derived to analyze directly the rock slope stability using the nonlinear HB strength criterion for arbitrary curve slip surface was described in the limit equilibrium framework.The current method was established based on certain assumptions concerning the stresses on the slip surface through amending the initial normal stressσ0 obtained without considering the effect of inter-slice forces,and it can satisfy all static equilibrium conditions of the sliding body,so the current method can obtain the reasonable and strict factor of safety(FOS)solutions.Compared with the results of other methods in some examples,the feasibility of the current method was verified.Meanwhile,the parametric analysis shows that the slope angleβhas an important influence on the difference of the results obtained using the nonlinear HB strength criterion and its linear EMC strength parameters.Forβ≤45°,both of the results are similar,showing the traditional limit equilibrium methods using the linear EMC strength parameters and the current method are all suitable to analyze rock slope stability,but forβ>60°,the differences of both the results are obvious,showing the actual slope stability state can not be reflected in the traditional limit equilibrium methods,and then the current method should be used.
文摘The HoekeBrown criterion was introduced in 1980 to provide input for the design of underground excavations in rock.The criterion now incorporates both intact rock and discontinuities,such as joints,characterized by the geological strength index(GSI),into a system designed to estimate the mechanical behaviour of typical rock masses encountered in tunnels,slopes and foundations.The strength and deformation properties of intact rock,derived from laboratory tests,are reduced based on the properties of discontinuities in the rock mass.The nonlinear HoekeBrown criterion for rock masses is widely accepted and has been applied in many projects around the world.While,in general,it has been found to provide satisfactory estimates,there are several questions on the limits of its applicability and on the inaccuracies related to the quality of the input data.This paper introduces relatively few fundamental changes,but it does discuss many of the issues of utilization and presents case histories to demonstrate practical applications of the criterion and the GSI system.
文摘The triaxial strength of twenty rockmass types was predicted using two non-linear triaxial strength criteria for rockmass i.e. Modified Mohr-Coulomb(MMC) criterion and Generalized Hoek-Brown(GHB)criterion. Four different rockmass classification systems were used for the calculation of MMC criterion parameters while only GSI classification system has been used for calculation of GHB parameters. The representative value of the uniaxial compressive strength and elastic modulus of rockmass have been estimated using probabilistic approach. A hypothetical case of an unsupported tunnel has been analyzed considering both MMC and GHB criteria. The analysis was done using the convergence-confinement method with two different approaches. The first approach predicts the tunnel response using GHB criterion directly. The second approach predicts the tunnel response using equivalent Mohr-Coulomb parameters obtained by linearization of triaxial data points obtained from MMC and GHB criteria. The tunnel response has been estimated in terms of radius of plastic zone, tunnel convergence and tunnel convergence strain. For very poor rockmasses the tunnel response predicted by MMC criterion is less than that predicted by GHB criterion. For poor and fair rockmass, the tunnel response estimated considering both the criteria are comparable except for few cases. Squeezing condition in rockmass has been also evaluated.
