Upper Hybrid Resonance of Microwaves with a Large Magnetized Plasma Sheet

A large magnetized plasma sheet with size of 60 cm×60 cm×2 cm was generated by a linear hollow cathode discharge under the confinement of a uniform magnetic field generated by a Helmholtz Coil. The microwave transmission characteristic of the plasma sheet was measured for different incident frequencies, in cases with the electric field polarization of the incident microwave either perpendicular or parallel to the magnetic field. In this measurement, parameters of the plasma sheet were changed by varying the discharge current and magnetic field intensity. In the experiment, upper hybrid resonance phenomena were observed when the electric field polarization of the incident wave was perpendicular to the magnetic field. These resonance phenomena cannot be found in the case of parallel polarization incidence. This result is consistent with theoretical consideration. According to the resonance condition, the electron density values at the resonance points are calculated under various experimental conditions. This kind of resonance phenomena can be used to develop a specific method to diagnose the electron density of this magnetized plasma sheet apparatus. Moreover, it is pointed out that the operating parameters of the large plasma sheet in practical applications should be selected to keep away from the upper hybrid resonance point to prevent signals from polarization distortion.

On the heating mechanism of electron cyclotron resonance thruster immerged in a non-uniform magnetic field

To study the heating mechanism of electron cyclotron resonance thruster(ECRT)immersed in a non-uniform magnetic field,experiments and simulations are performed based on an electron cyclotron resonance plasma source at ASIPP.It is found that the first harmonic of electron cyclotron resonance is essential for plasma ignition at high magnetic field(0.0875 T),while the plasma can sustain without the first and second harmonics of electron cyclotron resonance at low magnetic field(till 0.0170 T).Evidence of radial hollow density profile indicates that upper hybrid resonance,which has strong edge heating effect,is the heating mechanism of low-field ECRT.The heating mode transition from electron cyclotron resonance to upper hybrid resonance is also revealed.Interestingly,the evolutions of electron temperature and electron density with input power experience a‘delayed’jump,which may be correlated with the different power levels required for cyclotron and ionization.Moreover,when the field strength decreased,the variation of electron density behaves in an opposite trend with that of electron temperature,implying a possible competition of power deposition between them.The present work is of great interest for understanding the plasma discharge in ECRT especially immersed in a non-uniform magnetic field,and designing efficient ECRT using low magnetic field for economic space applications.

Generating Squeezed States of Nanomechanical Resonator via a Flux Qubit in a Hybrid System

We propose a scheme for generating squeezed states based on a superconducting hybrid system. Our system consists of a nanomeehanical resonator, a superconducting flux qubit, and a superconducting transmission line resonator. Using our proposal, one can easily generate the squeezed states of the nanomechanical resonator. In our scheme, the nonlinear interaction between the nanomechanical resonator and the superconducting transmission line resonator can be implemented by the flux qubit as ＇nonlinear media＇ with a tunable Josephson energy. The realization of the nonlinearity does not need any operations on the flux qubit and just needs to adiabatically keep it at the ground state, which can greatly decrease the effect of the decoherenee of the flux qubit on the squeezed ef^ciency.

Optimized Power Factor Correction for High Speed Switched Reluctance Motor

The Power Factor Correction(PFC)in Switched Reluctance(SR)motor is discussed in this article.The SR motors are applicable for multiple applications like electric vehicles,wind mills,machineries etc.The doubly salient structure of SR motor causes the occurrence of torque ripples,which affects the power factor of the motor.To improve the power quality,the power factor has to be corrected and the ripples have to be minimized.In order to achieve these objectives,a novel power factor correction(PFC)method is proposed in this work.Here,the conventional Diode Bridge Rectifier(DBR)is replaced by a Bridgeless Hybrid Resonant(HR)converter,which assists in improvising the output in a wider range.The converter is chosen because of having variety of beneficial measures including high gain.The converter’s output is fed to the SR motor by means of an asymmetric Bridge Resonant(BR)converter.The proposed converter operates in continuous mode of conduction with the switching frequency of 10 KHz.A hysteresis current controller and Proportional Integral(PI)controller are utilized for reducing the harmonics in the source current along with the regulation of output voltage.In addition,the speed control of SR motor is accomplished by means of the Whale Optimization Algorithm(WOA)assisted PI controller.The proposed methodology is effective for the control of unity power factor,torque and current ripples.The Total Harmonic Distortion(THD)of the source current is also minimized,which suits the standard of International Electrotechnical Comission IEC 61000-3-2.By this methodology,the power factor of 0.99 is achieved with 97%efficiency and 3.92%THD.The proposed methodology is validated in simulation by MATLAB and in hardware by FPGA Spartan 6E.

LD End-Pumped Nd:YAG InnoSlab Laser at 1319 nm

The 1319 nm lasers have important research value and application prospects in optical communications, biomedicine and nonlinear frequency conversion. Currently, there are few reports of high power 1319 nm continuous lasers with high beam quality. We have demonstrated a high output power, high beam quality 1319 nm continuous-wave laser by laser diode end-pumped Nd:YAG slab with a stable-unstable hybrid resonator. With a pumping power of 477 W, an output of 96.8 W was obtained with a slope efficiency of 26.5% and stability of 0.27%. A single wavelength laser operation at 1318.7 nm was demonstrated. At an output of 91.1 W, the beam quality factors M2 in stable and unstable directions were 2.95 and 1.88, respectively.

High Q-factor controllable phononic modes in hybrid phononic–dielectric structures

Phonon polariton resonances in the mid-infrared spectral range demonstrate properties superior to noble metal-based plasmonics,owing to smaller dissipative loss and better field confinement.However,a conventional way to excite the localized phonon resonance involves ion etching,which reduces the attainable quality factors(Q-factors)of the resonators.We show that by introducing a deep subwavelength layer of dielectric gratings on a phononic substrate,localized dipolar resonance and higher order modes with high Q-factors 96 and 195,respectively,can be excited.We further demonstrate,via experiments and simulations,that the resonant wavelength and field confinement can be controlled by coupling the localized hybrid mode with propagating surface phonon-polaritons.We also observed for the first time the coupling between a localized dipolar mode and a propagating higher-order surface phonon-polariton mode.The results will be useful in designing on-chip,low-loss,and highly integrated phononic devices in the infrared spectral domain.

Reduced thermal sensitivity of hybrid air-core photonic band-gap fiber ring resonator

A novel hybrid air-core photonic band-gap fiber(PBF) ring resonator with twin 90° polarization-axis rotated splices is proposed and demonstrated. Frist, we measure the temperature dependent birefringence coefficient of air-core PBF and Panda fiber. Experimental results show that the relative temperature dependent birefringence coefficient of air-core PBF is 1.42×10^(-8)/℃, which is typically ~16 times less than that of Panda fiber. Then, we extract the geometry profile of air-core PBF from scanning electron microscope(SEM) images. Numerical modal is built to distinguish the fast axis and slow axis in the fiber. By precisely setting the length difference in air-core PBF and Panda fiber between two 90° polarization-axis rotated splicing points, the hybrid air-core PBF ring resonator is constructed, and the finesse of the resonator is 8.4. Environmental birefringence variation induced by temperature change can be well compensated, and experimental results show an 18-fold reduction in thermal sensitivity, compared with resonator with twin 0° polarization-axis rotated splices.