Surface Plasmon Interference Lithography Assisted by a Fabry-Perot Cavity Composed of Subwavelength Metal Grating and Thin Metal Film

A surface plasmon interference lithography assisted by a Fabry-Perot （F-P） cavity composed of subwavelength metal gratings and a thin metal fihn is proposed to fabricate high-quality nanopatterns. The calculated results indicate that uniform straight interference fringes with high contrast and high electric-field intensity are formed in the resist under the F-P cavity. The analyses of spatial frequency spectra illuminate the physical mechanism of the formation for the interference fringes. The influence of the F-P cavity spacing is discussed in detail. Moreover, the error analyses reveal that all parameters except the metal grating period in this scheme can bear large tolerances for the device fabrication.

COMPACT PHASE GRATING INTERFERENCE SENSOR FOR MICRO-DISPLACEMENT

On the basis of existing techniques, a compact micro-displacement sensor of phase grating interference （PGI） is described, which adopts cylindrical hologram diffraction grating as the calibration standard. The optical principle of the sensor is explained, and the relation between the grating motion displacement and the phase shift of interference stripes is deduced. The improvement of the integral structure and the method of photoelectric signal processing are described in detail. With the software system based on the virtual instrument development platform Labwindows/CVI and other hardwares such as the precision displacement worktable, the surfaces of typical parts are measured and the characterization results are given. The sensor has wide measuring range and high resolution, its sensitivity and resolution being independent of the wavelength of the incident light. The vertical measuring range is 0-6 mm, and the vertical resolution is 0.005μm. The experimental results show that the sensor can be used to measure and characterize the surface topography parameters of the plane and curved surface.

FastICA Peel-off for ECG Interference Removal from Surface EMG

Multi-channel recording of surface electromyographyic (EMG) signals is very likely to be contaminat-ed by electrocardiographic (ECG) interference, specifically when the surface electrode is placed on mus-cles close to the heart.

Influence of structural depth of laser-patterned steel surfaces on the solid lubricity of carbon nanoparticle coatings

Carbon nanoparticle coatings on laser-patterned stainless-steel surfaces present a solid lubrication system where the pattern's recessions act as lubricant-retaining reservoirs.This study investigates the influence of the structural depth of line patterns coated with multi-walled carbon nanotubes(CNTs)and carbon onions(COs)on their respective potential to reduce friction and wear.Direct laser interference patterning(DLIP)with a pulse duration of 12 ps is used to create line patterns with three different structural depths at a periodicity of 3.5μm on AISI 304 steel platelets.Subsequently,electrophoretic deposition(EPD)is applied to form homogeneous carbon nanoparticle coatings on the patterned platelets.Tribological ball-on-disc experiments are conducted on the as-described surfaces with an alumina counter body at a load of 100 mN.The results show that the shallower the coated structure,the lower its coefficient of friction(COF),regardless of the particle type.Thereby,with a minimum of just below 0.20,CNTs reach lower COF values than COs over most of the testing period.The resulting wear tracks are characterized by scanning electron microscopy,transmission electron microscopy,and energy-dispersive X-ray spectroscopy.During friction testing,the CNTs remain in contact,and the immediate proximity,whereas the CO coating is largely removed.Regardless of structural depth,no oxidation occurs on CNT-coated surfaces,whereas minor oxidation is detected on CO-coated wear tracks.