Microstructure and Properties of La_(0.7)Sr_(0.3)MnO_3 Films Deposited on LaAlO_3 (100), (110), and (111) Substrates

A comparative study of the crystalline structure, magnetic properties, and transport properties of LSMO films grown on （100）-, （110）-, and （111） LaAlO3（LAO） substrates was carried out. Using atomic force microscopy, round, rectangle, and dot surface morphologies were observed in （ 100）-, （ 110）-, and （ 111 ）-oriented LSMO films, respectively. Electrical and magnetic characterizations were performed on LSMO films of different orientation to provide evidence for the effect of strain on the magnetotransport properties. The （ 111 ）-oriented LSMO film has higher saturation magnetization and lower resistance compared with the （100）- and （110）-oriented LSMO films, which results from the smaller elastic deformation due to the larger elastic modulus along the 〈 111 〉 crystallographic direction.

Transport properties and microstructure of La_(0.7)Sr_(0.3)MnO_3 nanocrystalline thin films grown by polymer-assisted chemical solution deposition

Perovskite-based materials can be widely used in the aerospace and transportation field. Perovskite man-ganese oxides La0.7Sr0.3MnO3 （LSMO） thin films were grown on LaAlO3 （100） and Si （100） single crystal sub-strates by the polymer-assisted chemical solution deposi-tion （PACSD） method. Electronic transport behavior, microstructure, and magnetoresistance （MR） of LSMO thin films on different substrates were investigated. The resis-tance of LSMO films fabricated on LaAlO3 substrates is smaller than that on the Si substrates. The magnetic field reduces resistance of LSMO films both on Si and LAO in the wide temperature region, when the insulator-metal transition temperature shifts to higher temperature. The low-field magnetoresistance of LSMO films on Si in low temperature range at 1 T is larger than that of LSMO films on LAO. However, the MR of LSMO film on LAO films at room-temperature is about 5.17%. The thin films are smooth and dense with uniform nanocrystal size grain. These results demonstrate that PACSD is an effective technique for producing high quality LSMO films, which is significant to improve the magnetic properties and the application of automotive sensor.

Characteristics of La_0.7Sr_0.3MnO₃Films Modified by Aluminum Ions Implantation and Post-Implantation Annealing

The magnetron sputtered La0.7Sr0.3MnO3 films were implanted with different doses (5 ′ 1015 ions×cm?2 and 5 ′ 1016 ions×cm-2) of Al ions at different negative pulsed voltages (30 kV and 50 kV) by plasma based ion implantation and then annealed at 973 K for 1 h in air. The microstructure, surface morphologies, surface roughness, metal-insulator transition and room temperature emittance properties of the post-implantation annealed films were investigated and compared with those of the La0.7Sr0.3MnO3 film annealed at 973 K for 1 h in air. The results indicate that the post- implantation annealed films show single perovskite phase and obvious (100) preferred orientation growth. The Mn-O bond length, surface roughness and metal-insulator transition temperature (TMI) of the films can be effectively adjusted by changing implantation voltage or implantation dose of Al ions. However, the change of implantation parameters just has a small effect on room temperature emittance of the films. Compared with the annealed film, the post-implantation annealed films have shorter Mn-O bond length and lower room temperature emittance. The TMI of the films implanted at low voltage is lower than that of the annealed film, which mainly results from the degradation of oxidization during annealing process and the part displacement of Mn3+-O2+- Mn4+ double exchange channels by Al3+-O2?-Mn4+. The post-implanted annealed film implanted at 50 kV/5 ′ 1016 ions×cm-2 has a higher TMI than the annealed film, which is 247 K. The increase of TMI of the film implanted with high dose of Al ions at high voltage can be attributed to the improvement of microstructure.

掺杂锰氧化物La_(0.85)Sr_(0.015)MnO_3薄膜的自旋输运特性

采用磁控溅射方法制备了二价碱土元素微量掺杂锰氧化物La0.85Sr0.015MnO3(LSMO)薄膜。电阻-温度关系表明,薄膜在273K时发生铁磁金属-顺磁半导体相变。在磁场和激光作用下,薄膜呈现出不同的响应特性:在整个测试温度区间内,磁场作用使薄膜电阻变小,在243K时,取得最大磁电阻变化率为21%;激光辐照薄膜在不同的相态显示出不同的变化特性,在铁磁金属态导致电阻增大,而在顺磁半导体态则致使电阻减小。从能带理论的角度定性地分析了产生该现象的原因是外场对eg电子的作用不同。

LSM-infiltrated LSCF cathodes for solid oxide fuel cells

Mixed ionic-electronic conductors in the family of LaxSr1-xCoyFe1-y O3-δ have been widely studied as cathode materials for solid oxide fuel cells （SOFCs）. However, the long-term stability was a concern. Here we report our findings on the effect of a thin film coating of La0.85Sr0.15MnO3-δ （LSM） on the performance of a porous La0.6Sr0.4Co0.2Feo.8O3-δ（LSCF） cathode. When the thicknesses of the LSM coatings are appropriate, an LSM-coated LSCF electrode showed better stability and lower polarization （or higher activity） than the blank LSCF cathode without LSM infiltration. An anode-supported cell with an LSM-infiltrated LSCF cathode demonstrated at 825 ℃ a peak power density of -1.07 W/cm2, about 24% higher than that of the same cell without LSM infiltration （-0.86 W/cm2）. Further, the LSM coating enhanced the stability of the electrode; there was little degradation in performance for the cell with an LSM-infiltrated LSCF cathode during 100 h operation.

Oxygen pressure dependent electro-resistance in La_(0.9)Sr_(0.1)MnO_3 thin films grown by laser molecular beam epitaxy

We report here studies on the influence of oxygen pressure on the electroresis-tance behavior of La0.9Sr0.1MnO3 thin films fabricated by laser molecular beam epi-taxy. It was found that the film deposited at lower oxygen pressure shows larger c-axis parameter,higher resistance,and more distinct electroresistance. These results reveal that the electroresistance of manganite thin films can be tuned by the conditions of film fabrication.

Linearly shifting ferromagnetic resonance response of La_(0.7)Sr_(0.3)MnO_(3) thin film for body temperature sensors

Human body temperature not only reflects vital signs,but also affects the state of various organs through blood circulation,and even affects lifespan.Here a wireless body temperature detection scheme was presented that the temperature was extracted by investigating the out-of-plane(OP)ferromagnetic resonance(FMR)field of 10.2 nm thick La_(0.7)Sr_(0.3)MnO_(3)(LSMO)film using electron paramagnetic resonance(EPR)technique.Within the range of 34-42℃,the OP FMR field changes linearly with the increasing or decreasing temperature,and this variation comes from the linear responses of magnetization to the fluctuant temperature.Using this method,a tiny temperature change(<0.1℃)of organisms can be detected accurately and sensitively,which shows great potential in body temperature monitoring for humans and mammals.