根据Modelsim与Matlab/Simulink软件各自的特点,对两者的联合仿真技术进行了研究。应用Simulink仿真库里提供的link for modelsim功能解决了联合仿真的接口与实现问题,并把该技术应用于IEEE1588时钟同步仿真中硬件时间戳的获取,取得了...根据Modelsim与Matlab/Simulink软件各自的特点,对两者的联合仿真技术进行了研究。应用Simulink仿真库里提供的link for modelsim功能解决了联合仿真的接口与实现问题,并把该技术应用于IEEE1588时钟同步仿真中硬件时间戳的获取,取得了良好的效果。展开更多
由于MATLAB/Simulink本身就是一款优秀的系统建模和算法仿真工具,Modelsim是国内最为常用的HDL仿真工具,利用Link for modelsim使Modelsim与Simulink协同工作,使得算法设计和验证在同一款软件中完成。避免了不同开发环境下的兼容性问题...由于MATLAB/Simulink本身就是一款优秀的系统建模和算法仿真工具,Modelsim是国内最为常用的HDL仿真工具,利用Link for modelsim使Modelsim与Simulink协同工作,使得算法设计和验证在同一款软件中完成。避免了不同开发环境下的兼容性问题,极大地简化了设计的复杂度,加快了开发进程。提出利用基于模型的设计方法,可以将算法与硬件实现联合起来,对于算法的开发以及后期硬件实现都会带来极大的方便。详细介绍了Modelsim与MATLAB/Simulink联合仿真的接口技术、模型的搭建,以及通过利用16 QAM调制与解调的应用实例来验证系统的正确性。展开更多
Based on the basic principle of Time-Of-Flight cameras,a novel MATLAB/SIMULINK model is proposed to measure phase delay of a modulated light signal which represents the distance from camera to object. Subsequently,by ...Based on the basic principle of Time-Of-Flight cameras,a novel MATLAB/SIMULINK model is proposed to measure phase delay of a modulated light signal which represents the distance from camera to object. Subsequently,by discussing influence factors of phase measurement,it is found that the integration time,the sampling time,and the aliasing effect have important effect on improving the accuracy of phase measurement. Interestingly,by analyzing different integration time and sampling time, it is found that the best integration time and sampling time are 0.05 ms and 10 ns,respectively. In this case(i.e.,in absence of the aliasing effect),the variation range of the distance error is between 1 mm and 11 mm in the interval of one period. Especially,under the consideration of the aliasing effect,the average value of distance error is half of that in absence of the aliasing effect. This improves the accuracy of the distance measurement greatly.展开更多
The modeling of PV （photovoltaic） systems is very crucial for embedded power system applications and maximum power point tracking. This paper presents a PV array model using Matlab/Simulink with the assistance of Si...The modeling of PV （photovoltaic） systems is very crucial for embedded power system applications and maximum power point tracking. This paper presents a PV array model using Matlab/Simulink with the assistance of SimPowerSystem toolbox. The PV cell is considered as the main building block for simulating and monitoring the PV array performance. The PV model has been developed and used as Simulink subsystems where the effect of solar insolation and PV array temperature on commercial PV modules have been studied throughout the simulated I-V and P-V output characteristics. The proposed model facilitates simulating the dynamic performance of PV-based power systems. The effect of different partial shading patterns of PV arrays under different configurations has been studied.展开更多
This paper presents an integrated simulation model for full digital controlled PMIG/MAG welding system with Matlab/Simulink, and it consists of power inverter, digital control system and dynamic arc-load model. An int...This paper presents an integrated simulation model for full digital controlled PMIG/MAG welding system with Matlab/Simulink, and it consists of power inverter, digital control system and dynamic arc-load model. An integrated simulation study was done for full digital PMIG/MAG welding, and a method of connecting dynamic arc-load model to the system with controlled current source was presented, in addition, the simulation results were utilized to study the issues of digital control PMIG/MAG welding in this paper. The experimental results validated the developed simulation model, and this simulation study can be applied in implementation of the full digital PMIG/MAG welding and analysis of system dynamic process.展开更多
A centrifugal pump used as a hydraulic turbine in producing power for a microhydropower system is multifaceted. Centrifugal pumps are far more ubiquitous than turbines in the turbomachinery market, therefore being mor...A centrifugal pump used as a hydraulic turbine in producing power for a microhydropower system is multifaceted. Centrifugal pumps are far more ubiquitous than turbines in the turbomachinery market, therefore being more readily available to the consumer. Additionally, they are cheaper. Hydraulic turbines undergo rigorous CFD simulation design and testing to establish their blade geometries and ranges of operation. This results in a refined but very expensive final product. Centrifugal pumps are thus presented as a logical alternative seeing that they can physically perform the same task as a hydropower turbine albeit at a reduced efficiency. This paper presents the results of an analysis and simulation to assess the use of a centrifugal pump as a hydraulic turbine.展开更多
This paper discusses an implementation based on CMEX S-functions to model and to check implementation feasibility of two most commonly used Maximum Power Point Tracking （MPPT） algorithms, namely Hill Climbing/Pertu...This paper discusses an implementation based on CMEX S-functions to model and to check implementation feasibility of two most commonly used Maximum Power Point Tracking （MPPT） algorithms, namely Hill Climbing/Perturb ＆ Observe （P＆O） and Incremental Conductance. This study can also be generalized to encompass the whole digital techniques family, including artificial intelligence like Neural Network and Fuzzy Logic Control.展开更多
In this paper, a PV （photovoltaic） module in renewable energy conversion system is simulated. The simulation of the system is developed using MATLAB/Simulink environments, which can be representative of PV cell, mod...In this paper, a PV （photovoltaic） module in renewable energy conversion system is simulated. The simulation of the system is developed using MATLAB/Simulink environments, which can be representative of PV cell, module and array for easy use on simulation block. The PV model is developed using basic circuit equations of the photovoltaic solar cells including the effects of irradiation and temperature. The output current and power characteristics of PV model are simulated. The results are provided and presented here.展开更多
In this paper, the solar panels are used to power an electrolyzer to separate the water into hydrogen and oxygen gas. Theelectrical equivalent circuit for the proton exchange membrane electrolyzer was developed and im...In this paper, the solar panels are used to power an electrolyzer to separate the water into hydrogen and oxygen gas. Theelectrical equivalent circuit for the proton exchange membrane electrolyzer was developed and implemented in MATLAB/Simulinkalong with the atmospheric hydrogen storage tank. The voltage （2 volt） and current （1 ampere） were supplied in a similar manner inorder to compare the simulated and experimental results. The hydrogen amount is calculated to be 7.345 （ml/min A） from the modelas well as the experimental set-up. The experimental and simulation results were matched.展开更多
文摘由于MATLAB/Simulink本身就是一款优秀的系统建模和算法仿真工具,Modelsim是国内最为常用的HDL仿真工具,利用Link for modelsim使Modelsim与Simulink协同工作,使得算法设计和验证在同一款软件中完成。避免了不同开发环境下的兼容性问题,极大地简化了设计的复杂度,加快了开发进程。提出利用基于模型的设计方法,可以将算法与硬件实现联合起来,对于算法的开发以及后期硬件实现都会带来极大的方便。详细介绍了Modelsim与MATLAB/Simulink联合仿真的接口技术、模型的搭建,以及通过利用16 QAM调制与解调的应用实例来验证系统的正确性。
基金National Natural Science Foundation of China(6127404361233010)Hunan Provincial Natural Science Fund for Distinguished Young Scholars(2015JJ1014)
文摘Based on the basic principle of Time-Of-Flight cameras,a novel MATLAB/SIMULINK model is proposed to measure phase delay of a modulated light signal which represents the distance from camera to object. Subsequently,by discussing influence factors of phase measurement,it is found that the integration time,the sampling time,and the aliasing effect have important effect on improving the accuracy of phase measurement. Interestingly,by analyzing different integration time and sampling time, it is found that the best integration time and sampling time are 0.05 ms and 10 ns,respectively. In this case(i.e.,in absence of the aliasing effect),the variation range of the distance error is between 1 mm and 11 mm in the interval of one period. Especially,under the consideration of the aliasing effect,the average value of distance error is half of that in absence of the aliasing effect. This improves the accuracy of the distance measurement greatly.
文摘The modeling of PV （photovoltaic） systems is very crucial for embedded power system applications and maximum power point tracking. This paper presents a PV array model using Matlab/Simulink with the assistance of SimPowerSystem toolbox. The PV cell is considered as the main building block for simulating and monitoring the PV array performance. The PV model has been developed and used as Simulink subsystems where the effect of solar insolation and PV array temperature on commercial PV modules have been studied throughout the simulated I-V and P-V output characteristics. The proposed model facilitates simulating the dynamic performance of PV-based power systems. The effect of different partial shading patterns of PV arrays under different configurations has been studied.
文摘This paper presents an integrated simulation model for full digital controlled PMIG/MAG welding system with Matlab/Simulink, and it consists of power inverter, digital control system and dynamic arc-load model. An integrated simulation study was done for full digital PMIG/MAG welding, and a method of connecting dynamic arc-load model to the system with controlled current source was presented, in addition, the simulation results were utilized to study the issues of digital control PMIG/MAG welding in this paper. The experimental results validated the developed simulation model, and this simulation study can be applied in implementation of the full digital PMIG/MAG welding and analysis of system dynamic process.
文摘A centrifugal pump used as a hydraulic turbine in producing power for a microhydropower system is multifaceted. Centrifugal pumps are far more ubiquitous than turbines in the turbomachinery market, therefore being more readily available to the consumer. Additionally, they are cheaper. Hydraulic turbines undergo rigorous CFD simulation design and testing to establish their blade geometries and ranges of operation. This results in a refined but very expensive final product. Centrifugal pumps are thus presented as a logical alternative seeing that they can physically perform the same task as a hydropower turbine albeit at a reduced efficiency. This paper presents the results of an analysis and simulation to assess the use of a centrifugal pump as a hydraulic turbine.
文摘This paper discusses an implementation based on CMEX S-functions to model and to check implementation feasibility of two most commonly used Maximum Power Point Tracking （MPPT） algorithms, namely Hill Climbing/Perturb ＆ Observe （P＆O） and Incremental Conductance. This study can also be generalized to encompass the whole digital techniques family, including artificial intelligence like Neural Network and Fuzzy Logic Control.
文摘In this paper, a PV （photovoltaic） module in renewable energy conversion system is simulated. The simulation of the system is developed using MATLAB/Simulink environments, which can be representative of PV cell, module and array for easy use on simulation block. The PV model is developed using basic circuit equations of the photovoltaic solar cells including the effects of irradiation and temperature. The output current and power characteristics of PV model are simulated. The results are provided and presented here.
文摘In this paper, the solar panels are used to power an electrolyzer to separate the water into hydrogen and oxygen gas. Theelectrical equivalent circuit for the proton exchange membrane electrolyzer was developed and implemented in MATLAB/Simulinkalong with the atmospheric hydrogen storage tank. The voltage （2 volt） and current （1 ampere） were supplied in a similar manner inorder to compare the simulated and experimental results. The hydrogen amount is calculated to be 7.345 （ml/min A） from the modelas well as the experimental set-up. The experimental and simulation results were matched.
