Interface passivation engineering has been recognized as an effective way to simultaneously contribute to the optoelectronic characteristic and stability of perovskite solar cells(PSCs). Herein, a p-conjugated dual-li...Interface passivation engineering has been recognized as an effective way to simultaneously contribute to the optoelectronic characteristic and stability of perovskite solar cells(PSCs). Herein, a p-conjugated dual-ligand 1,4-phenylmercaptan(PHMT) is explored to rationally tailor the surface of perovskite film.The experimental and theoretical results show that the PHMT presents planar structure and obvious electron delocalization characteristics, which allow it to anchor on the surface of perovskite with a certain orientation, thereby promoting the transport of interface charge. Moreover, the two sulfhydryl groups in PHMT reduce the trap density of the perovskite film by passivating under-coordinated lead ions.Consequently, the PHMT-modified inverted device based on MAPbI_(3)(MA: methylammonium) achieves enhanced efficiency from 18.11%(control) to 21.11%, along with the ambient stability up to 3500 h.After being placed at 85 °C for 500 h or illuminated for 600 h, the modified device remains over 89%or 86% of initial efficiency. This discovery opens a new window for the choice of passivators to improve the performance of PSCs.展开更多
Activated carbons containing dispersed metal oxide particles were prepared by carbonization of phenol resin containing metal compounds followed by steam activation. Acetylacetonates of Fe, Mn and V, and Cu nitrate wer...Activated carbons containing dispersed metal oxide particles were prepared by carbonization of phenol resin containing metal compounds followed by steam activation. Acetylacetonates of Fe, Mn and V, and Cu nitrate were used as the sources of metals. The removal of a small amount of methyl mercaptan (CH3SH) in air with these activated carbons was tested in a flow system. Compared with activated carbons without metal oxides, the carbons exhibited high activity for the removal of CH3SH in air. In particular, activated carbon obtained from Novolac containing 5 wt% Cu showed excellent behavior over a long time.展开更多
Aromatic-aliphatic polyols were obtained previously from the thiol-ene reactions of propoxylated cardanol with hydroxyalkyl mercaptans;these aromatic-aliphatic polyols were then utilized in the preparation of rigid po...Aromatic-aliphatic polyols were obtained previously from the thiol-ene reactions of propoxylated cardanol with hydroxyalkyl mercaptans;these aromatic-aliphatic polyols were then utilized in the preparation of rigid polyurethane foams with excellent properties.The current work describes a variant of cardanol polyol synthesis by thiol-ene reactions in three steps.The first step is propoxylation of cardanol by reacting cardanol with propylene oxide;the second step is mercaptanization of propoxylated cardanol by reacting double bonds with hydrogen sulfide;and the third step involves the addition of the thiol groups of mercaptanized propoxylated cardanol to the double bonds of allyl alcohol,glycerol-1-allyl ether,and trimethylolpropane allyl ether.Thus,obtained polyols were characterized by standard analytical methods.Rigid polyurethane foams prepared from these polyols show promising physical-mechanical properties.The rigid polyurethane foams can be used for various applications such as thermo-insulation of freezers,storage tanks and pipes for food and chemical industries,wood substitutes and flotation materials.展开更多
CdO(cadmium oxide)nanoparticles show a strong peak of Plasmon absorption in ultraviolet-visible zone.A strong interaction exists between the surface of CdO nanoparticles and aryl mercaptan compounds.Aryl mercaptan com...CdO(cadmium oxide)nanoparticles show a strong peak of Plasmon absorption in ultraviolet-visible zone.A strong interaction exists between the surface of CdO nanoparticles and aryl mercaptan compounds.Aryl mercaptan compounds cause aggregation of CdO nanoparticles linked to DNA/RNA(eoxyribonucleic acid/ribonucleic acid)and hence,lead to widening of peak Plasmon of CdO nanoparticles surface at 550 nm and emerge a new peak at higher wavelength.In the current project,this optical characteristic of CdO nanoparticles is used to investigate interaction time between different aryl mercaptanes and CdO nanoparticles.The results showed that aryl mercaptan compounds with shorter chain length interact faster with CdO nanoparticles.Therefore,a simple and fast method for identification of aryl mercaptanes with various chain lengths using red shift in surficial Plasmon absorption is presented.展开更多
The biofilter is cost-effective for the waste gases treatment. The bacterial is the main microorganism in the conventional biofilters. However, it faces some problems on the elimination of hydrophobic compounds. In or...The biofilter is cost-effective for the waste gases treatment. The bacterial is the main microorganism in the conventional biofilters. However, it faces some problems on the elimination of hydrophobic compounds. In order to overcome these problems, the biofilters with fungi were developed. The objective of this study is to investigate the factors affecting ethyl mercaptan(EM)-degradation using a fungal biofilter. A laboratory experiment was set up. The effects of loading rate, empty bed residence times(EBRT) and pH on EM degradation were investigated. Over 95% removals of EM could be achieved, under the condition of the influent loadings below 50 g/(m·h). Removal efficiencies improved to 98% with EM loading decreased to 45 g/(m·h). For long EBRT of 58 s corresponding to a flow rate of 0.3 m3/h, the EM removal efficiencies of over 98% were observed. However, when EBRT was decreased to 14 s, the removal efficiencies fell under 80%. The pH range of 3—5 was feasible to fungi.展开更多
基金supported by the Basic Research Fund for Free Exploration in Shenzhen (JCYJ20180306171402878)the Project of Shaanxi Young Stars in Science and Technology (2017KJXX-18, 2020GXLH-Z-025)+1 种基金the Shaanxi Provincial Key R&D Program (2020KWZ-018)the Fundamental Research Funds for the Central Universities (3102019ghxm003, 3102019JC005, 3102019ghjd001)。
文摘Interface passivation engineering has been recognized as an effective way to simultaneously contribute to the optoelectronic characteristic and stability of perovskite solar cells(PSCs). Herein, a p-conjugated dual-ligand 1,4-phenylmercaptan(PHMT) is explored to rationally tailor the surface of perovskite film.The experimental and theoretical results show that the PHMT presents planar structure and obvious electron delocalization characteristics, which allow it to anchor on the surface of perovskite with a certain orientation, thereby promoting the transport of interface charge. Moreover, the two sulfhydryl groups in PHMT reduce the trap density of the perovskite film by passivating under-coordinated lead ions.Consequently, the PHMT-modified inverted device based on MAPbI_(3)(MA: methylammonium) achieves enhanced efficiency from 18.11%(control) to 21.11%, along with the ambient stability up to 3500 h.After being placed at 85 °C for 500 h or illuminated for 600 h, the modified device remains over 89%or 86% of initial efficiency. This discovery opens a new window for the choice of passivators to improve the performance of PSCs.
文摘Activated carbons containing dispersed metal oxide particles were prepared by carbonization of phenol resin containing metal compounds followed by steam activation. Acetylacetonates of Fe, Mn and V, and Cu nitrate were used as the sources of metals. The removal of a small amount of methyl mercaptan (CH3SH) in air with these activated carbons was tested in a flow system. Compared with activated carbons without metal oxides, the carbons exhibited high activity for the removal of CH3SH in air. In particular, activated carbon obtained from Novolac containing 5 wt% Cu showed excellent behavior over a long time.
文摘Aromatic-aliphatic polyols were obtained previously from the thiol-ene reactions of propoxylated cardanol with hydroxyalkyl mercaptans;these aromatic-aliphatic polyols were then utilized in the preparation of rigid polyurethane foams with excellent properties.The current work describes a variant of cardanol polyol synthesis by thiol-ene reactions in three steps.The first step is propoxylation of cardanol by reacting cardanol with propylene oxide;the second step is mercaptanization of propoxylated cardanol by reacting double bonds with hydrogen sulfide;and the third step involves the addition of the thiol groups of mercaptanized propoxylated cardanol to the double bonds of allyl alcohol,glycerol-1-allyl ether,and trimethylolpropane allyl ether.Thus,obtained polyols were characterized by standard analytical methods.Rigid polyurethane foams prepared from these polyols show promising physical-mechanical properties.The rigid polyurethane foams can be used for various applications such as thermo-insulation of freezers,storage tanks and pipes for food and chemical industries,wood substitutes and flotation materials.
文摘CdO(cadmium oxide)nanoparticles show a strong peak of Plasmon absorption in ultraviolet-visible zone.A strong interaction exists between the surface of CdO nanoparticles and aryl mercaptan compounds.Aryl mercaptan compounds cause aggregation of CdO nanoparticles linked to DNA/RNA(eoxyribonucleic acid/ribonucleic acid)and hence,lead to widening of peak Plasmon of CdO nanoparticles surface at 550 nm and emerge a new peak at higher wavelength.In the current project,this optical characteristic of CdO nanoparticles is used to investigate interaction time between different aryl mercaptanes and CdO nanoparticles.The results showed that aryl mercaptan compounds with shorter chain length interact faster with CdO nanoparticles.Therefore,a simple and fast method for identification of aryl mercaptanes with various chain lengths using red shift in surficial Plasmon absorption is presented.
文摘The biofilter is cost-effective for the waste gases treatment. The bacterial is the main microorganism in the conventional biofilters. However, it faces some problems on the elimination of hydrophobic compounds. In order to overcome these problems, the biofilters with fungi were developed. The objective of this study is to investigate the factors affecting ethyl mercaptan(EM)-degradation using a fungal biofilter. A laboratory experiment was set up. The effects of loading rate, empty bed residence times(EBRT) and pH on EM degradation were investigated. Over 95% removals of EM could be achieved, under the condition of the influent loadings below 50 g/(m·h). Removal efficiencies improved to 98% with EM loading decreased to 45 g/(m·h). For long EBRT of 58 s corresponding to a flow rate of 0.3 m3/h, the EM removal efficiencies of over 98% were observed. However, when EBRT was decreased to 14 s, the removal efficiencies fell under 80%. The pH range of 3—5 was feasible to fungi.
