In our previous work, a series of polyethylenimine(PEI)-derived cation exchangers were synthesized using PEIgrafted resin FF-PEI-L740(ionic capacity, 740 mmol·L^-1) as the basic resin to study lysozyme adsorption...In our previous work, a series of polyethylenimine(PEI)-derived cation exchangers were synthesized using PEIgrafted resin FF-PEI-L740(ionic capacity, 740 mmol·L^-1) as the basic resin to study lysozyme adsorption and chromatographic behavior. It was found that the resin with an ionic capacity of 630 mmol·L^-1(FF-PEI-CR630)possessed high adsorption performance towards lysozyme at 0–100 mmol·L^-1 Na Cl. Therefore, in this work,FF-PEI-CR630 was selected to study the influences of pH and ionic strength(IS) on protein adsorption and chromatographic behavior towards lysozyme. The increase of lysozyme adsorption capacity in the pH range of 6 to 10 was observed. However, the uptake rate decreased in the pH range of 6 to 8 and then remained essentially unchanged from pH 8 to pH 10. Increasing IS led to decreased protein adsorption capacity and increased uptake rate in different pH ranges. Besides, FF-PEI-CR630 maintained dynamic binding capacity as high as over150 mg·ml^-1 at pH 8–10 without NaCl. The research has thus provided insight into the selection of proper pH and IS conditions for protein purification by using FF-PEI-CR630.展开更多
An novel method for removal of copper from nickel anodic electrolyte through ion exchange was studied after cupric deoxidization. Orthogonal design experiments show the optimum conditions of deoxidizing cupric into Cu...An novel method for removal of copper from nickel anodic electrolyte through ion exchange was studied after cupric deoxidization. Orthogonal design experiments show the optimum conditions of deoxidizing cupric into Cu+ in the nickel electrolyte are the reductive agent dosage is 4.5 times as the theoretic dosage and reaction time is 0.5 h at 40 ℃ and pH 2.0. Ion exchange experiments show that the breakthrough capacity(Y) decreases with the increase of the linear flow rate(X): Y=1.559-0.194X+ 0.006 7X2. Breakthrough capacity increases with the increase of the ratio of height to radius(RRH). The higher the initial copper concentration, the less the breakthrough capacity(BC). SO42- and nickel concentration have no obvious change during the process of sorption, so it is not necessary to worry about the loss of nickel during the sorption process. Desorption experiments show that copper desorption from the resin is made perfectly with NaCl solution added with 4% (volume fraction) H2O2 (30%) and more than 100 g/L CuCl2 solution is achieved.展开更多
研究了采用ZGA351大孔强碱性阴离子交换树脂从粗钨酸铵溶液中吸附分离钼的工艺方法,考察了树脂型号、料液硫含量、料液陈化时间、料液陈化温度、料液pH值、吸附流速、吸附温度对树脂吸附分离钼效果的影响。结果表明:使用100 mL ZGA351...研究了采用ZGA351大孔强碱性阴离子交换树脂从粗钨酸铵溶液中吸附分离钼的工艺方法,考察了树脂型号、料液硫含量、料液陈化时间、料液陈化温度、料液pH值、吸附流速、吸附温度对树脂吸附分离钼效果的影响。结果表明:使用100 mL ZGA351树脂进行动态吸附试验,在料液硫含量为理论量1.1倍、料液陈化时间48 h、料液陈化温度40℃、料液pH值10.0、吸附流速15 mL/h、吸附温度40℃的最优条件下,料液钨损失率仅为0.54%,树脂钼穿透容量为107.77 g/L_(湿树脂),相比目前工业生产应用的HBDM-1树脂钼穿透容量提高了3.15倍。另外,重复试验稳定性良好,ZGA351树脂吸附后得到的纯钨酸铵溶液平均钼钨比为0.88×10^(-4),满足工业生产APT产品用纯钨酸铵溶液钼钨比小于2×10^(-4)的需求。综合而言,采用强碱性阴离子交换树脂从粗钨酸铵溶液中分离钼具有钼穿透容量高、钨损失率低、钨钼分离效率高等优势,为工业化应用提供了一种有效技术参考。展开更多
Electrolyte hydrogels are perspective materials for applications in electrochemical devices, which work at ambient temperatures. In this work, hydrogel sulpho-modified membranes were formed by radical co-polymerizatio...Electrolyte hydrogels are perspective materials for applications in electrochemical devices, which work at ambient temperatures. In this work, hydrogel sulpho-modified membranes were formed by radical co-polymerization of sodium styrensulphonate and potassium sulphopropyl acrylate with acrylamide and acrylonitrile. The hydrogel membranes were obtained in the form of thin films. Properties of the membranes were studied by thermogravimetry, mass-spectrometry and IR-spectrometry. The prepared membranes were thermally stable up to 70°C - 90°C, and showed ion exchange capacity and swelling coefficients sufficient for use as ion-exchange or proton-conducting membranes.展开更多
It is still a challenge to eliminate efficiently fluoride ion from groundwater,especially to design and synthesis an adsorbent possessing high adsorption capacity,recyclability and wide pH application conditions.Herei...It is still a challenge to eliminate efficiently fluoride ion from groundwater,especially to design and synthesis an adsorbent possessing high adsorption capacity,recyclability and wide pH application conditions.Herein we present millimeter-sized sulfate-type zirconium alginate hydrogel beads with 3D network structure(AHB@Zr-SO^(2−)_(4))that exhibited a maximum adsorption capacity of 101.3 mg/g with wide pH applicability(pH 3−9).This material have~2.5 times higher adsorption capacity than that of pure zirconium alginate hydrogel beads(AHB@Zr)and it was ascribed to ion exchange between SO^(2−)_(4)and F−on the surface of AHB@Zr-SO^(2−)_(4),which was verified via ion chromatography measurement coupled with X-ray photoelectron spectroscopy(XPS)and Fourier Transform Infrared Spectrometer(FTIR Spectrometer)analysis.Density functional theory(DFT)calculations indicated that the ion exchange process between SO^(2−)_(4)and F−in AHB@Zr-SO^(2−)_(4)was energetically favorable than OH^(−)and F^(−)in AHB@Zr.In addition,310 bed volumes(BV)of effluent was realized via column adsorption of groundwater containing fluoride on AHB@Zr-SO^(2−)_(4)and indicated that it is a promising candidate for mitigating the problem of fluoride-containing groundwater.展开更多
基金supported by the National Natural Science Foundation of China (Nos. 21878222 and 21621004).
文摘In our previous work, a series of polyethylenimine(PEI)-derived cation exchangers were synthesized using PEIgrafted resin FF-PEI-L740(ionic capacity, 740 mmol·L^-1) as the basic resin to study lysozyme adsorption and chromatographic behavior. It was found that the resin with an ionic capacity of 630 mmol·L^-1(FF-PEI-CR630)possessed high adsorption performance towards lysozyme at 0–100 mmol·L^-1 Na Cl. Therefore, in this work,FF-PEI-CR630 was selected to study the influences of pH and ionic strength(IS) on protein adsorption and chromatographic behavior towards lysozyme. The increase of lysozyme adsorption capacity in the pH range of 6 to 10 was observed. However, the uptake rate decreased in the pH range of 6 to 8 and then remained essentially unchanged from pH 8 to pH 10. Increasing IS led to decreased protein adsorption capacity and increased uptake rate in different pH ranges. Besides, FF-PEI-CR630 maintained dynamic binding capacity as high as over150 mg·ml^-1 at pH 8–10 without NaCl. The research has thus provided insight into the selection of proper pH and IS conditions for protein purification by using FF-PEI-CR630.
基金Project supported by the Postdoctoral Foundation of Central South University and Minerals Processing and Bioengineering, China
文摘An novel method for removal of copper from nickel anodic electrolyte through ion exchange was studied after cupric deoxidization. Orthogonal design experiments show the optimum conditions of deoxidizing cupric into Cu+ in the nickel electrolyte are the reductive agent dosage is 4.5 times as the theoretic dosage and reaction time is 0.5 h at 40 ℃ and pH 2.0. Ion exchange experiments show that the breakthrough capacity(Y) decreases with the increase of the linear flow rate(X): Y=1.559-0.194X+ 0.006 7X2. Breakthrough capacity increases with the increase of the ratio of height to radius(RRH). The higher the initial copper concentration, the less the breakthrough capacity(BC). SO42- and nickel concentration have no obvious change during the process of sorption, so it is not necessary to worry about the loss of nickel during the sorption process. Desorption experiments show that copper desorption from the resin is made perfectly with NaCl solution added with 4% (volume fraction) H2O2 (30%) and more than 100 g/L CuCl2 solution is achieved.
文摘Electrolyte hydrogels are perspective materials for applications in electrochemical devices, which work at ambient temperatures. In this work, hydrogel sulpho-modified membranes were formed by radical co-polymerization of sodium styrensulphonate and potassium sulphopropyl acrylate with acrylamide and acrylonitrile. The hydrogel membranes were obtained in the form of thin films. Properties of the membranes were studied by thermogravimetry, mass-spectrometry and IR-spectrometry. The prepared membranes were thermally stable up to 70°C - 90°C, and showed ion exchange capacity and swelling coefficients sufficient for use as ion-exchange or proton-conducting membranes.
基金supported by the Natural Science Foundation of Tianjin(No.18JCYBJC17700)the National Natural Science Foundation of China(Nos.21406164,21466035 and 22066022).
文摘It is still a challenge to eliminate efficiently fluoride ion from groundwater,especially to design and synthesis an adsorbent possessing high adsorption capacity,recyclability and wide pH application conditions.Herein we present millimeter-sized sulfate-type zirconium alginate hydrogel beads with 3D network structure(AHB@Zr-SO^(2−)_(4))that exhibited a maximum adsorption capacity of 101.3 mg/g with wide pH applicability(pH 3−9).This material have~2.5 times higher adsorption capacity than that of pure zirconium alginate hydrogel beads(AHB@Zr)and it was ascribed to ion exchange between SO^(2−)_(4)and F−on the surface of AHB@Zr-SO^(2−)_(4),which was verified via ion chromatography measurement coupled with X-ray photoelectron spectroscopy(XPS)and Fourier Transform Infrared Spectrometer(FTIR Spectrometer)analysis.Density functional theory(DFT)calculations indicated that the ion exchange process between SO^(2−)_(4)and F−in AHB@Zr-SO^(2−)_(4)was energetically favorable than OH^(−)and F^(−)in AHB@Zr.In addition,310 bed volumes(BV)of effluent was realized via column adsorption of groundwater containing fluoride on AHB@Zr-SO^(2−)_(4)and indicated that it is a promising candidate for mitigating the problem of fluoride-containing groundwater.
