Investigation of Dispersion Compensation in 2.5 Gbit/s OOK Label and 40 Gbit/s RZ-DPSK Payload Optical Label Switching System Based on Optical Carrier Suppression and Separation

Three dispersion compensation schemes of an optical label switching transmission system were investigated, which employs 40 Gbit/s return zero differential phase-shift keying（RZ-DPSK） payload labeled with 2.5 Gbit/s on-off keying（OOK） signal based on the optical carrier suppression and separation（OCSS） techniq ue, In the system, proposed are the receiver sensi ti vity oS payload and label, achieving -- 32. 4 dBm and --38.5 dBm, respectively. Using the optimal dispersion compensation scheme, after transmitted over 160 km and 320 km SMF respectively, the label can be recovered without power penalty, while the payload can be recovered with less than 2 dB and 5 dB penalty, respectively.

Improving performance of optical fibre chaotic communication by dispersion compensation techniques

This paper numerically investigates the effects of dispersion on optical fibre chaotic communication, and proposes a dispersion compensation scheme to improve the performance of optical fibre chaotic communication system. The obtained results show that the transmitter-receiver synchronization progressively degrades and the signal-to-noise ratio of the recovered message deteriorates as the fibre length increases due to the dispersion accumulation. Two segments of 2.5-km dispersion-compensating fibres are symmetrically placed at both ends of a segment of 245-km nonzero dispersionshifted fibre with low dispersion in one compensation period. The numerical results show that the signal-to-noise ratio of the extracted 1 GHz sinusoidal message is improved from -2.92 dB to 15.38 dB by this dispersion compensation for the transmission distance of 500 km.

High-speed polarization mode dispersion compensation in a 43-Gb/s RZ-DQPSK transmission system over 1200 km of standard single-mode fibre

This paper reports that the designed optical polarization mode dispersion compensator shows a good performance under the real-time variation of differential group delay, state of polarization and principal state of polarization in a （40×43）-Gb/s dense-wavelength-multiplexing, 1200-km enhanced return-to-zero differential-quadrature-phase-shift- keying （RZ-DQPSK） system. The polarization mode dispersion tolerance of the system is improved by 26 ps using the optical polarization mode dispersion compensator. The short and long time stabilities are tested with the bit error ratio recorded.

Design of Dispersion Compensation and Nonlinear Distortion Self-compensationin Co -network Transmission Systems

Dispersion and nonlinear distortion have an effect on transmission performanc es of optic al fiber transimission systems. The schemes of dispersion compensation and nonli near distortion self-compens ation in telecom-CATV co-network transmission systems are reported, followed by investigation on (1) the impact of dispersion compensation fiber (DCF) on fi ber nonlinear effects with a cascade of erbium-doped fiber amplifiers (EDFAs) an d different dispersion compensation schemes, (2) the impact of the complex on th e total nonlinear distortion induced by EDFA gain tilt and the light source. As a result , dispersion compensation optimal scheme and EDFA negative gain tilt are suggest ed as a solution to dispersion compensation and the nonlinear distortion self-c ompensation.

Research on Dispersion Compensation of 40 GB/s Optical Duo-Binary Coded Transmission System

A 40 Gb/s high speed optical transmission system is designed, and the different dispersion compensation schemes are adopted to realize the transmission of the optical duo-binary (ODB) signals over 120 km optical fiber. Optical duo-binary signals are generated by using a precoder, two low- pass filters (LPF) and one mach-zehnder modulator (MZM). Through combination of dispersion compensation fiber (DCF) and single mode fiber (SMF) in the transmission link, four different dispersion compensation schemes (pre-compensation, post-compensation and hybrid compensation (pre+ post) and hybrid compensation (post+ pre)) were compared. Analyzing Q factor, BER, eye diagrams and receiver sensitivity in several dispersion compensation schemes, the simulation results are: the cut-off frequency of LPF affects the transmission performance, and the hybrid compensation (post+ pre) scheme is the optimal dispersion compensation method.

Seismic energy dispersion compensation by multi-scale morphology

Seismic energy decays while propagating subsurface, which may reduce the resolution of seismic data. This paper studies the method of seismic energy dispersion compensation which provides the basic principles for multi-scale morphology and the spectrum simulation method. These methods are applied in seismic energy compensation. First of all, the seismic data is decomposed into multiple scales and the effective frequency bandwidth is selectively broadened for some scales by using a spectrum simulation method. In this process, according to the amplitude spectrum of each scale, the best simulation range is selected to simulate the middle and low frequency components to ensure the authenticity of the simulation curve which is calculated by the median method, and the high frequency component is broadened. Finally, these scales are reconstructed with reasonable coefficients, and the compensated seismic data can be obtained. Examples are shown to illustrate the feasibility of the energy compensation method.

The Analysis and Research of Chirped Bragg Fiber GratingTheory on Dispersion Compensation

Based on the general theory of linear Chirped Bragg fiber grating, this paper discusses some parameters including different chirped values and quasi gauss coupling function relating with the reflectivity coefficient dispersion compensation.The result shows that selecting larger chirped value and appropriate qusi guass coupling function can improve the dispersion compensation while ensuring high reflectivity. The concept of "figure of merit" in the microwave field is introduced to quantize the equalizing power of the dispersion compensator.

The system of L-band 2 × 10 Gb/s WDM transmission over conventional single mode fibre with 600 km by chirped fibre Bragg gratings dispersion compensation

A chirped fibre Bragg grating according to ITU-T suggested L-band （2nd channel λ1 = 1570.83 nm; 80th channel λ2 = 1603.57 nm） with more than 1800 ps/nm single channel dispersion compensation is presented in this paper, of which the cladding mode loss, the delay curve ripple and the power fluctuation of the reflected spectrum are less than 0.5 dB, 50 ps and 0.25 dB, respectively. With this new FBG as dispersion compensation device, a 2 × 10 Gb/s wavelength division multiplexing （WDM） L-band transmission of 600 km based on conventional single mode fibre （G.652 fibre） is performed without forward error correction. The bit error rate （BER） is less than 10-12 and the power penalties of the 2nd and 80th channel of L-band are 1.8 dB and 2.0 dB, respectively.

A Method for Dispersion Compensation Based on GLM Theory

A method used to design the waveguide gratings for dispersion compensation employing GLM theory is briefly described. By using this method a reflective grating is designed, which has both a flat amplitude and a quadratic phase response over the transfer bandwidth.

Multichannel Adaptive Polarization Mode Dispersion Compensation with One Compensator in Dense Wavelength Division Multiplexing Transmission Systems

A simple two-section polarization mode dispersion(PMD) compensator is proposed for multichannel PMD compensation, which can compensate two or even more channels simultaneously. Because of the statistical characteristics and the frequency-dependence of PMD, for current single mode fiber with moderate PMD, the probability that all channels are severely degraded at the same time is extremely small, which makes it possible to compensate a dense wavelength division multiplexing(DWDM) transmission system with moderate PMD using this compensator. It is shown that the outage probability of a 40×43 Gb/s DWDM transmission system using this compensator is decreased significantly from 3.6×10-3 to 3.6×10-5.

Analysis of the Impact of P-Ratio on BER, Q-Factor and OSNR of Radio over Fiber (RoF) System

The impact of p-ratio i.e. ratio of carrier power to total received RF power at control office (CO) on Bit error rate (BER), Q- performance parameter and Optical signal noise ratio (OSNR) of RoF communication system is theoretically analyzed using angular full-linewidth at half maximum (FWHM) of Lorentzian shape for the RF oscillator in this paper. As reduction in Laser linewidth improves the performance of RoF system, the RF oscillator linewidth at FWHM also plays an important role in improving the performance of RoF system.

基于广义回归神经网络的色散和OSNR监测

基于异步延时采样结合神经网络的方法,提出一种利用广义回归神经网络(GRNN)对光信噪比(OSNR)和色散(CD)的监测方法,主要在40 Gbit/s 16QAM通信系统以及非线性信道环境中,通过异步采样方法提取特征量,用GRNN实现OSNR、CD的监测。GRNN方法不仅可以实现OSNR、CD的监测,与其他神经网络方法相比还具有参数少、算法效率高、易于优化的特点。

基于偏振实现OSNR和PMD的同时监测

在介绍偏振度(DOP)监测方法工作原理,分析偏振模色散(PMD)导致传输信号去偏问题的基础上,提出了一种采用扰偏器和偏振分束器实现光信噪比(OSNR)和PMD同时监测的方案。波分复用传输信号经扰偏器扰偏后解复用分离出待测信道信号,偏振分束器将待测信号分成偏振正交的两个支路,然后通过检测两支路信号功率之间的关系得到信道的OSNR和PMD值,系统中使用了电放大器,以提高监测灵敏度。

A novel design for broadband dispersion compensation microstructure fiber

A novel microstructure fiber （MF） structure is proposed for broadband dispersion compensation. Through manipulating the four air-hole parameters and the pitch, the broad band dispersion compensation MF can be efficiently designed. The newly designed MF could compensate （to within 0.8%） the dispersion of 101 times of its length of standard single mode fiber over the entire 100-nm band centered on 1550 nm. The proposed design has been simulated through the finite difference beam propagation method, and the corresponding design procedures are also presented. OCIS codes： 060.2310, 060.2280.

Optimal Configuration of Dispersion Compensation Modules with Installation Limits

Selecting a cost optimum subset of discrete-value dispersion compensation modules (DV-DCMs) subject to maximum module count from an available set of DV-DCMs is a NP-hard problem. We derive a novel dynamic programming algorithm with pseudo-polynomial time bound and show that DV-DCM cost re-scaling can improve the running time.

Zero-Loss Broadband Dispersion Compensation Scheme for G.652 Fibers

We have evaluated the gain characteristics of an erbium-doped broadband dual-core dispersion compensating fiber (DCF) to achieve a loss-less dispersion compensating module for long-haul G.652 fiber links.

Application of Automatic Chromatic Dispersion Compensation for Realization of All-Optical Network

We have studied the algorithm for the automatic chromatic dispersion compensation using bit error rate (BER) and Q-factor optimization for realization of dynamically reconfigurable all-optical .network. We have made sure good performance using the compensation system by laboratory experiments.

Analysis of dispersion compensation for position-dependence in externally modulated CATV lightwave systems by using chirped fiber grating

The dispersion compensation characteristics of the chirped fiber grating （CFG） for different dispersion compensation positions are analyzed in externally modulated cable television （CATV） lightwave system and the analytic expression of the composite second order （CSO） distortion is derived. The analyses give a reasonable explanation for the position-dependent effect of CFG dispersion compensator, which was found in practical systems. Moreover, the theoretical result is also verified by an experiment. It is believed that the theory will be helpful in designing optical CATV fiber links with nodes at proper positions both for intensity amplification and dispersion compensation.

Group velocity dispersion and polarization mode dispersion compensation by high-birefringence linearly chirped fiber Bragg grating

A high-birefringence linearly chirped fiber Bragg grating (FBG) is written into a polarization-maintaining photosensitive fiber by ultraviolet (UV) beam through a linearly chirped phase mask.Its performance as group velocity dispersion (GVD) and polarization mode dispersion (PMD) compensator is demonstrated in short pulse fiber optical transmission systems.

Dispersion compensation in an open-loop all-optical chaotic communication system

The optical chaotic communication system using open-loop fiber transmission is studied under strong injection conditions. The optical chaotic communication system with open-loop configuration is studied using fiber transmission under strong injection conditions. The performances of fiber links composed of two types of fiber segments in different dispersion compensation maps are compared by testing the quality of the recovered message with different bit rates and encrypted by chaotic modulation （CM） or chaotic shift keying （CSK）. The result indicates that the performance of the pre-compensation map is always worst. Two types of symmetrical maps are identical whatever the encryption method and bit-rate of message are. For the transmitting and the recovering of message of lower bit rate （1 Gb/s）, the post-compensation map is the best scheme. However, for the message of higher bit rate （2.5 Gb/s）, the parameters in communication system need to be modified properly in order to adapt to the high-speed application. Meanwhile, two types of symmetrical maps are the best scheme. In addition, the CM method is superior to the CSK method for high-speed applications. It is in accordance with the result in a back-to-back configuration system.