The Effects of the Geometry of a Current Collector with an Equal Open Ratio on Output Power of a Direct Methanol Fuel Cell

The open ratio of a current collector has a great impact on direct methanol fuel cell(DMFC)performance.Although a number of studies have investigated the influence of the open ratio of DMFC current collectors,far too little attention has been given to how geometry(including the shape and feature size of the flow field)affects a current collector with an equal open ratio.In this paper,perforated and parallel current collectors with an equal open ratio of 50%and different feature sizes are designed,and the corresponding experimental results are shown to explain the geometry effects on the output power of the DMFC.The results indicate that the optimal feature sizes are between 2 and 2.5 mm for both perforated and parallel flow field in the current collectors with an equal open ratio of 50%.This means that for passive methanol fuel cells,to achieve the highest output power,the optimal feature size of the flow field in both anode and cathode current collectors is between 2 and 2.5 mm under the operating mode of this experiment.The effects of rib and channel position are also investigated,and the results indicate that the optimum pattern depends on the feature sizes of the flow field.

Influence of opening ratios and directions of windows on natural smoke exhaust effect in atrium buildings

In this paper,the influence of different opening ratios and different opening directions of the windows on the natural smoke exhaust was studied through a series of real fire experiments and simulation analysis.Increasing the open area of the window could effectively improve the overall smoke exhaust effect.When the top windows were open and the opening ratio increased from 19.2%to 24.3%,the optical density was decreased by 12.4%.The average smoke exhaust rate per unit area of the window did not change significantly.Increasing the area of the natural smoke exhaust window could effectively increase the smoke exhaust rate and improve the overall effect of smoke extraction.When the top windows were open,the temperature rise on the top floor was 30.8%-47.5%lower while the visibility was 16.8%-21.9%higher than that when the side windows were open.

Hydrodynamic Characteristics of Square Heaving Plates with Opening Under Forced Oscillation

The existence of the heaving plates can improve the heaving motion performance of an offshore structure significantly by providing both extra added mass and damping.In the current research,numerical investigation is carried out on the hydrodynamic characteristics of both isolated square heaving plate and double square heaving plates with opening by an immersed boundary-lattice Boltzmann method.The effects on hydrodynamic performance of plates due to Keulegan-Carpenter(KC)number,frequency number,opening ratio,opening distribution and spacing of plates are examined.It is found that the heaving plates with optimized opening ratio can provide additional damping compared with the plates without opening.Better hydrodynamic characteristics of double plates can be obtained with the increase of plate spacing.

Effect of CO_(2) Opposing Multiple Jets on Thermoacoustic Instability and NO_(x) Emissions in a Lean-Premixed Model Combustor

This paper experimentally studied the effect of CO_(2) opposing multiple jets on the thermoacoustic instability and NO_(x) emissions in a lean-premixed model combustor.The feasibility was verified from three variables:the CO_(2) jet flow rate,hole numbers,and hole diameters of the nozzles.Results indicate that the control effect of thermoacoustic instability and NO_x emissions show a reverse trend with the increase of open area ratio on the whole,and the optimal jet flow rate range is 1-4 L/min with CO_(2) opposing multiple jets.In this flow rate range,the amplitude and frequency of the dynamic pressure and heat release signals CH~* basically decrease as the CO_(2) flow rate increases,which avoids high-frequency and high-amplitude thermoacoustic instability.The amplitude-damped ratio of dynamic pressure and CH*can reach as high as 98.75% and 93.64% with an optimal open area ratio of 3.72%.NO_(x) emissions also decrease as the jet flow rate increases,and the maximum suppression ratio can reach 68.14%.Besides,the flame shape changes from a steep inverted "V" to a more flat "M",and the flame length will become shorter with CO_(2) opposing multiple jets.This research achieved the synchronous control of thermoacoustic instability and NO_(x) emissions,which could be a design reference for constructing a safer and cleaner combustor.

Optimal design of gas distributor in fluidized bed for synthesis of silicone monomer

The structure of the gas distributor is closely related to the production efficiency of organosilicon monomers.To improve the production efficiency of organosilicon monomers,this study uses Eulerian-Eulerian two fluid model and proposes a design formula for the gas distributor to optimize the gas distributor.It is proposed that the pressure drop of the gas distributor,the velocity nonuniformity coefficient,the relative standard deviation of the solid holdup,and the solid particle dispersion coefficient are used to evaluate the performance of the gas distributor.The results show that the performance of the gas distributor is significantly improved when the opening ratioΦ=0.53%is optimized toΦ=0.18%,in which the relative standard deviation of the solid holdup is reduced by 22%,and the solid particle dispersion coefficient is reduced by 40%.On this basis,this article studies the influence of different arrangements of vent holes on gas-solid fluidization characteristics.The results show that the circular arrangement of vent holes is helpful to the mixing of gas and solid.