Damage Mechanism of Optical Films by High-power Laser

From sevenal models about damage mechanism, the damage mechanism of optical films and the factors which affect the damage threshold are described experimentally and theoretically. Some reasonable proposals are given in this paper on how to select the high-threshold films.

Study on optical compound films

Using the compound materials and double e-gun evaporation,the compound optical films have been successfully deposited on K9 glass substrate.The refractive index of optical compund films deposited in diffeent parameters have been measured and theoretical formula for calculation refractive index of compound films have been derived.It is shown that the experimental curve for the variation of refractive index with wavelength in 0.4￣1.4 μm region and the theoretical one agree very well.Using these films,the laser reflecting mirror has been successfully coated.

A Fiber Optic Sensor for 2,4-dichlorophenol Analysis based on Optical Composite Oxygen-sensitive Film

A novel fiber optic sensor based on optical composite oxygen-sensitive film was developed for determination of 2,4-dichlorophenol(DCP).The optical composite oxygen-sensitive film consists of tris(2,2’-bipyridyl)dichloro ruthenium(II)hexahydrate(Ru(bpy)3Cl2)as the fluorescence indicator and iron(III)tetrasulfophthalocyanine(Fe(III)PcTs)as bionic enzyme.A lock-in amplifier was used for detecting the lifetime of the composite oxygen-sensitive film by measuring the phase delay of the sensor head.The different variables affecting the sensor performance were evaluated and optimized.Under the optimal conditions(i e,pH 6.0,25℃,Fe(III)PcTs concentration of 5.0×10^-5 mol/L),the linear detection range,detection limit and response time of the fiber optic sensor are 3.0×10^-7-9.0×10^-5 mol/L,4.8×10^-8 mol/L(S/N=3),and 220 s,respectively.The sensor displays high selectivity,good repeatability and stability,which have good potentials in analyzing DCP concentration in practical water samples.

Electrical and Optical Properties of GaSe Thin Films

The structure, electrical transport, and optical properties of GaSe films fabricated by means of radio-frequency (RF) magnetron sputtering in Ar were investigated. The as-sputtered GaSe films were amorphous, and their optical energy gap Eg are 1.9～2.6 eV. The effect of the synthesis conditions on the optical and electrical properties of the GaSe films has also been studied

The Third-Order Nonlinear Optical Properties in Cobalt-Doped ZnO Films

We quantitatively investigate the third-order optical nonlinear response of Co-doped ZnO thin films prepared by magnetron sputtering using the Z-scan method. The two-photon absorption and optical Kerr effect are revealed to contribute to the third-order nonlinear response of the Co-doped ZnO films. The nonlinear absorption coefficient β is determined to be approximately 8.8 × 10-5 cm/W and the third-order nonlinear susceptibility X（3） is 2.93 × 10-6 esu. The defect-associated energy levels within the band gap are suggested to be responsible for the enhanced nonlinear response observed in Co-doped ZnO films.

Optical properties of titanium oxide films obtained by cathodic arc plasma deposition

Structural and optical properties of nanometric titanium oxide（TixOy） films obtained by cathodic arc plasma deposition were investigated. Phase analysis by x-ray diffraction and Fouriertransform infrared spectroscopy showed the presence of anatase, rutile, Ti_2O_3, Ti_4O_7 and amorphous phases. Scanning electron microscopy images showed well-developed surface morphology with nano-patterns. Spectroscopic ellipsometry revealed film thicknesses of 53 and50 nm, variable refractive indices dependent on the light wavelength and close to zero extinction coefficients for wavelengths higher than 500 nm. On the basis of ultraviolet–visible spectroscopy data and using the Tauc equation, band gap values for direct and indirect electron transitions were determined.

Structural, Optical and Luminescence Properties of ZnO Thin Films Prepared by Sol-Gel Spin-Coating Method： Effect of Precursor Concentration

Transparent zinc oxide（ZnO） thin films are fabricated by a simple sol-gel spin-coating technique on glass substrates with different solution concentrations（0.3-1.2 M） using zinc acetate dehydrate [Zn（CH_3COO）_2·2H_2O] as precursor and isopropanol and monoethanolamine（MEA） as solvent and stabilizer, respectively. The molar ratio of zinc acetate dehydrate to MEA is 1.0. X-ray diffraction, ultraviolet-visible spectroscopy and photoluminescence spectroscopy are employed to investigate the effect of solution concentration on the structural and optical properties of the ZnO thin films. The obtained results of all thin films are discussed in detail and are compared with other experimental data.

Effect of Oxygen Concentration and Annealing Theatment on the Optical Properties of the Transparent Conductive CdIn_2O_4 Thin Films

Transparent conductive cadmium indium oxide films (CdIn2O4) were prepared by r.f. reactive sputtering from Cd-In alloy targets under an Ar-O2 atmosphere. Electrical conductivity of the order of 105Ω-1.m-1 and the optical transmission as high as 94% are easily attained by postdeposition annealing treatment. The effects of oxygen concentration in the reactive gas mixture and post-deposition annealing treatment on the optical transmittance as well as optical parameters, such as refractive index (n), extinction coefficient (k), real part (ε') and imaginary part (ε') of the dielectric constant, were studied in the visible and near-infrared region. The highfrequency dielectric constant ε∞ the plasma frequency ωP, and the conduction band effective mass mc of different samples were also investigated

Photoinduced Reorientation Process and Nonlinear Optical Properties of Ag Nanoparticle Doped Azo Polymer Films

Azobenzene polymer films doped with and without Ag nanoparticles are prepared. The photoinduced reorientation process is investigated by using an Nd：YVO4 pump beam at 532 nm and a low semiconductor laser beam at 650 nm. The reorientation rate of azo polymer films is enhanced in the presence of Ag nanoparticles, and the rate of the azo polymer film with Ag concentration of 2.2 μg/ml is larger than that of the azo polymer films with Ag concentrations of 1.1 μg/ml and 4.4 μg/ml. The third-order nonlinear optical properties of the Ag/azo composite film are obtained by the Z-scan technique at a wavelength of 532 nm, and the measured nonlinear refractive index is 9.258×10-9 esu. It is shown that the main mechanisms involved in the large nonlinear optical responses come from the local field enhancement of Ag nanoparticles and the nonlinear effect of the azo polymer matrix.

Structural, Optical and Electrical Properties of Evaporated CdSe Films

CdSe films are of great interest for use in thin film photoelectric devices. A simple chemical precipitation method is adopted for the first time to synthesise CdSe powder. Films on glass obtained at different substrate temperatures TS such as 300, 373, 423 and 473 K have been characterised by X-ray diffraction, optical absorption and Hall measurements.

Dependence of Nitrogen/Argon Reaction Gas Amount on Structural,Mechanical and Optical Properties of Thin WNx Films

WNxfilms are deposited by reactive chemical vapor deposition at different amounts of nitrogen in gas mixtures.Experimental data demonstrate that nitrogen amount has a strong effect on microstructure, phase formation,texture morphology, mechanical and optical properties of the WNxfilms. With increasing nitrogen a phase transition from a single WNxphase with low crystallinity structure to a well-mixed crystallized hexagonal WNxand face-centered-cubic W2N phases appears. Relatively smooth morphology at lower N2concentration changes to a really smooth morphology and then granular with coarse surface at higher N2concentration. The SEM observation clearly shows a columnar structure at lower N2concentration and a dense nanoplates one for higher nitrogen content. The hardness of WNxthin films mainly depends on the film microstructure. The absorbance peak position shifts to shorter wavelength continuously with increasing nitrogen amount and decreasing particle size.

Relationship Between Thermal Stability and Optical Bandgap of Fluorinated Amorphous Carbon Films

Fluorinated amorphous carbon films were deposited using microwave electron cyclotron resonance chemical vapor deposition (ECR-CVD) reactor with CF4 and C8H6 as source gas and were annealed in nitrogen ambience for the investigating of their thermal stability .The relative concentration of C=C bond and optical bandgap were obtained by Fourier Transform Infrared (FTIR) spectroscopy and Ultraviolet-Visible (UV-VIS ) spectrum, respectively. It has been demonstrated that there is a close relationship between relative concentration of C=C bond and optical bandgap, and the films deposited at a higher microwave power have a lower optical bandgap and a better thermal stability.

Effect of Pre-heating Temperature on Structural and Optical Properties of Sol-gel Derived Zn_(0.8)Cd_(0.2)O Thin Films

Zn_（0.8）Cd_（0.2）O thin films prepared using the spin-coating method were investigated. X-ray diffraction, scanning electron microscopy, and UV-Vis spectrophotometry were employed to illustrate the effects of the pre-heating temperature on the crystalline structure, surface morphology and transmission spectra of Zn_（0.8）Cd_（0.2）O thin films. When the thin films were pre-heated at 150 ℃, polycrystalline Zn O thin films were obtained. When the thin films were pre-heated at temperatures of 200 ℃ or higher, preferential growth of Zn O nanocrystals along the c-axis was observed. Transmission spectra showed that thin films with high transmission in the visible light range were prepared and effective bandgap energies of these thin films decreased from 3.19 e V to 3.08 e V when the pre-heating temperature increased from 150 ℃ to 300 ℃.

Gap States of ZnO Thin Films by New Methods:Optical Spectroscopy,Optical Conductivity and Optical Dispersion Energy

The optical reflectance and transmittance spectra in the wavelength range of 300-2500 nm are used to compute the absorption coefficient of zinc oxide films annealed at different post-annealing temperatures 400, 500 and 600°C.The values of the cross point between the curves of the real and imaginary parts of the optical conductivity ɑ_1 and ɑ_1 with energy axis of films exhibit values that correspond to optical gaps and are about 3.25-3.3 eV. The maxima of peaks in plots dR/dλ and dT/dλ versus wavelength of films exhibit optical gaps at about 3.12-3.25 eV.The values of the fundamental indirect band gap obtained from the Tauc model are at about 3.14-3.2 eV. It can be seen that films annealed at 600°C have the minimum indirect optical band gap at about 3.15 eV. The films annealed at 600°C have Urbach＇s energy minimum of 1.38 eV and hence have minimum disorder. The dispersion energy d of films annealed at 500°C has the minimum value of 43 eV.

(Al_xGa_(1-x))_yIn_(1-y)P Films and Its Optical Constants on the Surface

The optical parameters for three samples of intrinsic, doped Si and doped Mg (Al x Ga 1- x ) y In 1- y P prepared by the MOCVD on GaAs substrate were measured by using ellipsometry and were calculated by the two-layer absorption film model. The results obtained were discussed. The grown rates and thickness of oxidic layer on the intrinsic (Al x Ga 1- x ) y In 1- y P surface exposed in the atmosphere were studied. A linear dependence of oxidic layer thickness on the time was obtained.

Brightness of Blue/Violet Luminescent Nano-Crystalline AZO and IZO Thin Films with Effect of Layer Number:For High Optical Performance

From different reports, it （AZO） and indium-doped including usage areas. We nanocrystalline films with is realized that there is a need to consider all sides of aluminum-doped zinc oxide zinc oxide （IZO） thin films with their optical, luminescence and surface properties establish an assessment to carry out further information to summarize AZO and IZO impact of the layer number.

RESONANT PHOTOEMISSION OF BULK CeO_(2) AND NANO-CeO_(2) FILMS

Photoemission behaviors of nano-CeO2 films with particle sizes ranging from 8 nm to 50 nm and bulk CeO2 in Ce 4 d-4 f absorption region have been investigated. Resonant enhancements of Ce 4 f valance band and Ce 5 p bands for nano film and bulk material have been observed. The variation of electron density of states in valance bands of nano and bulk structures of CeO2 is discussed in terms of Ce 4 d-4 f resonance.

Dependence of surface morphology of CVD diamond films on deposition conditions

The diamond films have been deposited by the hot filament CVD method on molybdenum substrates from the mixture reactant gas of acetone and hydrogen.The surface morphologies of the obtained diamond films under various deposition conditions have been observed by scanning electron microscope(SEM).The experimental results strongly indicate that the surface morphologies of the resulting films have closely related to the deposition conditions,i.e.,reaction pressure.For molybdenum substrates,under the lower reaction pressure the surface morphologies of the grains comprising the resulting films mainly display the small single crystal cubo-octahedron and double small crystal cubo-octahedron;under the higher reaction pressure,the surface morphologies mainly display the large cauliflower-like.These results show that there are various crystal habits for CVD diamond under various deposition conditions.

Design of non-polarizing thin film edge filters

The separation between s- and p-polarization components invariably affects thin film edge filters used for tilted incidence and is a difficult problem for many applications, especially for optical communication. This paper presents a novel design method to obtain edge filters with non-polarization at incidence angle of 45°. The polarization separation at 50% trans-mittance for a long-wave-pass filter and a short-wave-pass filter is 0.3 nm and 0.1 nm respectively. The design method is based on a broadband Fabry-Perot thin-film interference filter in which the higher or lower interference band at both sides of the main transmittance peak can be used for initial design of long-wave-pass filter or short-wave-pass filter and then can be refined to reduce the transmittance ripples. The spacer 2H2L2H or 2L2H2L of the filter is usually taken. Moreover, the method for expanding the bandwidth of rejection and transmission is explained. The bandwidth of 200 nm for both rejection region and transmission band is obtained at wavelength 1550 nm. In this way, the long-wave-pass and short-wave-pass edge filters with zero separation between two polarization components can easily be fabricated.

Microstructure Control of Nanoporous Silica Thin Film Prepared by Sol-gel Process

Nanoporous silica films were prepared by sol-gel process with base, acid and base/acid two-step catalysis.Transmission electron microscope （TEM） and particle size analyzer were used to characterize the microstructure and the particle size distribution of the sols. Scanning electron microscopy （SEM）, atomic force microscopy （AFM） and spectroscopic ellipsometer were used to characterize the surface microstructure and the optical properties of the silica films. Stability of the sols during long-term storage was investigated. Moreover,the dispersion relation of the optical constants of the silica films, and the control of the microstructure and properties of the films by changing the catalysis conditions during sol-gel process were also discussed.