Optimization of Extraction and Characterization of Pectin from Grapefruit Peels

In this study, pectin was extracted from grapefruit peels with hydrochloric acid and precipitated with 95% ethanol solution and 5% tartaric acid. The physical and chemical properties of pectin obtained were analyzed, including color, texture, degree of esterification, and water solubility. The effects of peel to sol- vent ratio, pH of the solvent, extraction temperature and extraction duration on pectin extraction rate were investigated. On the basis of single-factor experiments, an L9 （34） orthogonal experiment was performed to screen the optimal extraction conditions. According to the results, the optimal combination of technical parame- ters was A1B3 C1 D3, i. e. , solid to liquid ratio 1：40 （g： ml）, pH 2.0, extraction duration 70 rain, extraction temperature 90 ℃. The average pectin extraction rate was 68.60% ; the color of pectin extracted under the optimal conditions varied from milky white to light yellow; the degree of esterification of pectin extracts was 65. 71% ; the extracted pectin exhibited good water solubility. Key words Pomelo peel; Pectin extraction; Optimum conditions; Esterification degree; Water solubility

Study on Extraction of Pectin from Orange Peels

The comparison was conducted to investigate the higher extraction rate between two methods including alcohol deposition with acid hydrolysis and micro- wave-assistant extraction technique. The experimental results showed that the former method led to a better extraction effect. For the method of alcohol deposition with acid hydrolysis, the technique parameters were optimized through I.s （34 ） orthogonal e^periment based on the results of single factor experiments, after investi- gated the effect of solid to liquid ratio, pH, extraction temperature and extraction time on the pectin extraction rate. tersrm technique was employed to extract pectin. The selected parameter was obtained by means On the basis of the optimal technical parmne- of L16 （45） orthogonal experiment after studied the effect of solid to liquid ratio, extraction temperature, microwave treatment period, pH and microwave power on pectin extraction yield. Repetitive examinations of two methods were carried out separately, pectin extraction rate with the fLrst technique was 14.57% and that with the second method was 11.62%. The charac- teristics of the pectin sample prepared by alcohol deposition with acid hydrolysis were further investigated. The research demonstrated that mass percent of pectin was 87.23%. The esterification degree of pectin was 75.66% ,and pectin sample color was from creamy white to pale yellow.

Study on Processing of Clear Banana Juice Using Hot Water Extraction Method

In this study, the effects of hot water temperature on clarity, total soluble solids, polyphenol oxidase （PPO） and color of banana juice during hot water ex-traction were discussed based on the theory in which heat treatment might induce the pectin and protein in banana pulp to form insoluble products. The results showed the hot water temperature had a significant effect on the formation of insol-uble polymers in banana pulp from pectin and protein. In 75 ℃ water, the pectin and protein in banana pulp were most inclined to form insoluble products. Under this condition, the clarity of banana juice was also highest. The light transmittance at 660 nm was close to 90%. In the banana juice, extracted by 75 ℃ water, the pectin and protein contents were lowest, and they were lower than 7.3 mg/100 ml and 12.9 mg/100 ml respectively. The 75 ℃ water could not inactivate completely the pectin in banana pulp due to its high heat resistance, Therefore, 0.05% L-cys-teine or ascorbic acid needed to be added into banana pulp to inhibit the browning of juice induced by residual PPO.

Relationship between Pectic Substances and Strand Separation of Cooked Spaghetti Squash--Part 2. Changes in Firmness, Histological Structure and Pectic Substances during Soaking in Pectin Extractants

The flesh of spaghetti squash separates into strands when cooked. The purpose of this paper is to investigate the cause of strand separation （during cooking） by soaking for 24 h at 35 ℃ in solutions with three kinds of pectin extractant. The changes in strand separation, firmness, histological structure and the pectin of flesh during soaking in 0.01 N HCI solution （pH 2.0）, 0.035 M ammonium oxalate solution （pH 4.0） or 2% sodium hexametaphosphate solution （pH 4.0） were investigated. When flesh was soaked in the HCI solution, the separation into strands and removal of calcium and magnesium were greater than that soaked in other pectin extractants. High methoxyl pectin was extracted by soaking in HC1 solution （pH 2.0） due to removal of polyvalent cations. This result shows that high methoxyl pectin glues strands together in the flesh of spaghetti squash. The shape of the cells which constituted strands was round; on the other hand, that of cells surrounded strands was elongated. When cooked in boiling water or soaked at pH 2.0, the shape of the former cells was maintained, but the latter cells, which contributed to adhesion between strands, broke down. Thus, the flesh separated into strands. When flesh was boiled for 15-30 min, pectin degraded and dissolved in the cooking solution; consequently, the flesh separated into strands and also the middle lamella of cell walls of strands separated. However, pectin remaining in strands maintained their crispness.

Removal of methyl orange from aqueous solution by Azolla filicoloides:Synthesis of Fe_3O_4 nano-particles and its surface modification by the extracted pectin of Azolla

The modified Fe3O4 nanoparticles with the extracted pectin from the cell wall of Azolla filicoloides（FNEP） can remove methyl orange as a watersoluble azo dye from waste water better than Azolla and the extracted pectin from Azolla（EPA）,alone.It could be due to more crowding the main functional groups of uptake after binding pectin with nanoparticles.Thermodynamic studies showed that adsorption equilibrium constant（KL） and maximum adsorption capacities（Q（max）） were increased with decreasing temperature（exothermic）.The maximum uptake capacity（Q（max）） of dye by FNEP in a batch reactor was 0.533,0.498 and 0.446 mmol/g at 5,25 and 50℃,respectively.The enthalpy change（△H） and entropy change（△S） were 15.31 kJ/mol and 0.02434 kJ/mol K,respectively.