Assessment of Dependent Performance Shaping Factors in SPAR-H Based on Pearson Correlation Coefficient

With the improvement of equipment reliability,human factors have become the most uncertain part in the system.The standardized Plant Analysis of Risk-Human Reliability Analysis(SPAR-H)method is a reliable method in the field of human reliability analysis(HRA)to evaluate human reliability and assess risk in large complex systems.However,the classical SPAR-H method does not consider the dependencies among performance shaping factors(PSFs),whichmay cause overestimation or underestimation of the risk of the actual situation.To address this issue,this paper proposes a new method to deal with the dependencies among PSFs in SPAR-H based on the Pearson correlation coefficient.First,the dependence between every two PSFs is measured by the Pearson correlation coefficient.Second,the weights of the PSFs are obtained by considering the total dependence degree.Finally,PSFs’multipliers are modified based on the weights of corresponding PSFs,and then used in the calculating of human error probability(HEP).A case study is used to illustrate the procedure and effectiveness of the proposed method.

Thermal performance assessment of self-rotating twisted tapes and Al_(2)O_(3) nanoparticle in a circular pipe

In view of the practical importance of the heat transfer devices in various thermal engineering fields including chemical and nuclear engineering,this study aims at developing an effective method of heat transfer enhancement by using selfrotating twisted tapes(SRTTs)and Al_(2)O_(3) nanoparticles.The effect of the selfrotating twisted tapes and Al2O3 nanoparticles on the thermal performance was comprehensively investigated in a circular pipe.The experimental results indicated the heat transfer rate was effectively improved by SRTTs in comparison of plain tube.In addition,the heat transfer multiplier with SRTTs decreased from 1.38 to 1.08 with the Reynolds number increasing from 19,322 to 64,407,while the friction factor multiplier decreased from 1.61 to 1.32.Besides,the results indicated that the employment of Al_(2)O_(3) nanoparticles and SRTTs demonstrated superior thermal performance to the single SRTTs.As Reynolds number increases from 19,322 to 64,407,the heat transfer multiplier decreased from 2.08 to 1.18 in the mass concentration of 3.0%and from 1.38 to 1.08 in mass concentration of 0.0%.Finally,the new heat transfer and friction factor correlations considering the combined effect of Al2O3 nanoparticle and SRTTs were developed within 10%deviation of experimental values.

Evaluation of Driver-Induced Human Errors in Smart Construction Tower Crane Operations Based on DEMATEL-ISM-MICMAC

With the advent of Industry 4.0, smart construction sites have seen significant development in China. However, accidents involving digitized tower cranes continue to be a persistent issue. Among the contributing factors, human unsafe behavior stands out as a primary cause for these incidents. This study aims to assess the human reliability of tower crane operations on smart construction sites. To proactively enhance safety measures, the research employs text mining techniques (TF-IDF-Truncated SVD-Complement NB) to identify patterns of human errors among tower crane operators. Building upon the SHEL model, the study categorizes behavioral factors affecting human reliability in the man-machine interface, leading to the establishment of the Performance Shaping Factors (PSFs) system. Furthermore, the research constructs an error impact indicator system for the intelligent construction site tower crane operator interface. Using the DEMATEL method, it analyzes the significance of various factors influencing human errors in tower crane operations. Additionally, the ISM-MICMAC method is applied to unveil the hierarchical relationships and driving-dependent connections among these influencing factors. The findings indicate that personal state, operating procedures, and physical environment directly impact human errors, while personal capability, technological environment, and one fundamental organizational management factor contribute indirectly. .

Design and Optimization of a Hybrid Energy System for Decentralized Heating

The performances of a hybrid energy system for decentralized heating are investigated.The proposed energy system consists of a solar collector,an air-source heat pump,a gas-fired boiler and a hot water tank.A mathematical model is developed to predict the operating characteristics of the system.The simulation results are compared with experimental data.Such a comparison indicates that the model accuracy is sufficient.The influence of the flat plate solar collector area on the economic and energy efficiency of such system is also evaluated through numerical simulations.Finally,this system is optimized using the method of orthogonal design.The results clearly demonstrate that the solar-heat pump-gas combined system is more convenient and efficient than the simple gas system and the heat pump-gas combined system,whereas it is less convenient but more efficient than the solarassisted gas system.

Engineering approach for human error probability quantification

A novel approach for engineering application to human error probability quantification is presented based on an overview of the existing human reliability analysis methods. The set of performance shaping factors is classified as two subsets of dominant factors and adjusting factors respectively. Firstly, the dominant factors are used to determine the probabilities of three behavior modes. The basic probability and its interval of human error for each behavior mode are given. Secondly, the basic probability and its interval are modified by the adjusting factors, and the total probability of human error is calculated by a total probability formula. Finally, a simple example is introduced, and the consistency and validity of the presented approach are illustrated.

Cells grouping scheme against pilot contamination in large scale antennas system

The influence of cells groupings factor to the performance of the cells groupings time-shift pilot scheme is researched for the multiple cells large scale antennas systems（LSAS）. The former researches have confirmed that the cells groupings time-shift pilots scheme is effective to reduce inter-cell interference, especially pilot contamination, which results from the pilot reuse in adjacent cells. However, they have not specified reasonable cells groupings factor, which plays a critical role in the general performance of the LSAS. Therefore, this problem is researched in details. The time for reverse-link data transmission will be compressed, when the groupings factor surpasses a certain range. Thus it is not always beneficial to increase the cells groupings factor without limitation. Furthermore,a reasonable cells groupings factor is deduced from the perspective of optimization to enhance the system performance. Simulations verify the proposed cell grouping factor.

Evaluation on the Factors Concerning the Urban Economic Performance

ＥｖａｌｕａｔｉｏｎｏｎｔｈｅＦａｃｔｏｒｓＣｏｎｃｅｒｎｉｎｇｔｈｅＵｒｂａｎＥｃｏｎｏｍｉｃＰｅｒｆｏｒｍａｎｃｅ￥ＬｉｎＺｈｅｎｇｕｏ；ＬｉｕＹｉｎｇｃｈｕｎ（ＳｈａｎｇｈａｉＡｃａｄｅｍｙｏｆＳｏｃｉａｌＳｃｉｅｎｃｅｓ；ＢｕｓｉｎｅｓｓＭａ...

Behaviour of self-centring shear walls——A state of the art review

The application of unbonded post-tensioning (PT) in structural walls has led to the development of advanced self-centring (rocking) shear wall systems that has significant advantages, including accelerated construction due to the incorporation of prefabricated elements and segmental construction for different materials (e.g., concrete, masonry, and timber), reduced residual drifts, and little damage upon extreme seismic and wind loads. Concrete, masonry, and timber are often used for the construction of unbonded PT structural wall systems. Despite extensive research since the 1980s, there are no well-established design guidelines available on the shear wall configuration with the required energy dissipation system, joint’s locations and acceptance criteria for shear sliding, confinement, seismic performance factors, PT loss, PT force range and residual drifts of shear walls subjected to lateral loads. In this research a comprehensive state-of-the-art literature review was performed on self-centring shear wall system. An extensive study was carried out to collect a database of 100 concrete, masonry, and self-centring shear wall tests from the literature. The established database was then used to review shear walls’ configurations, material, and components to benchmark requirements applicable for design purposes. The behaviour of concrete, masonry and timber shear walls were compared and critically analysed. The general behaviour, force-displacement performance of the walls, ductility, and seismic response factors, were critically reviewed and analysed for different self-centring wall systems to understand the effect of different parameters including configurations of the walls, material used for construction of the wall (concrete, masonry, timber) and axial stress ratio. The outcome of this research can be used to better understand the behaviour of self-centring wall system in order to develop design guidelines for such walls.

Aging of PVDF and PES ultrafiltration membranes by sodium hypochlorite:Effect of solution pH

Sodium hypochlorite(NaClO)is a commonly applied cleaning agent for ultrafiltration membranes in water and wastewater treatment.Long-term exposure to NaClO might change the properties and performance of polymeric membranes,and ultimately shorten membrane lifespan.Active species in NaClO solution vary with solution pH,and the aging effects can change depending on the membrane material.In this study,the aging of polyvinylidene fluoride(PVDF)and polyethersulfone(PES)membranes by NaClO at pH 3–11 was investigated by examining variations in chemical composition,surface charge,surface morphology,mechanical strength,permeability,and retention ability.Polyvinyl pyrrolidone(PVP),which was blended in both membranes,was oxidized and dislodged due to NaClO aging at all investigated pH values,but the oxidation products and dislodgement ratio of PVP varied with solution pH.For the PVDF membrane,NaClO aging at pH 3–11 caused a moderate increase in permeability and decreased retention due to the oxidation and release of PVP.The tensile strength decreased only at pH 11 because of the defluorination of PVDF molecules.For the PES membrane,NaClO aging at all investigated pH resulted in chain scission of PES molecules,which was favored at pH 7 and 9,potentially due to the formation of free radicals.Therefore,a decrease in tensile strength and retention ability,as well as an increase in permeability,occurred in the PES membrane for NaClO aging at pH 3–11.Overall,the results can provide a basis for selecting chemical cleaning conditions for PVDF and PES membranes.