采用柠檬酸-硝酸盐自蔓延燃烧法分别合成了Pr_(0.6)Sr_(0.4)Co_(0.2)Fe_(0.8)O_(3-δ)(PSCF)和Gd_(0.2)Ce_(0.8)O_(2-δ)(GDC)粉体,高温固相法合成La_(0.9)Sr_(0.1)Ga_(0.8)Mg_(0.2)O_(3-δ)(LSGM)电解质粉体。以LSGM为电解质,PSCF同时...采用柠檬酸-硝酸盐自蔓延燃烧法分别合成了Pr_(0.6)Sr_(0.4)Co_(0.2)Fe_(0.8)O_(3-δ)(PSCF)和Gd_(0.2)Ce_(0.8)O_(2-δ)(GDC)粉体,高温固相法合成La_(0.9)Sr_(0.1)Ga_(0.8)Mg_(0.2)O_(3-δ)(LSGM)电解质粉体。以LSGM为电解质,PSCF同时作为阴极和阳极,GDC作为功能层材料,构建了对称固体氧化物燃料电池PSCF│GDC│LSGM│GDC│PSCF。利用X射线衍射法研究材料的成相以及相互间的化学稳定性,交流阻抗法记录界面极化行为,用扫描电子显微镜观察电池的断面微结构,用自组装的测试系统评价电池输出性能。结果表明,合成的PSCF粉体呈立方钙钛矿结构,具有良好的氧化–还原可逆性。使用GDC功能层明显改善了氢气环境下PSCF与LSGM材料间的化学相容性以及电池的输出性能,800℃时,电极│电解质界面极化电阻从6.892?·cm^2下降到0.314?·cm^2;以加湿H_2(含体积分数3%的水蒸气)为燃料气,空气为氧化气时,单电池输出功率密度由269 m W/cm2增大至463 m W/cm^2。研究结果显示,PSCF是对称固体氧化物燃料电池良好的候选电极材料,GDC功能层对改善电池长期稳定性能具有潜在的应用价值。展开更多
The resistive switching properties in amorphous Pr0.67Sr0.33MnO3 films deposited by pulsed laser deposition are investigated.Reproducible and bipolar counter-8-shape and 8-shape switching behaviours of Au/Pr0.67Sr0.33...The resistive switching properties in amorphous Pr0.67Sr0.33MnO3 films deposited by pulsed laser deposition are investigated.Reproducible and bipolar counter-8-shape and 8-shape switching behaviours of Au/Pr0.67Sr0.33MnO3 /F：SnO2 junctions are obtained at room temperature.Dramatically,the coexistence of two switching polarities could be reversibly adjusted by an applied voltage range.The results allocated those two switching types to areas of different defect densities beneath the same electrode.The migration of oxygen vacancies and the trapping effect of electrons under an applied electric field play an important role.An interface-effect-related resistance switching is proposed in an amorphous Pr0.67Sr0.33MnO3-based memory cell.展开更多
Red phosphors, Li2Sr0.996 Si O4： Pr3＋0.004, with different hydrothermal conditions were prepared via hydrothermal synthesis and then heat-treatment. The chemical structures of the phosphors were identified with X-ra...Red phosphors, Li2Sr0.996 Si O4： Pr3＋0.004, with different hydrothermal conditions were prepared via hydrothermal synthesis and then heat-treatment. The chemical structures of the phosphors were identified with X-ray diffraction（XRD）. Surface morphological features were observed by scanning electron microscopic（SEM） investigation. Spectra of excitation and emission for the phosphors were also obtained by a spectrophotometer. Results showed that the optimum conditions were as follows： p H value of solution was 1–2, reaction temperature was at 180 oC for 24 h. The as-prepared phosphors exhibited two excitation dominant peaks at 451 and 486 nm, attributed to transitions of 3H4→3P2 and 3H4→3P0 of Pr3＋, respectively. A narrow emission peak at 610 nm corresponded to the energy level transition of 3P0→3H6 of Pr3＋ under excitation of light at 451 nm, which indicated promising candidate red phosphors for blue LED chips.展开更多
The La0.67Sr0.33MnO3 +δ/Pr0.7Ca0.3MnO3 +δ/La0.67Sr0.33MnO3 +δ(LPL) trilayered films on (100)LaA-1O3 substrates are prepared by using direct current (DC) magnetron sputtering method. The results obtained by means of...The La0.67Sr0.33MnO3 +δ/Pr0.7Ca0.3MnO3 +δ/La0.67Sr0.33MnO3 +δ(LPL) trilayered films on (100)LaA-1O3 substrates are prepared by using direct current (DC) magnetron sputtering method. The results obtained by means of X-ray powder diffractometer show that all films are the high quality epitaxial films. The results gained by SQUID magnetometer indicate that there is a magnetic coupling in the LPL trilayered films. The resistivities of LSMO, PC-MO and LPL films are measured using standard four-probe method and analyzed log ρ/T curve. From the results it is concluded that the middle-layered PCMO which is ferromagnetic may play a role of intra-magnetic field, which weakens the paramagnetism of LSMO film, lowers ρmax and enlarges Tp which is the transition temperature from metal to insulator, just as the applied magnetic field does. And the middle-layered PCMO may induce the change of the density of states in the LSMO' s gap. The two reasons above make the resistivity and Tp of the samples in zero field change with the thickness of PCMO layers.展开更多
文摘采用柠檬酸-硝酸盐自蔓延燃烧法分别合成了Pr_(0.6)Sr_(0.4)Co_(0.2)Fe_(0.8)O_(3-δ)(PSCF)和Gd_(0.2)Ce_(0.8)O_(2-δ)(GDC)粉体,高温固相法合成La_(0.9)Sr_(0.1)Ga_(0.8)Mg_(0.2)O_(3-δ)(LSGM)电解质粉体。以LSGM为电解质,PSCF同时作为阴极和阳极,GDC作为功能层材料,构建了对称固体氧化物燃料电池PSCF│GDC│LSGM│GDC│PSCF。利用X射线衍射法研究材料的成相以及相互间的化学稳定性,交流阻抗法记录界面极化行为,用扫描电子显微镜观察电池的断面微结构,用自组装的测试系统评价电池输出性能。结果表明,合成的PSCF粉体呈立方钙钛矿结构,具有良好的氧化–还原可逆性。使用GDC功能层明显改善了氢气环境下PSCF与LSGM材料间的化学相容性以及电池的输出性能,800℃时,电极│电解质界面极化电阻从6.892?·cm^2下降到0.314?·cm^2;以加湿H_2(含体积分数3%的水蒸气)为燃料气,空气为氧化气时,单电池输出功率密度由269 m W/cm2增大至463 m W/cm^2。研究结果显示,PSCF是对称固体氧化物燃料电池良好的候选电极材料,GDC功能层对改善电池长期稳定性能具有潜在的应用价值。
基金Project supported by the National Natural Science Foundation of China (Grant No. 60976016)the Program for Innovative Research Team in Science and Technology in University of Henan Province (IRTSTUHN),China (Grant No. 2012IRTSTHN004)the Foundation Co-established by the Province and the Ministry in Henan University,China (Grant No. SBGJ090503)
文摘The resistive switching properties in amorphous Pr0.67Sr0.33MnO3 films deposited by pulsed laser deposition are investigated.Reproducible and bipolar counter-8-shape and 8-shape switching behaviours of Au/Pr0.67Sr0.33MnO3 /F：SnO2 junctions are obtained at room temperature.Dramatically,the coexistence of two switching polarities could be reversibly adjusted by an applied voltage range.The results allocated those two switching types to areas of different defect densities beneath the same electrode.The migration of oxygen vacancies and the trapping effect of electrons under an applied electric field play an important role.An interface-effect-related resistance switching is proposed in an amorphous Pr0.67Sr0.33MnO3-based memory cell.
基金Project supported by the Fujian Provincial Key Project(2013H6020)
文摘Red phosphors, Li2Sr0.996 Si O4： Pr3＋0.004, with different hydrothermal conditions were prepared via hydrothermal synthesis and then heat-treatment. The chemical structures of the phosphors were identified with X-ray diffraction（XRD）. Surface morphological features were observed by scanning electron microscopic（SEM） investigation. Spectra of excitation and emission for the phosphors were also obtained by a spectrophotometer. Results showed that the optimum conditions were as follows： p H value of solution was 1–2, reaction temperature was at 180 oC for 24 h. The as-prepared phosphors exhibited two excitation dominant peaks at 451 and 486 nm, attributed to transitions of 3H4→3P2 and 3H4→3P0 of Pr3＋, respectively. A narrow emission peak at 610 nm corresponded to the energy level transition of 3P0→3H6 of Pr3＋ under excitation of light at 451 nm, which indicated promising candidate red phosphors for blue LED chips.
基金Project supported by the Chinese Academy of Sciences the Foundation of State ScienceTechnology Commission of China
文摘The La0.67Sr0.33MnO3 +δ/Pr0.7Ca0.3MnO3 +δ/La0.67Sr0.33MnO3 +δ(LPL) trilayered films on (100)LaA-1O3 substrates are prepared by using direct current (DC) magnetron sputtering method. The results obtained by means of X-ray powder diffractometer show that all films are the high quality epitaxial films. The results gained by SQUID magnetometer indicate that there is a magnetic coupling in the LPL trilayered films. The resistivities of LSMO, PC-MO and LPL films are measured using standard four-probe method and analyzed log ρ/T curve. From the results it is concluded that the middle-layered PCMO which is ferromagnetic may play a role of intra-magnetic field, which weakens the paramagnetism of LSMO film, lowers ρmax and enlarges Tp which is the transition temperature from metal to insulator, just as the applied magnetic field does. And the middle-layered PCMO may induce the change of the density of states in the LSMO' s gap. The two reasons above make the resistivity and Tp of the samples in zero field change with the thickness of PCMO layers.
