Steady State Rheological Characteristic of Semisolid Magnesium Alloy

Isothermal compressive experiments at different temperatures, strain rates and holding time for semisolid AZ91D, Zr modified AZ91D and MB15 alloy with higher solid volume fraction were carried out by using Gleeble-1500D simulator and the true stress-strain curves were given directly. The relationship of apparent viscosity vs temperature, shear rate and holding time of the three kinds of semi-solid magnesium alloys, as well as isothermal steady state rheological characteristic and mechanical behavior were studied. The results show that the three magnesium alloys had the characteristic of shear-thinning. The rheological characteristic of the semi-solid MB15 is different from that of semi-solid AZ91D. The semi-solid MB15 has higher apparent viscosity and deformation resistance.

Effects of pH on rheological characteristics and stability of petroleum coke water slurry

In this study, the effects of pH on slurrying properties of petroleum coke water slurry（PCWS） were investigated. The slurrying concentration, rheological characteristics and stability of PCWS were studied with four different types of additives at pH varying from 5 to 11.The results showed that the slurrying concentration, rheological characteristics and stability of PCWS all increased at first and then decreased with increasing pH from 5 to 11,and a pH of around 9 was found to be the most favorable acid–alkali environment to all these three slurrying properties. It was also indicated that only in a moderate alkaline environment can the additives be active enough to react with particle surfaces sufficiently to obtain good slurrying concentration and form a stable three-dimensional network structure, which can support strong pseudoplastic characteristics and good stability. An acid environment was a very unfavorable factor to the slurrying properties of PCWS.

Evaluation Indices of Interaction Ability of Asphalt and Aggregate Based on Rheological Characteristics

In order to find a parameter as the evaluation index that can capture the effect of the interaction between asphalt and aggregate, the rheological properties of asphalt mastics using two kinds of asphalts and four kinds of aggregates under different filler-asphalt ratios were measured by a dynamic shear rheometer （DSR）. Moreover, four rheological parameters of K.Ziegel-B, Luis Ibrarra-A, complex shear modulus ΔG＊and complex viscosity Δη＊ for evaluating the interaction ability were studied. Results indicate that all the four parameters can characterize the interaction ability of asphalt and aggregate correctly and feasibly. Through the comparison of sensitivities and physical meanings of the four parameters, K.Ziegel-B with high sensitivity and exact physical meaning is finally selected as the evaluation index for interaction ability of asphalt and aggregate.

Study on Rheological Characteristics of a Grease Used in High Speed Bearing

On a self-made super-high shear strain rate rheometer, the rheological characteristics and apparent viscosity curves of a high-speed bearing grease were obtained under different working conditions. A new grease rheological model suited to a shear strain rate range of 0—3.5×10~6s^(-1) was presented. The results showed that the shear stress increased linearly at first and then increased nonlinearly with the increase in shear strain rate up to 1.5×10~6s^(-1), and finally the shear stress decreased slightly with the successive increase in shear strain rate. The shear stress increased with a decreasing rolling speed and an increasing contact pressure. The apparent viscosity decreased rapidly with the increase of shear strain rate at beginning and could approach the viscosity of the base oil if the shear strain rate surpassed 1.5×10~6s^(-1). The fits between the test data and the predicted values by the new model were fairly good.

Analysis on damage and rheological characteristics of deep surrounding rock of shaft engineering

According to the characteristics of deep engineering surrounding rock main shaft of No.3 mining district in Jinchuan, electron microscope scanning and rock mechanics test were adopted to analyze the damage features of rock. The software of FLAG3D and Burgers body （Kelvin-Maxwell model） were used to research on rheological theory, and rheological model was modified. The results indicate that the damage of rock mass is very serious, and the rheological characteristics also outstanding; rheological behavior of deep surrounding rocks of the shaft can be taken as superposition of transient and stable rheology; and there exist the most dangerous zone on 100 m higher than 1 063 m level, so it is necessity that works of monitor and corresponding reinforcement should strengthen.

Rheological and Tribological Characteristics of the Synthesized Lubricants Derived from Vegetable Oils

The double bonds in the vegetable oils can be conjungated and Diels-Alder react when they are heated in the existence of the catalyst. The percent of the double bond will decrease and the oxidative stability of the vegetable oils can be ameliorated. Dimmer acid can react with different carbon chain length of alcohols to form dimmer acid esters. A series of dimmer acid esters were synthesized and their rheological characteristics （viscosity, viscosity index, pour point） and tribological characteristics （the coefficient of friction at different load, the characteristic of extreine pressure （ PB ）, the wear scare diameter （ D30min^196N ） were evaluated and analyzed. The results showed that the characteristics of Di-iso-octanol dimmer acid ester were the best among the synthesized dimmer esters. It＇ s a lubricant with good properties（the viscosity is 94.5 mm^2/s, the viscosity index is high up to 141 and the pour point is - 49℃ ）. It is a kind of newly interesthing ester type lubricant. Its rheological and tribological characteristics are even better than those of the slap-up synthesized lubricant--pentaerythritol esters （C7-9 acidate）. The FT-IR spectrophotometer was used to analyze the structure of the synthetic esters. Their IR spectra are the same as the typical IR spectrum of ester. The test indicated that Di-iso-octanol dimmer acid ester could be used as a kind of base lubricant with excellent quantity.

Comparison of Different Dough Rheological Measurement and Path Coefficient Analysis of Bread Quality

Farinograph, extensograph and mixograph are the special instruments used to determinedough rheological characteristics. In this study, twenty-seven wheat cultivars ofdifferent gluten strength were used to study the correlations among each rheologicalparameter determined by above instruments. Multiple linear regression analysis and pathcoefficient analysis were used to study the direct and indirect effects of 11 doughrheological characteristics on bread quality. The results showed significant correlationsamong the principal parameters. There were significantly or extremely significantlypositive correlations among development time (DT), stability time (ST), farinographquality number (FQN) of farinograph, area, maximum resistance (Rmax), viscoelastic ratio(Rmax/E)of extensograph and mixing time (MT), 8-minute-curve-tail (8MCT) of mixograph.These indexes affected bread-making quality either directly or indirectly. Of all theindexes, ST, maximum Rmax, MT and FQN were the most important ones.

SIMULATION OF MICROSTRUCTURE AND RHEOGICAL PROPERTIES OF SURFACTANT SOLUTION

The Brownian dynamics （BD） simulation of a dilute surfactant solution is conducted in a steady shear flow. The rodlike micelle is assumed as a rigid rod composed of lined-up beads. A novel intercluster potential model is introduced for describing the interactions between, micelles. In the model, the Lennard-Jones and the soft-sphere potentials are used as inter-bead potentials for end-end and interior-interior beads, respectively. The micelles are combined at their ends to form a network structure at lower shear rates and are disconnected to become more and more parallel to the shear flow direction with increasing shear rate. The change of micellar microstructures with the variation of the shear rate results in shear thinning characteristics of the computed shear viscosities and first normal stress difference coefficients. The effects of surfactant solution concentration on the micellar structures and rheological properties are also investigated. Results show that the shear viscosities and the first normal stress difference coefficients increase with increasing the viscosity of the surfactant solution.

Time-dependent safety of lining structures of circular tunnels in weak rock strata

Following tunnel excavation and lining completion,fractured surrounding rock deforms gradually over time;this results in a time-dependent evolution of the pressure applied to the lining structure by the surrounding rock.Thus,the safety of the tunnel lining in weak strata is strongly correlated with time.In this study,we developed an analytical method for determining the time-dependent pressure in the surrounding rock and lining structure of a circular tunnel under a hydrostatic stress field.Under the proposed method,the stress–strain relationship of the fractured surrounding rock is assumed to conform to that of the Burgers viscoelastic component,and the lining structure is assumed to be an elastomer.Based on these assumptions,the viscoelastic deformation of the surrounding rock,the elastic deformation of the lining structure,and the coordinated deformation between the surrounding rock and lining structure were derived.The proposed analytical method,which employs a time-dependent safety coefficient,was subsequently used to estimate the durability of the lining structure of the Foling Tunnel in China.The derived attenuation curve of the safety coefficient with respect to time can assist engineers in predicting the remaining viable life of the lining structure.Unlike existing analytical methods,the method derived in this study considers the time dependency of the interaction between the surrounding rock and tunnel lining;hence,it is more suitable for the evaluation of lining lifetime.

Numerical Study on Interaction Between Two Bubbles Rising Side by Side in CMC Solution

A numerical simulation was performed to investigate the interaction of two bubbles rising side by side in shear-thinning fluid using volume of fluid （VOF） method coupled with continuous surface force （CSF） method. By considering rheological characteristics of fluid, this approach was able to accurately capture the deformation of bubble interface, and validated by comparing with the experimental results. The rising of bubble pairs with different configurations, including horizontal alignment and oblique alignment, was simulated by the method. The influences of the bubble initial distance and the bubble alignment were studied by analyzing the bubble deformation, rising paths and flow fields surrounding bubbles. The results indicate that within certam mltlal bubble spacing of S = 3.3 （S＊ = SI/D, SI initial distance between bubbles, and D bubble diameter）, the dynamic interaction between two bub- bles aligned horizontally shows repulsive effect that decreases with the increase of initial bubble spacing, but weakens to certain degree by the shear-thinning properties of fluid. However, the interaction between two bubbles aligned obliquely presents a repulsive effect for the small angle involved but an attractive impact for the large one, which is vet strengthened by the rheological characteristics of fluid.

Improving slurryability, rheology,and stability of slurry fuel from blending petroleum coke with lignite

Petroleum coke and lignite are two important fossil fuels that have not been widely used in China. Petroleum coke-lignite slurry （PCLS）, a mixture of petro- leum coke, lignite, water, and additives, efficiently utilizes the two materials. In this study, we investigate the effects of the proportion （7） of petroleum coke on slurryability, rheo- logical behavior, stability, and increasing temperature characteristics of PCLSs. The results show that the fixed- viscosity solid concentration （COo） increases with increasing 7. The ~Oo of lignite-water slurry （LWS, ~ = 0） is 46.7 %, compared to 71.3 % for the petroleum coke-water slurry （PCWS, c~ --- i00 %）, while that of PCLS is in between the two values. The rheological behavior of PCLS perfectly fits the power-law model. The PCWS acts as a dilatant fluid. As decreases, the slurry behaves first as an approximate Newtonian fluid, and then turns into a pseudo-plastic fluid that exhibits shear-thinning behavior. With increasing ct, the rigid sedimentation and water separation ratio （WSR） increase, indicating a decrease in the stability of PCLS. When α is 60-70 %, the result is a high-quality slurry fuel for industrial applications, which has high slurryability （ω0 = 57-60 %）, good stability （WSR 〈 2 %）, and superior pseudo-plastic behavior （n = 0.9）.