As the infrared technology continues to advance, there is a growing demand for multispectral detectors for advanced IR systems with better target discrimination and identification. Both HgCdTe detectors and quantum we...As the infrared technology continues to advance, there is a growing demand for multispectral detectors for advanced IR systems with better target discrimination and identification. Both HgCdTe detectors and quantum well GaAs/AlGaAs photodetectors offer wavelength flexibility from medium wavelength to very long wavelength and multicolor capability in these regions. The main challenges facing all multicolor devices are more complicated device structtures, thicker and multilayer material growth, and more difficult device fabrication, especially when the array size gets larger and pixel size gets smaller. In the paper recent progress in development of two color HgCdTe photodiodes and quantum well infrared photodetectors is presented. More attention is devoted to HgCdTe detectors. The two color detector arrays are based upon an n P N (the capital letters mean the materials with larger bandgap energy) HgCdTe triple layer heterojunction design. Vertically stacking the two p n junctions permits incorporation of both detectros into a single pixel. Both sequential mode and simultaneous mode detectors are fabricated. The mode of detection is determined by the fabrication process of the multilayer materials. Also the performances of stacked multicolor QWIPs detectors are presented. For multicolor arrays, QWIP’s narrow band spectrum is an advantage, resulting in low spectral crosstalk. The major challenge for QWIP is developing broadband or multicolor optical coupling structures that permit efficient absorption of all required spectral bands.展开更多
In this paper,we present the general design methods and parameter measurements of a 1-k W solidstate radio frequency(RF) power amplifier at 2856 MHz,for the soft X-ray free electron laser facility.Three-stage amplific...In this paper,we present the general design methods and parameter measurements of a 1-k W solidstate radio frequency(RF) power amplifier at 2856 MHz,for the soft X-ray free electron laser facility.Three-stage amplification with a 4-way combination is used.An RF switch module is integrated with the solid-state RF power amplifier to convert the continuous wave(CW) signal into pulse signal,with adjustable pulse width.The power gain is measured at 57.7 d B at 60 d Bm output.The RF phase noise,which is measured by the low-level RF system,is\0.015 degree(RMS),while the pulse frontier jitter is\5 ns.展开更多
电源网络S参数与芯片电源模型(Chip Power Module,CPM)级联可实现电源时域噪声仿真,完成电源完整性设计签核。当下部分仿真工具在AC阻抗优化过程中导出的S参数存在低频段无法覆盖的问题,影响时域纹波仿真精度,如果重新对S参数进行提取,...电源网络S参数与芯片电源模型(Chip Power Module,CPM)级联可实现电源时域噪声仿真,完成电源完整性设计签核。当下部分仿真工具在AC阻抗优化过程中导出的S参数存在低频段无法覆盖的问题,影响时域纹波仿真精度,如果重新对S参数进行提取,又会增加仿真时间降低仿真效率。针对AC阻抗优化过程中导出的S参数无法覆盖低频段的问题,提出了一种电源网络S参数低频段拓展方法,结合电压调节模块(Voltage Regulator Module,VRM)的R-L模型,推导出低频段的S参数可以借用抽取的S参数中最低频点处的S参数实现低频段S参数的拓展。仿真和实验结果表明,通过对低频段S参数进行拓展,电源时域纹波噪声仿真的精度提升31%。同时,低频段的S参数直接借用已抽取的S参数中低频点的数值无须重复提取,在8 GB内存的配置下,仿真时间节约14%左右,提高了仿真效率。展开更多
We have observed weather clutter containing targets (ships) using an S-band radar with a frequency 3.05 GHz, a beam width 1.8°, and a pulsewidth 0.5 μs. To investigate the weather clutter amplitude statistics, w...We have observed weather clutter containing targets (ships) using an S-band radar with a frequency 3.05 GHz, a beam width 1.8°, and a pulsewidth 0.5 μs. To investigate the weather clutter amplitude statistics, we introduce the Akaike Information Criterion (AIC). We have found that the weather clutter amplitudes obey the log-normal, Weibull, and log-Weibull distributions with the shape parameters of 0.308 to 0.470, 4.42 to 4.51, and 15.91 to 16.44, respectively, for small data within the beam width of an antenna. We have proposed the log-normal/CFAR circuit modified a Cell-Averaging (CA) LOG/CFAR circuit. It is found that weather clutter is suppressed with improvement of 51.58 dB by log-normal/CFAR. As a result, we have showed that weather clutter observed by S-band radar does not obey the Rayleigh distribution and our log-normal/CFAR circuit has an effect on suppression of clutter and detection of target, while conventional LOG/CFAR circuit does not. In addition, if our circuit can be realized, we will have an advantage economically.展开更多
In this paper, we present a background and theory of the effect of Surface Acoustic Wave (SAW) Filter Module (SFM) in-band ripple on high data rate communications parameters such as the Error Vector Magnitude (EVM). I...In this paper, we present a background and theory of the effect of Surface Acoustic Wave (SAW) Filter Module (SFM) in-band ripple on high data rate communications parameters such as the Error Vector Magnitude (EVM). In addition, we present analyses and statements for the choice of unbalanced S-parameters set of the SFM over balanced S-parameters set of the SFM in measurements and Agilent’s Advance Design System (ADS) Ptolemy simulations. A test and measurement setup using Agilent’s equipment will be presented.展开更多
随着光通信技术的发展,各种现有的单模光纤已不能满足宽带光传输密集波分复用(DWDM)系统传输的要求,S C L三波段传输新型单模光纤是在1460~1625nm的波长范围内具有足够大的色散以抑制四波混频效应、交叉相位调制等非线性效应,又使色散...随着光通信技术的发展,各种现有的单模光纤已不能满足宽带光传输密集波分复用(DWDM)系统传输的要求,S C L三波段传输新型单模光纤是在1460~1625nm的波长范围内具有足够大的色散以抑制四波混频效应、交叉相位调制等非线性效应,又使色散及斜率尽可能低,从而使色散管理成本降到最低的新型单模光纤.我们设计和计算了这种新型的光纤的结构并对其性能参数进行了分析和讨论.展开更多
文摘As the infrared technology continues to advance, there is a growing demand for multispectral detectors for advanced IR systems with better target discrimination and identification. Both HgCdTe detectors and quantum well GaAs/AlGaAs photodetectors offer wavelength flexibility from medium wavelength to very long wavelength and multicolor capability in these regions. The main challenges facing all multicolor devices are more complicated device structtures, thicker and multilayer material growth, and more difficult device fabrication, especially when the array size gets larger and pixel size gets smaller. In the paper recent progress in development of two color HgCdTe photodiodes and quantum well infrared photodetectors is presented. More attention is devoted to HgCdTe detectors. The two color detector arrays are based upon an n P N (the capital letters mean the materials with larger bandgap energy) HgCdTe triple layer heterojunction design. Vertically stacking the two p n junctions permits incorporation of both detectros into a single pixel. Both sequential mode and simultaneous mode detectors are fabricated. The mode of detection is determined by the fabrication process of the multilayer materials. Also the performances of stacked multicolor QWIPs detectors are presented. For multicolor arrays, QWIP’s narrow band spectrum is an advantage, resulting in low spectral crosstalk. The major challenge for QWIP is developing broadband or multicolor optical coupling structures that permit efficient absorption of all required spectral bands.
文摘In this paper,we present the general design methods and parameter measurements of a 1-k W solidstate radio frequency(RF) power amplifier at 2856 MHz,for the soft X-ray free electron laser facility.Three-stage amplification with a 4-way combination is used.An RF switch module is integrated with the solid-state RF power amplifier to convert the continuous wave(CW) signal into pulse signal,with adjustable pulse width.The power gain is measured at 57.7 d B at 60 d Bm output.The RF phase noise,which is measured by the low-level RF system,is\0.015 degree(RMS),while the pulse frontier jitter is\5 ns.
文摘We have observed weather clutter containing targets (ships) using an S-band radar with a frequency 3.05 GHz, a beam width 1.8°, and a pulsewidth 0.5 μs. To investigate the weather clutter amplitude statistics, we introduce the Akaike Information Criterion (AIC). We have found that the weather clutter amplitudes obey the log-normal, Weibull, and log-Weibull distributions with the shape parameters of 0.308 to 0.470, 4.42 to 4.51, and 15.91 to 16.44, respectively, for small data within the beam width of an antenna. We have proposed the log-normal/CFAR circuit modified a Cell-Averaging (CA) LOG/CFAR circuit. It is found that weather clutter is suppressed with improvement of 51.58 dB by log-normal/CFAR. As a result, we have showed that weather clutter observed by S-band radar does not obey the Rayleigh distribution and our log-normal/CFAR circuit has an effect on suppression of clutter and detection of target, while conventional LOG/CFAR circuit does not. In addition, if our circuit can be realized, we will have an advantage economically.
文摘In this paper, we present a background and theory of the effect of Surface Acoustic Wave (SAW) Filter Module (SFM) in-band ripple on high data rate communications parameters such as the Error Vector Magnitude (EVM). In addition, we present analyses and statements for the choice of unbalanced S-parameters set of the SFM over balanced S-parameters set of the SFM in measurements and Agilent’s Advance Design System (ADS) Ptolemy simulations. A test and measurement setup using Agilent’s equipment will be presented.
文摘随着光通信技术的发展,各种现有的单模光纤已不能满足宽带光传输密集波分复用(DWDM)系统传输的要求,S C L三波段传输新型单模光纤是在1460~1625nm的波长范围内具有足够大的色散以抑制四波混频效应、交叉相位调制等非线性效应,又使色散及斜率尽可能低,从而使色散管理成本降到最低的新型单模光纤.我们设计和计算了这种新型的光纤的结构并对其性能参数进行了分析和讨论.