Experimental and Numerical Study on the Gas Explosion in Urban Regulator Station

Regulator station is an important part in the urban gas transmission and distribution system.Once gas explosion occurs,the real explosion process and consequences of methane gas explosion in the regulator station were not revealed systematically.In this study,a full-scale experiment was carried out to simulate the regulator station explosion process,and some numerical simulations with a commercial CFD software called FLACS were conducted to analyze the effect of ignition and vent conditions on the blast overpressure and flame propagation.The experimental results demonstrated that the peak overpressure increased as the distance from the vent increased within a certain distance.And the maximum overpressure appeared 3 m away from the door,which was about 36.6 kPa.It was found that the pressure-time rising curves obtained from the simulation are basically the same as the ones from the experiment,however,the time of reaching the peak pressure was much shorter.The numerical simulation results show that the peak overpressures show an increase trend as the ignition height decreased and the vent relief pressure increased.It indicates that the damage and peak overpressure of gas explosion could be well predicted by FLACS in different styles of regulator station.In addition,the results help us to understand the internal mechanism and development process of gas explosion better.It also offers technical support for the safety protection of the urban regulator station.

Characteristics of Leakage Pollution of Longpan Road Gas Station and Its Enlightenment

Geological penetrating radar combined with drilling and chemical analysis has been applied to investigate leakage pollution of Longpan Road gas station in Nanjing, China. The results indicate that radar images show strong reflection anomalies along the northeast to the gas station, characterized by contaminants or contaminant plumes spreading downstream and below. The drilling results confirmed the contents of monocyclic and polycyclic aromatic hydrocarbons contained in the layers of fine sands ranging from 0.60 m to 6.0 m beneath the surface mostly exceed Chinese standard severely, such as toluene and isobutylbenzene with high content at 2738 μg/kg and 64505 μg/kg, respectively. Therefore, it is considered that geological penetrating radar can be employed to investigate leakage contamination of gas stations, and remediation and administration should be conducted in the polluted soil layers and aquifers.

Assessment of BTEX Concentrations in Air Ambient of Gas Stations Using Passive Sampling and the Health Risks for Workers

Gas stations are important emissions source of benzene (C6H6), toluene (C7H8), ethylbenzene (C8H10), and ortho, meta and para-xylene (C8H10)—better known by the acronym BTEX. The objective of this study was to determine the concentrations of BTEX compounds in the ambient air of ten gas stations in the cities of Salvador and Feira de Santana, Bahia, Brazil and evaluate the health risks to workers. Passive samplers diffusive of the Radiello?, containing activated carbon as adsorbent, were used. The samplers were exposed for 8 h and then the analytes were recovered by chemical desorption with CS2 and determined by GC-FID. The BTEX concentrations found in the ambient air of gas stations ranged from 46.72 - 435.43 μg·m?3 for benzene;25.54 - 342.46 μg·m?3 for toluene, 7.10 - 30.07 μg·m?3 for ethylbenzene, 9.36 - 89.73 μg·m?3 for m, p-xylene and 9.79 - 52.29 μg·m?3 for o-xylene. The concentrations of toluene, ethylbenzene and xylenes found in gas stations were lower than the limits recommended by the US NIOSH and NR-15 of the Ministry of Labour of Brazil;however, it should be considered the risks due to chronic exposure of workers. Benzene concentrations in three gas stations were above the exposure limit recommended by NIOSH (3.20 × 102 μg·m?3). Samplings were also held outdoors at 250 m of two gas stations. The total concentrations of the BTEX compounds were equal to 24.97 and 35.51 μg·m?3, and benzene concentrations were about 3 - 4 times higher than the annual pattern of 5.0 μg·m?3 established by Union European, as tolerance limit for outside areas. These data confirm that the next areas of gas stations are subject to the effects of volatilization of these compounds. Additionally, the values found in the 10 gas stations for the cancer risk ranged from 4.06 × 10?5 - 3.78 × 10?4 (mean of 1.82 × 10?4) for workers exposed to benzene for 30 years (acceptable limit equal 1.00 × 10?6). The cancer risk is very high, because the values found are about 40 - 378 times above the acceptable limit and reinforce the need to adopt urgent measures to reduce or eliminate exposure of workers to the BTEX compounds. The average non-cancer risk to benzene, toluene, ethylbenzene and xylenes was 1.84, 5.76 × 10?3, 4.59 × 10?3 and 1.37 × 10?1, respectively (acceptable limit 1). Only to benzene the average value of this risk is above 1, showing that workers are likely the adverse effects health due to exposure to benzene.

Relationship between Symptoms, Use of PPE and Habits Related to Occupational Exposure to BTEX Compounds in Workers of Gas Stations in Bahia, Brazil

To show the risks and harm caused by the occupational exposure to the benzene, toluene, ethylbenzene and xylenes compounds (BTEX), the working conditions of 113 persons employed at gas stations in the cities of Riach?o do Jacuipe, Feira de Santana and Salvador in the state of Bahia, Brazil were investigated by experts who correlated protection measures required by law and those applied to the workers. Data collection was performed by help of a questionnaire and non-participant observation record. The age groups of the workers in the three cities surveyed were between 18 to 25 years (30.08%) and 26 to 33 years (34.51%) of the total. The study revealed an association between occupational habits of workers at gas stations and the prevalence of symptoms due to the exposure to the BTEX compounds. Regarding the use of Personal Protective Equipment (PPE) most workers wear boots. The data show that these workers reported symptoms such as headache, rhinitis, leg pain, drowsiness, cough, fatigue, insomnia, tremors and palpitations. These disorders are related back to previous exposure to BTEX compounds which is associated with inadequate occupational habits of the workers which potentiate chemical contamination in their respective environment.

Performance enhancement of water bath heater at natural gas city gate station using twisted tubes

Natural gas is transported from producing regions to consumption regions by using transmission pipelines at high pressures. At consumption regions, the pressure of natural gas is reduced in city gate stations(CGSs). Before the pressure reduction process, the temperature of natural gas is increased usually by using a water bath heater,which burns natural gas as fuel, to protect against freezing of natural gas. These types of heat exchangers have a low efficiency and consume a lot of fuel to generate the required heat. In the current study, the twisted configuration of the heating coil is proposed and investigated to enhance the heat transfer through a water bath heater with a nominal capacity of 1000 m^3·h^-1. Firstly, the implementation procedure is validated with data collected from the CGS of Qaleh-Jiq(located in Golestan province of Iran). A very good agreement is achieved between the obtained results and the real data. Then, three different twist ratios are considered to examine the twisting effects. The proposed technique is evaluated in the terms of velocity, temperature, and pressure variations, and the results are compared with the conventional case, i.e. straight configuration. It is found that both the heat transfer rate and the pressure drop augment as the twist ratio is raised. Finally, it is concluded that the twisted tubes can reduce the length of the gas coil by about 12.5% for the model with low twist ratio, 18.75% for the model with medium twist ratio, and 25% for the model with high twist ratio as compared to the straight configuration.

Two-stage robust power cost minimization in a natural gas compressor station

Optimal operation of a compressor station is important since it accounts for 25%to 50%of a company’s total operating budget.In short-term management of a compressor station,handling demand uncertainty is important yet challenging.Previous studies either require precise information about the distribution of uncertain parameters or greatly simplify the compressor model.We build a two-stage robust optimization framework of power cost minimization in a natural gas compressor station with nonidentical compressors.In the first stage,decision variables are the ON/OFF state of each compressor and discharge pressure.The worst-case cost of the second stage is incorporated in the first stage.Firststage decision variables feasibility is discussed and proper feasibility cuts are also proposed for the first stage.We employ a piece-wise approximation and propose accelerate methods.Our numerical results highlight two advantages of robust approach when managing uncertainty in practical settings:(1)the feasibility of first-stage decision can be increased by up to 45%,and(2)the worst-case cost can be reduced by up to 25%compared with stochastic programming models.Furthermore,our numerical experiments show that the designed accelerate algorithm has time improvements of 1518.9%on average(3785.9%at maximum).

Development of a ~3He Gas Filling Station at the China Spallation Neutron Source

At the China Spallation Neutron Source(CSNS), we have developed a custom gas-filling station, a glassblowing workshop, and a spin-exchange optical pumping(SEOP) system for producing high-quality ^(3)He-based neutron spin filter(NSF) cells. The gas-filling station is capable of routinely filling ^(3)He cells made from GE180 glass of various dimensions, to be used as neutron polarizers and analyzers on beamlines at the CSNS. Performance tests on cells fabricated at our gas-filling station are conducted via neutron transmission and nuclear-magneticresonance measurements, revealing nominal filling pressures, and a saturated ~3He polarization in the region of 80%, with a lifetime of approximately 240 hours. These results demonstrate our ability to produce competitive NSF cells to meet the ever-increasing research needs of the polarized neutron research community.

Design of the Pumping Stations and the Gas Puffing Systems for the Superconducting Tokamak HT-7U

The design of the pumping stations and the gas injection systems for the inner Chamber and the cryostat on HT-7U superconducting tokamak is described in this paper.

Ground Penetrating Radar Survey for the Location and Assessment of the Hydrocarbon Plumes at Gas Station Installations

The present paper describes the implementation of GPR 3D survey for detecting and delineating possible remains of hydrocarbon plumes on a gas station. The 3D-imaging was used for the detection of anomalous zones that were analyzed with some relevant signal attributes extracted by digital signal processing. These signal attributes or parameters have been the frequency of the maximum energy concentration on time-frequency distribution and instantaneous amplitude that could be related to the local response of the electromagnetic interaction and the presence of hydrocarbon plumes or soil contaminated areas. The implementation methodology took place at a gas station monitored with a piezometric sensor installation with soil layer information. The 3D-imaging of processed data and its slicing tool permits visualizing expected targets as pipes, tanks and installations in the subsoil exposing the anomalous zones for refined analyses. This further processing has used some spectral attributes of the signal to assess the real presence of the total petroleum hydrocarbons (TPH) providing a new effort to simplify and overcome the current state of the geophysical methods able to assess the presence of hydrocarbon plumes in industrial environments regarding the time cost of the survey and the traceable indication of the spectral shiftment shown in the plume volume.

Relevance of Marketing Strategies for Gas Stations in China - An Analysis Using SPSS

This study aims to find out the relevance of marketing strategies for gas stations in China.According to IBISWorld,the companies holding the largest market shares in China’s gas station industry include China Petrochemical Corporation,China National Petroleum Corporation,Sinochem Corporation,China National Offshore Oil Corporation,and BP(China)Holdings Limited.Marketing has changed over the past several years.Similarly,gas station marketing is all about more customers,greater sales,and higher profits.Technology provides many different marketing tools to see more fresh faces at the door,increase repeat sales,and improve profits.Word-of-mouth advertising should be encouraged,especially when contests are being held.The prizes from these contests may include car essentials,free coffee,free car wash,or coupons to be used at convenience stores.Customers who have won these contests would surely go around advertising the particular gas station,ultimately bringing in more customers.Other than that,managers can boost the sales volume through radio promotions as well.This study also aims to give future businessmen and women some ideas on how to deal with different kinds of strategies when it comes to marketing,especially in China in hope to cater and prove to the people of China the possibility of promoting businesses,such as the oil industry.

Natural Gas Pressure Reduction Station Self-powered by Fire Thermoelectric Generator

Pressure reduction station(PRS)is an essential facility in natural gas transmission,which owns the function of pressure reduction,demand-supply management and flow metering.However,a large number of PRSs are located in off-grid areas and powered by battery equipment resulting in high maintenance costs.So,how to realize the energy independence of these PRSs is an urgent issue to be solved.Therefore,the natural gas fired thermoelectric generation(FTEG)module,including gas flue,cover,TEGs and heat radiators,is designed for PRS in off-grid areas.Phase change material is introduced into the FTEG module to change the operation mode from continuous mode into a periodic mode,and the prototype of the FTEG module is built to discuss the generation performance in different modes.The results show that the generation efficiency of the FTEG module is improved by 63%in periodic mode compared with the continuous mode.Then,the numerical model is established to investigate the impacts of air coefficient,cold-side heat radiator and number of TEGs on the module performance.It found that the impacts of cold-side heat radiator and the number of TEGs are more significant than those of the air coefficient.After adjusting these key parameters,an optimized FTEG module with 32 TEGs is proposed,which has an average power generation of 16.4 W and a heat collection efficiency of 84.6%.Eventually,3 to 6 modules can be connected in series to meet the power requirement of 50 W to 100 W for PRS.This high-performance FTEG module can accelerate the process of achieving the energy independence of PRS and promote its application in mesoscale equipment.

浅谈智能调压站的运行优势

通过对哈尔滨市区内运行智能调压站现场调查，分析智能调压站运行的原理，及对新老调压站的对比前提下，提出了提高和完善方案。